Extreme Networks F1 Instruction Manual

Outdoor

2.4GHZ Digital R/C

More Range, Faster Response Time

with Precise Accuracy

,

Antenna

ON / OFF Power
Indicator light

Hi / Low
Speed Button

Up / Down
Hover Throttle

Power ON / OFF

Left / Right
Forward / Backward
Throttle

Fine-tuning
Turn Left / Right

Fine-tuning
Forward-Backward

LCD display

CHARGE PACK

F1 HELICOPTER

A/C ADAPTER

SPARE PARTS

Main blades

Tail blade

Screwdriver

PARTS - SERVICE - REPAIRS ... www.extremercbyrsi.com or call our MI Service Center: 586-757-1336 x 1

PARTS - SERVICE - REPAIRS ... www.extremercbyrsi.com or call our MI Service Center: 586-757-1336 x 1

Open M-F 9-6 ... Sat 10-3 (EST)

• Safety instructions

• Charging instructions

• Flying instructions

• Calibration control

• Battery installation

• Part list

• Troubleshooting

• Service department hours

• Extreme F1 helicopter

• 2.4GHz Digital remote control

• A/C adapter

• Charge pack

• Warranty card

• Instruction manual

• Spare main and tail blades

• Screwdriver

Packing listManual contents

Read the entire user’s manual before operation.

Save manual for future reference.

2.4GHz DIGITAL REMOTE CONTROL

Charge

Power

F1

2.4GHz

Single Blade ... Remote Control Helicopter

R

3-C H A NNEL GYRO SYSTEM

INDOOR / OUTDOOR

Balance bar

Co-axle

Top main blade

Bottom main blade

Tail blade

Tail motor

Plug into charge-pack

power wire

Helicopter power start connecting wires

Search light

ON / OFF

switch

Tail pipe structural supports

Head cover

Main shaft motor gear

Landing gear

1. Low battery power will shorten the controller’s effective range.

2. Low battery power will lead to difficulties in taking off and ascending.

3. Immediately repair helicopter if there is any damage. Flying a damaged helicopter could cause injuries.

4. If you will not be flying your helicopter for 30 days or more, remove all ‘AA’ batteries to prevent harmful leakage.

5. Avoid crashing or dropping the helicopter on a hard surface, as this may dangerously damage the model.

6. When preparing to fly, turn on the helicopter first using the power switch on the model’s fuselage, then turn on the
remote control.

7. When you are finished flying, turn off the remote control first, then turn off the helicopter.

8. Whenever possible, land on soft ground.

If helicopter rotates counter-clockwise...

push R/C right calibration control button right

If helicopter rotates clockwise...

push R/C right calibration control button left

If the helicopter is moving forward while hovering.

push the R/C right button calibration trim control

If the helicopter is moving backward while hovering.

push the R/C right button calibration trim control

PARTS - SERVICE - REPAIRS ... www.extremercbyrsi.com or call our MI Service Center: 586-757-1336 x 1

RIGHT / LEFT CALIBRATION TRIM CONTROL

TAIL SPEED CALIBRATION TRIM CONTROL

If the helicopter is turning excessively to the right or left, or moving forward or backward

while hovering, the instruction guide below should help you resolve the problem.