Exotic Flames Natural Gas Fire Pit, NORCOLD, Aquatic Glassel Installation And Operating Manual

F

IRE PIT INSTALLATION AND OPERATION GUIDE FOR

Featuring Aquatic Glassel® Tempered, Formulated Glass, ©2005 - 2007

NATURAL GAS INSTRUCTIONS

Adequate Fire Pit Ventilation is Required (if indoors)

NOTE: READ INSTRUCTIONS FULLY BEFORE INSTALLING OR OPERATING.

INSTALLERS, LEAVE THESE INSTRUCTIONS WITH THE CONSUMER!

This product must be burned only in a fully vented (if indoors), non-combustible fire pit with the
completely open (if indoors) and the chimney free of any obstructions or restrictions. The fire pit must be
designed and approved to burn wood. The minimum permanent, free opening in the fireplace chimney
must be 8 inches in diameter (50 sq. inches) or greater (for indoor installations).

IT IS THE HOMEOWNER’S RESPONSIBILITY TO ASSURE THAT

THEIR FIRE PIT HAS ADEQUATE DRAFT (for indoor installation only).

WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A

FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY

OR LOSS OF LIFE.

FOR YOUR SAFETY – IF YOU SMELL GAS

1. OPEN WINDOWS

2. DON’T TOUCH ELECTRICAL SWITCHES

3. EXTINQUISH ANY OPEN FLAMES

4. IMMEDIATELY CALL YOUR GAS SUPPLIER

FLAMMABLE VAPORS MAY BE DRAWN BY AIR CURRENTS FROM OTHER AREAS OF
YOUR HOUSE TO THIS APPLIANCE.

GENERAL INFORMATION

DO NOT USE A NATURAL GAS BURNER FOR PROPANE OR A PROPANE BURNER FOR NATURAL
GAS. WHEN USING PROPANE GAS (LPG) AN AUTOMATIC PILOT SYSTEM MUST BE INSTALLED.

1. There are many different local codes for gas fireplaces. The installation of Aquatic Glassel
glass must conform to your local codes, or in the absence of local codes, conform to the
National Fuel Gas Code (ANSI Z223.1 1999).

2. Periodically, the glass may be dusted with a soft feather duster. The top layer may also be
scooped up and taken to a water source and washed.

3. Do not burn wood with this product.

NOTE: THIS PRODUCT MUST BE INSTALLED BY PERSONNEL QUALIFIED TO INSTALL GAS

APPLIANCES, IF REQUIRED BY YOUR LOCAL CODES. EXOTIC FLAMES BEARS NO
RESPONSIBILITY FOR YOUR ACTIONS.

damper

Page 1 of 3

Step 1

Clean out your fire pit (Figure 1).
Remove old burner (unless it can be
re-used).
Attach your new burner with the flex
line provided. Hint – unscrew the fitting
on each end of the flex line. Screw the
fittings to the burner and gas line first.
Then screw the flex line to each fitting.
Position the burner to the center and 2
to 3 inches below the rim of the pit by
gently bending the flex line.

Step 2

Now pour in the crushed lava rock
(Figure 2) while holding the burner in
position.
Pour in just enough lava rock to create
a flat surface about an inch below the
burner.
Then switch to finely crushed lava rock
(pea size), filling until the lava rock is
flush with the top of the burner. Also
See Figure 4.

Figure 1

Figure 2

Page 2 of 3