Extech Extech DA30 Manual

User’s Guide Model DA30
AC CURRENT DETECTOR
Safety Precautions
1. Improper use of this meter can cause damage, shock, injury or death. Read this guide before use.
2. Secure any covers or battery doors before use.
3. Inspect the condition of the meter for any damage before use.
4. Remove the batteries from the meter if the meter is to be stored for long periods.
International Safety Symbols
Refer to the user’s guide for information. Hazardous voltages may be present
Operation
WARNING: Risk of Electrocution. Before use, always test the Detector on a known live circuit to
NOTE: There must be a load on the circuit (current flow) for current detection.
1. Turn the On/Off-Sensitivity switch (2) clockwise to turn the unit on.
2. Set the Sensitivity adjustment (2) to the high (counterclockwise) position
3. If the detector begins to beep/flash (1), slowly reduce the sensitivity (clockwise) until the beep stops.
4. Move the detector current sensor (1) near the current carrying conductor until the tip flashes and
5. Slowly adjust the sensitivity (2) and reduce the distance
verify proper operation
beeper sounds.
between the sensor and conductor to pinpoint and identify the conductor.
Battery Replacement
1. Turn power OFF and release the end cap latch from the pocket clip and slide out the battery compartment (3).
2. Replace the four LR44 batteries and replace the battery compartment.
Specifications
Current sensitivity 200mA (0.2A) AC at 0.2” Audible/Visible indication Beeper/ Flashing LED Frequency range 50 to 500Hz Operating Temperature/Humidity 14 to 122°F (-10°C to 50°C): < 80% RH Power supply (4) LR44 batteries or equivalent Weight/ Dimensions 1.6 oz. (45g)/5.7 x 1.1 x 1” (145x28x25mm) IEC 1010 Category III 600V
99 Washington Street Melrose, MA 02176
Phone 781-665-1400 Toll Free 1-800-517-8431
Visit us at www.TestEquipmentDepot.com
Back to the Extech DA30 Product Info Page
Test Equipment Depot, 99 Washington Street, Melrose, MA 02176
781.665.1400 | 800.517.8431 | Fax: 781.665.0780
Loading...