HD700 Manometer
Software Introduction
MANOMETER serial software is a program for collecting data from HD700 Manometer when it is connected to a PC or notebook computer. The data may be displayed graphically, as text or exported to Excel or similar programs. The major functions are all listed in the main window.
The maximum number of data points is 17278.
System Required:
Windows 2000 or Windows XP
Minimum Hardware Required:
PC or NoteBook with Pentium 90MHz or higher 32 MB RAM ;
At least 5 MB byte hard disk space available to install MANOMETER serial software.
Recommended display resolution 1024X768 with High Color(16 bit).
Main Menu
Save - Save the recorded real time data to the disk.
Print- Print the real time graph.
Real Time Data I Run - Start collecting real time data .
Stop - Stop collecting real time data .
Undo Zoom.
Power off-power off the manometer
Help document
Operation
Starting communication
1.Power on the manometer first and connect it to a PC USB port with the cable provided
2.Run the MANOMETER software program.
3.If the connection is successful the panel will display the same value as the manometerr
4. If the connection fails the software will display "- - - -" on the panel window .
5.If you fail to connect, check you cable first, close all other application and then choose other serial ports from the menu until the connection is successful. Wait a few second after a new com port is selected to see if the communication is successful. When successful, the com port selections will turn gray (become inactive).
Loading...