25˚16˚ 45˚
bezel
grid
grid alignment
inserting
attaching
Choosing a Grid Angle:
The Rogue Grid was designed to produce 3 different grid angles; 25˚, 45˚, and
when aligned and stacked together, a 16˚ angle. The 25˚ and 45˚ angles are
marked on the outside curve of each honeycomb grid, describing the angle at
which light exits the grid. Smaller degree angles produce smaller spots of light.
For example, the 16˚ grid produces the smallest spot of light.
1. To insert a honeycomb grid, align the grooves on the side of the grid with the
corresponding alignment ridges on the inside of the Grid Bezel. Firmly push the
honeycomb grid into the Bezel until it comes to a complete stop.
2. To remove a grid simply push it back out of the bezel.
3. To create the 16˚ degree angle, align & stack both grids into the bezel
together. They may be stacked in any order.
Attaching the Rogue Grid to your Flash:
1. Attach the grid strap to the flash head by wrapping the bottom strap
around the flash head. To ensure a secure fit, pull the elastic band tight and
fasten the rubber tab to the velcro on the strap. The two snap positions on
the grid strap are designed to allow greater adjustability to accommodate
smaller and larger flash heads.
position
form collar
bezel alignment
tuck edges
2. Position the grid strap on the flash head so the top of the strap is even with
the face of the flash. Once the honeycomb grid is attached, this positioning
will allow for about 1” between the face of the flash and the grid.
3. Form a collar with the extended white flaps of the grid strap and attach
the ends using the hook and loop.
4. Align “Rogue Grid” on the face of the grid bezel with the black “Rogue” label
on the top of the grid strap collar.
5. Firmly push the grid into the end of the collar. Be sure to check that the
edges of the collar tuck under the outer ring of the grid all the way around.
More information can be found online at expoimaging.com
Warranty Information
Rogue Grid comes with a limited warranty to be free of defects in workmanship and
materials for a period of one (1) year from the date of original retail purchase. If the
product proves defective within the warranty period it will be replaced free of charge.
Please visit our website at www.expoimaging.com for more warranty information.
© ExpoImaging, Inc., 2011
Loading...