Instruction Manual
Discover the complete line of Excalibur brand professional products at
www.drying123.com
TABLE OF CONTENTS
Blender Safety
Specifications 5
Important Safeguards 6
Blending Operation 7
Cleaning Instructions
Control Panel 9
Cautions & Safeguards 10
Maintanace
4
8
11
BLENDER SAFETY
DANGER Electricity GENERAL Caution
DANGER Risk of Electrical Schock DANGER Keep Hands Clear
DANGER You can be seriously injured IMPORTANT
if you do not follow these instructions to all safety guidelines in this
manual
Please adhere
WARNING WARNING
Electrical Shock Hazard Moving Parts!
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire or electrical shock.
FAILURE TO ADHERE TO THESE WARNINGS CAN RESULT IN FIRE,
SERIOUS INJURY, ELECTRICAL SHOCK AND/OR DEATH.
Always cover the lid on the container when
blending.
Do not put hands. spoons or other utensils in
container when blending.
Failure to fol low these instructions can result
in broken bones, cuts or other injuries.
For Warranty Assistance:
For assistance or replacement parts,
Call Technical Service
24 Hours a Day, 7 Days a Week
Toll Free: #1-877-368-2797
4
SPECIFICATIONS
EXB4300
Shipping Dimensions:
17.5" W x 10" D x 13.75" H
440mm W x 250mm D x 350mm H
Shipping Weight:
15 lb
6.8 kg
EXB4300L
Power Requirements:
Volts: 120 VAC
Amps: 11.5 Amp
Hz: 50-60
Container:
64 Oz. / 1800ml (EXB4300)
82 Oz. / 2300ml (EXB4300L)
5
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should
always be followed, including the following:
1. Read all the instructions before using the blender.
2. Plug into a grounded outlet.
3. Do not remove the ground pin on your power cord.
4. Do not use an adapter.
5. Do not use an extension cord.
6. To protect against risk of electrical shock, do not put the blender in water or other liquid.
7. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure they do not play with the appliance.
8. Unplug from outlet when not in use, before putting on or taking off parts, and before cleaning.
9. Avoid contact with moving parts, especially blades.
10. Do not operate any appliance with a damaged cord or plug or after the appliance
malfunctions, or is dropped or damaged in any manner. Return appliance to the nearest
authorized service facility for examination/repair/electrical or mechanical adjustment, or
contact your distributor.
11. Caution: Keep hands and utensils out of container while blending to reduce the risk of
severe injury to persons or damage to the blender. If scraping, folding, etc. If necessary, turn
off and unplug the blender, and use a rubber spatula only.
12. Warning; Blades are sharp. Handle carefully.
13. To reduce personal injury, never place cutting blades on base without jar properly attached.
14. Screw on locking ring firmly. Injury can result if moving blades accidentally become
exposed.
15. Always operate blender with lid in place.
16. WARNIING: When blending hot liquids, place a hand towel over the cover. Do not fill blender
container beyond 2/3 full. Always begin processing at the lowest speed setting. Keep hands,
arms and face away from the feeder cup opening to prevent possible burns.
17. Do not use outdoors.
18. Do not let cord hang over edge of table or counter, or touch hot surfaces.
19. Do not leave blender unattended while it is operating.
20. The use of attachments not approved by Excalibur may cause injuries.
21. The capacity may be substantially less than normal with thick mixtures. Do not overfill.
22. Inspect the container assembly daily. Do not use a broken, chipped or cracked container.
Check cutter for wear, nicks or broken blades.
23. This appliance is intended for short period of operation, with an average rated operating time
of approximately 3 minutes.
6
BLENDER OPERATION
To operate the blender, proceed as follows:
1. For the first time user, wash the container assembly, including the lid, before using it.
(Refer to "Cleaning Instructions") Do not put the container assembly & blender base
assembly in the dishwasher.
2. Place the blender on a dry, clean, level surface,
3. Place the container onto the motor base. Make sure it rests securely on the base.
4. Plug the blender into an electric outlet.
S. Place the ingredients into the container.
4. Place the lid and feeder cap tightly on the container.
7. Set desired speed by switching the knob to Low or High.
8. The pulse feature can also be used by pressing the pulse switch.
and be sure it is set to off.
BLENDING TIPS
1. Processing hot liquids
● Always cover the lid and feeder cap before blending hot liquid or mixture.
● Use the feeder cap to add liquids to the container while the unit is running.
● Never stand with your face directly over the container when you are putting
ingredients through the feeder cap.
2. Blending icy mixtures
● Steps for blending ice:
1. Pour in liquid, and then add ice.
2. Place the lid on the container.
3. Chunks of frozen fruit can be added to milk or fruit juice to produce a sherbert
or slush.
4. Use the feeder cap to add liquids or ingredients to the container while the unit
is running.
7
CLEANING INSTRUCTIONS
The Ecalibur blender container parts are corrosion resistant, sanitary
and easily cleaned. Do not put the container assembly or blender base
assembly in the dishwasher.
1. Before first use and after every use, separate container parts from the base.
2. To clean the container: Use a washing solution of tepid water (less than 115°F/46°C)
and a non-sudsing detergent. Use the recommended amount of detergent.
3. Scrub and flush out the container interior lid and feeder cap to remove food residue.
Empty container.
4. Fill container 1/4 full with fresh washing solution and place it on the base.
5. Replace the lid and feeder cap on the container and run the blender on high speed
for 2 minutes.
6. Repeat step 4 using clean rinse water (95°F/35°C).
7. Wipe down the outside of container, feeder cap, and lid with a soft cloth or sponge,
dampened with fresh washing solution.
8. Wipe the exterior of the base with a damp cloth or sponge. The base contains
electrical components: do not immerse. use a high-pressure washer, or use a
dishwasher to clean the base.
BLENDER CARE
For best results:
1. Periodically check all parts before reassembly. Use of damaged or non-recommended
parts could result in severe personal injury and/or damage to the blender.
2. Blades:
If the processing blades are stuck or difficult to turn. DO NOT USE BLENDER.
Remove container from the base. Check by carefully turning the blades in a counter clockwise direction, where the opposite edges are sharp. Blades should turn freely.
3. Container:
If the EASTMAN TRITAN™ container is cracked, DO NOT USE BLENDER, further
use could result in the container breakage during use.
4. Blender Base:
Never immerse the blender base in water. To clean, unplug base and use a damp
cloth.
5. Motor:
The motor is permanently lubricated and does not require any additional lubrication.
8
CONTROL PANEL
EXB4300
EXB4300L
ContainerModel
64 Oz. / 1800ml
82 Oz. / 2300ml
Off/Low/High Knob
Off/Low/High Knob
Controls
Pulse Switch
Pulse Switch
Blade Agitator Assembly
Use caution when handling the blade; it is sharp. Use a soft cloth to grab
the blade when inserting the blade assembly through the container.
Retainer Nut and Blade Removal
• The retainer nut is easily removed using the disassembling tool (DT).
Turn container upside down and insert the disassembling tool on the
holes of the nut. Push the tool counterclockwise to loosen nut (Step 1).
Once loosened, remove by hand.(Disasembly tool sold separately)
• To release the blade use the other end of the DT while grabbing the
gear with backup pliers and turn counterclockwise (Step 2)
Care and Cleaning
Motor Base
1. Unplug the power cord.
2. Wipe outside surface with a damp soft cloth or sponge, which has
been rinsed in a mild solution of liquid dish soap and warm water. NEVER
IMMERSE MOTOR BASE IN WATER OR OTHER LIQUID.
3. Wipe dry with a clean, soft cloth.
Control Panel
Gently wash the front panel with a soft cloth and low pH balance soap.
NOTE: Be sure to wring excess water out of cloth or sponge when cleaning
around the controls, drive socket or any electrical part.
9
CAUTION & SAFEGUARDS
1. To protect against risk of electrical shock, do not put motor base in
water or other liquid.
2. Unplug the power cord from the wall outlet when the unit is not
in use, before putting on or taking off parts, and before cleaning other
than washing the container.
3. Never contact moving parts.
4. Do not use outdoors.
5. Do not let the power cord hang over edge of table or counter, or
touch hot surfaces.
6. Keep hands and utensils out of the container while the motor
is running to prevent the possibility of severe personal injury and/or
damage to the unit. A rubber scraper may be used, but only when the
unit is not running.
7. The blade is very sharp and requires carefull handling. Never try to
remove blade while container is sitting on the motor base. Do not operate
with loose or damaged blades. To reduce the risk of personal injury,
never place blade assembly on motor base without blender container
properly attached.
8. Always operate with the lid in place.
9. NEVER bang the container against a surface to loosen the ingredients.
Remove the container from the base and use a rubber spatula to
remove thick mixtures from the bottom of your container.
10. NEVER shake or rattle a container in use while seated on
the motor base.
11. NEVER remove the container before the machine has come to a
complete stop.
12. NEVER start the motor before the container is in place.
13. Keep children away when the blender is in use.
On most models, the power cord comes equipped with a three-prong
(grounding) plug which mates with a standard three-prong wall outlet
(Figure A). Please use approved 2 prong adapters(Figure B) when a
ground is not available. Do not cut or remove the round grounding prong
from the power cord.
10
TROUBLESHOOTING
Problem
1. Blender fails to start
2. Stopped
3. Ingredients do not mix properly
MAINTENANCE
Solution
1. Place container properly on the base.
2. Check to ensure controls are clean
and moving freely.
3. Double-check to ensure power cord is
securely plugged into the electric outlet.
4. Check to see if the circuit breaker has
tripped or if the fuse for the electric
outlet has blown.
1. Unplug blender and wait 5 minutes.
2. Plug the blender back in and resume
operation.
1. Container is too full.
2. Cutter unit blades are not sharp
enough or are damaged.
3. Solid pieces are bigger than 1"
(25mm) cubes.
4. Check the speed to create a fluid
blend.
5. Check to see if enough liquid has
been added to the ingredients. Mixture
should be fluid and free-running at all
times.
Inspect the blender and its various parts and replace as follows:
1. Unplug the blender and remove the
container from the base.
Daily
Weekly
Quarterly
2. Inspect the container blades for wear,
nicks, and broken or loose blades.
Replace if necessary.
1. Unplug the blender.
2. Inspect the power cord insulation and
power plug for cracks. Refer to
"Technical Service" for repair or
replacement.
1. Review the condition of the container
assembly and Mushroom Clutch Set at
least every 90 days.
2. Replace if necessary.
Replacement Parts
For replacement parts, call toll free: # 1-877-368-2797
11
RECIPES
Mango Flaxseed Smoothie
1/2 cup Peeled, Cored, Diced Mango
1/4 cup Almond Milk
1/4 cup Greek Yogurt
2 tbsp Mango Juice
1 tbsp Flaxseeds
1/2 cup Ice
Blend all ingredients.
Orange Healthy Creamsicle
1 Orange,
1/4 cup Fat Free Yogurt
1 Juiced Orange
1/4 teaspoon Vanilla Extract
Ice
Blend all ingredients.
peeled
12
RECIPES
Pesto Vegan Style
2 cups Basil Leaves
1/3 cup Extra Virgin Olive Oil
1/2 cup Pecans
Salt and black pepper to taste
2 cloves Garlic
Simply blend to your desired consistency. Store in a container in
a refrigerator. Serve over pasta.
Feta & Red Pepper Dip
4 Red Bell Peppers
1/4 cup Extra Virgin Olive Oil
2 Garlic Cloves,
2 cups Crumbled Feta Cheese
Peel, seed, and quarter peppers. We recommend grilling peppers. Puree
peppers, oil, garlic, and cheese blender. Season with salt and pepper.
Chill at least 3 hours or overnight. Eat with bread or crackers.
peeled
13
Excalibur
6083 Power Inn Road, CA 95824
1.877.368.2797 • www.drying123.com
Find us on Facebook
www.facebook.com/ExcaliburDehydrators
Loading...