
Master Light 
Toolbox 
User’s Guide
www.ExcaliburElectronics.com
H638S-WC-CS (MA) Master Light Toolbox 071707.indd  1H638S-WC-CS (MA) Master Light Toolbox 071707.indd  1 7/17/07  6:14:02 PM7/17/07  6:14:02 PM
Model No.:H638S-WC-CS
 

ongratulations on your 
C
purchase of The Weather 
Channel® Master Light Toolbox 
from Excalibur Electronics. 
It combines a bright LED 
fl ashlight with a utility toolbox. 
It also features a powerful 
mounting magnet, and with the 
EZ Crank, the batteries never 
need replaced! 
The Weather Channel® Master 
Light Toolbox is easy to use. Be 
sure to keep this User’s Manual 
for your reference 
Socket set
Closing clasp
Screwdriver 
heads
Hexagonal 
connector
Winding port
Your set includes :
9 Screwdriver heads 
4 Precision screwdrivers 
8 Socket heads 
1 Hexagonal connector 
1 EZ Crank handle and multitool 
1 Tool extension 
1 Toolbox
Features
• Flashlight with alert
• No batteries needed
• Adjustable brightness
• 25-piece toolkit with box
• Powerful mounting magnet
LED lamp 
with alert
Lamp release 
 (both sides)
Flashlight power 
button (on door)
Precision 
screwdrivers
Tool extension 
(behind screwdrivers)
Mounting magnet
EZ Crank handle 
and multitool
Charging the Flashlight
Make sure that the Master 
Light is off before charging. 
Insert the EZ Crank handle 
into the Winding port located 
at the base of the Master Light 
Toolbox. Rotate the EZ Crank 
handle clockwise for three 
minutes to fully charge. After 
a full charge you will have 
approximately 180 minutes 
of bright light on the “Low” 
setting, or 60 minutes on 
“High”. 
Note: Battery life may vary. 
Operating the Flashlight
Push the Power Button on the 
door to turn the fl ashlight on. 
To increase the brightness of 
the fl ashlight, push the power 
again. Press this button a third 
time to activate the fl ashing 
alert light. Press it one more 
time to turn the fl ashlight off. 
The Weather Channel® Master 
Light Toolbox features a 
pivoting lamp head. To use 
this feature, press the Lamp 
release buttons on either side 
of the LED lamp in, and pull 
up on the lamp head. With the 
lamp head fully extended, you 
can pivot the light 180 degrees.
Using the Mounting Magnet
The Mounting magnet at the 
bottom of the unit can be 
used to attach the toolbox to 
almost any metal surface for 
convenient use.
Using the Multitool
The EZ Crank handle doubles 
as a multitool that connects to 
your sockets and screwdriver 
heads. Insert the screwdrivier 
heads directly into the end 
of the multitool. To use the 
sockets, insert the hexagonal 
connecter into the end of the 
multitool, then connect your 
socket. Use the Tool extension 
with sockets and screwdriver 
heads to make work easier!
Safety and Care
• Avoid rough handling such  
 as bumping or dropping. 
• Clean using only a slightly  
 damp cloth. 
• Do not submerge the lantern  
 in water or other liquids. 
• For best results, use   
 between 39º F and 100º F  
 (4º C - 38º C). 
• LED bulbs are not replace-  
 able. Do not attempt to open  
 light housing. Doing so could  
 damage the unit. 
 • Do not look directly into the  
 light. This may damage eyes.
H638S-WC-CS (MA) Master Light Toolbox 071707.indd  2-3H638S-WC-CS (MA) Master Light Toolbox 071707.indd  2-3 7/17/07  6:14:05 PM7/17/07  6:14:05 PM
 

90-DAY LIMITED WARRANTY
   EXCALIBUR ELECTRONICS, INC., warrants to the original consumer that its products 
are free from any electrical or mechanical defects for a period of 90 DAYS from the date 
of purchase. If any such defect is discovered within the warranty period, EXCALIBUR 
ELECTRONICS, INC., will repair or replace the unit free of charge upon receipt of the 
unit, shipped postage prepaid and insured to the factory address below.
   The warranty covers normal consumer use and does not cover damage that occurs 
in shipment or failure that results from alterations, accident, misuse, abuse, neglect, 
wear and tear, inadequate maintenance, commercial use, or unreasonable use of the 
unit. This warranty does not cover cost of repairs made or attempted outside of the 
factory.
   Any applicable implied warranties, including warranties of merchantability and 
fi tness, are hereby limited to 90 DAYS from the date of purchase. Consequential 
or incidental damages resulting from a breach of any applicable express or implied 
warranties are hereby excluded. Some states do not allow limitations on the duration of 
LIMITED 90-DAY WARRANTY implied warranties and do not allow exclusion of incidental 
or consequential damages, so the above limitations and exclusions in these instances 
may not apply. The only authorized service center in the United States is:
Excalibur Electronics, Inc.
13755 SW 119th Ave
Miami, Florida 33186 U.S.A.
Phone: 305.477.8080
Fax: 305.477.9516
   Ship the unit carefully packed, preferably in the original carton, and send it prepaid, 
and adequately insured. Include a letter, detailing the complaint and including your 
daytime telephone number, inside the shipping carton. If your warranty has expired and 
you want an estimated fee for service, write to the above address, specifying the model 
and the problem.
NOTE: Please do not send your unit without fi rst receiving an estimate for servicing 
from EXCALIBUR ELECTRONICS, INC. Contact us before sending your unit. We cannot 
store your unit!
Excalibur Electronics, Inc. reserves the right to make technical changes 
www.ExcaliburElectronics.com
without notice in the interest of progress.
Excalibur Electronics, Inc. 
13755 SW 119th Avenue 
Miami, Florida 33186
Phone: 305.477.8080
Fax: 305.477.9516
Please Visit Us At: 
www.ExcaliburElectronics.com
H638S-WC-CS Master Light 071707
H638S-WC-CS (MA) Master Light Toolbox 071707.indd  4H638S-WC-CS (MA) Master Light Toolbox 071707.indd  4 7/17/07  6:14:05 PM7/17/07  6:14:05 PM