SKU RC-01
Programming Instructions
Before you program your ExcelTek remote please be advised of the followings:
• More than 1 garage door to program
Be sure to know which garage door you’re planning programming on which button
before you start because once programmed you won’t be able to change it unless
you erase all frequencies previously programmed with your garage door opener.
For example, you have the ExcelTek remote button A programmed with garage door
#1 and button B programmed with garage door #2 and you changed your mind. You
now want to do the opposite. When you’re gonna have the garage door #2
programmed on button A or garage door #1 programmed on button B both garage
doors A and B will open at the same time.
• Up to 3 frequencies can be programmed
For model RC-01, button C and D are linked together making the remote three
buttons.
Programming Instructions
1. Locate the Learn button
2. Press and immediately release the learn button. The learn LED will glow
steadily for 30 seconds. Within 30 seconds…
3. Press and hold the button on the remote control that you wish to use.
Release the button when the garage door opener lights blink or two clicks are
heard. If programming to other products, press the button a second time to
activate the product.
Troubleshooting Guide
❖ My remote is not synchronizing with my garage door opener.
o Please locate the learn button or antenna on your garage door opener
and make sure it is PURPLE in color. If it’s a different color the ExcelTek
remote model RC-01 is not suitable for your device and you will have
to return it since you ordered the wrong item. Please check out our
listings for remotes compatible with other learn buttons colors.
Troubleshooting Guide
❖ My remote is not synchronizing with my garage door opener.
o Please check the voltage of your remote battery because it might be
low. We try to do our best to provide top quality products, but
sometimes low voltage batteries slip through our quality controls. If
you received a defective battery, please contact immediately so we
can solve the problem in a timely manner.
o Your garage door opener memory has reach maximum capacity. You
will have to erase all previous codes by resetting your device. To reset
your device simply hold down the learn button until the LED light goes
out (approximately 8-10 seconds).
PLEASE NOTE THAT YOU WILL HAVE TO REPROGRAM EACH REMOTE
CONTROL, KEYPADS AND HOMELINK YOU WISH TO USE ONE BY ONE
AFTER RESETTING YOUR DEVICE.
❖ Signal range is very weak.
o Please make sure your garage door opener antenna’s is correctly
hanging under it for optimal reception. If you’re still experiencing bad
reception, please reach out to us so we can assist you.
HOW TO REPLACE THE BATTERY
❖ You will need a micro 50mm Philips screwdriver to remove the back panel.
Battery type is 27A 12V
(Available on Amazon)
IMPORTANT
❖ Please note button C and D are linked together.
❖ Dip switches are NOT compatible with model RC-01.
❖ If you have any concerns while programming our ExcelTek remote feel free
to contact us to get assistance. If you feel unhappy about our products in any
way, please give us a chance to make it right! Contact us immediately before
doing anything and we will do whatever it takes to make you happy!
Loading...