The information contained herein is the property of Excell Precision Limited
and is supplied without liability for errors or omissions. No part may be
reproduced or used except as authorised by contract or other written
permission. The copyright and the foregoing restriction on reproduction
and use extend to all media in which the information may be embodied.
Dolphin 9903 V 1.1 SME300000041
TABLE OF CONTENTS
INSTRUCTION FOR USE............................................................................................................2
PREPARING TO USE THE SCALE.............................................................................................2
CHAPTER 1 FEATURES AND SPACIFICATIONS......................................................................3
Thank you for purchasing the 9903 Dolphin II weighing scale of Excell. To enable you to use this
scale correctly, we suggest that you read the following instructions carefully.
1. Don’t bump the scale against other items nor load it with heavy weight exceeding its full
capacity.
2. Keep it away from high temperature.
3. If the scale is not going to be used for a certain period of time, clean it and store it in a
polythene bag. A desiccant may be included.
4. If the scale is not used for a long period of time, recharge it every 3 months so as to ensure a
long life of the battery. Fully recharge it before using again. Take care not to keep the scale
being charged for too long.
5. Commodities should be placed at the center of the platter when being weighed, and can’t
EXCELL PRECISION CO., LTD.
exceed the dimension of the platter.
PREPARING TO USE THE SCALE
1. Please locate the scale on a stable, level surface to ensure accurate weight readings.
2. Adjust the four leveling feet to make the balance horizontal. Make sure that the level bubble is
in the center of the circle.
3. Keep the scale away from places with strong drafts or excessive temperature fluctuations (e.g.
direct sunlight or the air louver of an air conditioner).
4. There should be no weight on the scale when the scale is switched on.
5. Once the scale is switched on, it will go through a LCD display test and then re-zero to be
ready for use.
6. Please warm up the scale for 15~20 minutes before operation.
7. Please note when the symbol flashes on the screen, the battery needs to be
recharged.
Dolphin 9903 V 1.1 SME300000041
2
CHAPTER 1 FEATURES AND SPACIFICATIONS
1. Features
2 IP65 Wash down design
2 Auto calibration
2 Large LCD display with LED backlight included
2 Kilogram (kg) and pound (lb) weighing modes
2 Full range tare; Auto zero tracking
2 Adjustable gravity value
2 Simple counting; Gross/Net indication; Hold function; Check mode Lo/Hi/OK
2 Low power indication and auto power off
2 Easily adjusted leveling feet for stability of the scale
EXCELL PRECISION CO., LTD.
2. Options
2 Second display (customer side)
2 DC 6V/1.2 AH Rechargeable battery
2 Stainless steel platter (220 x 190 mm)
3. Specifications
Model Capacity Division
9903-3 3 kg (6 lb ) 1 g (0.002 lb)
9903-6 6 kg (12 lb) 2 g (0.005 lb)
9903-15 15 kg (30 lb) 5 g (0.01 lb)
9903-30 30 kg (60 lb) 10 g (0.02 lb)
Operating Temperature: 0°C ~ 40°C (32°F ~ 104°F)
Power Source: AC 110V/230V (±10%) or 4 x UM-1 1.5V dry batteries (not included)
Dimensions: 242 x 130 x 285 mm ( W x H x D )
Platter Size: 218 x 188 mm (Plastic platter); 220 x 190 mm (Steel platter)
Display: LCD, 6 Digits. 25 mm (Height), LED backlight
Dolphin 9903 V 1.1 SME300000041
3
4. Power Supply
Power Source: AC 110V/230V (±10%) adaptor;
4 x UM-1 1.5V dry batteries; or
6V / 1.2Ah rechargeable battery
Power Consumption:
With backlight: about DC 14 mA; battery life about 85 hours
Without backlight: about DC 24 mA; battery life about 50 hours
Low Battery Indication: When the symbol flashes, the battery needs to be
recharged or the dry battery needs to be replaced.
4The scale will power off automatically after 1 to 2 hours if the battery is not charged.
EXCELL PRECISION CO., LTD.
Please fully recharge the battery before using the scale again.
Dolphin 9903 V 1.1 SME300000041
4
2 3 4 5 6 7
EXCELL PRECISION CO., LTD.
CHAPTER 2 DISPLAY
1
HI : When this indicator is on, the weight value is larger than the preset high limit.
OK : When this indicator is on, the weight value is between the low and high limits.
LO : When this indicator is on, the weight value is less than the preset low limit.
kg : Indicating that the current weighing unit is “kg”.
lb : Indicating that the current weighing unit is “lb”.
Pcs : Indicating that the scale is in the simple counting mode.
à0ß : “ZERO” indicator and platform stable confirmation.
Net: When this indicator is on, the scale is in the tare mode, and the net weight is displayed.
: “Low Battery” indicator
61 : (STABLE) “stable” indicator
62 : (GROSS) When this indicator is on, the scale is in the tare mode, and the gross weight
is displayed.
63 : ( ) In the counting mode, when this indicator is on, the unit weight of the sample
is too small.
64 : () In the counting mode, when this indicator is on, the total weight of the sample