US Army™ Hydro Terra
Amphibious
Remote Control Vehicle
User Guide
US1239 © 2012 EB Excalibur, Inc.
2
C
ongratulations on your new purchase! This US ArmyTM Hydro Terra is a
rugged, powerful remote control vehicle that is capable of taking on any
terrain, including water!
We recommend reading through this manual thoroughly before attempting
nd driving control tips, safety
precautions and care instructions to keep your vehicle in tip-top shape. Follow
the instructions, and drive your US Army
TM
eld of action!
VEHICLE LAYOUT
1. Battery Door Latch
2. Battery Door
3. ON/OFF Switch
4. Battery Compartment
5. LED Light
CONTROLLER LAYOUT
A. Antenna
B. Battery Door
C. Driving Controls (Left Joystick)
D. Driving Controls (Right Joystick)
E. ON/OFF Switch
F. Indicator Light
1
2
3
4
5
5
A
B
C DE
F
3
BATTERY INSTALLATION
Vehicle
Requires 4 AA Alkaline Batteries (not included)
1. There is a screw in the center of
the battery latch. Loosen the
screw with a phillips head
screw driver.
2. While holding the battery
compartment lid, pull up on
the latch and turn it either
counter clockwise or clockwise
so that the battery compartment
lid can be removed.
3. Insert 4 AA batteries, making sure to follow the battery
polarity (+ and -) indicators on product.
4. Replace the battery cover.
5. Turn the Power Switch to the ON position and the
ash.
Controller
Requires one 9v Battery (included)
1. Remove the battery cover as shown.
2. Insert one 9V battery, making sure
to match the polarity (+ and -) as
shown inside the battery
compartment.
3. Replace the battery cover.
4. Turn the transmitter ON.
The red indicator light on the
controller will turn on.
OPERATING ON LAND
Activate the vehicle by turning the ON/OFF button located in the rear of the
vehicle to the ON position. If done correctly, the LED lights on the vehicle
ash. Activate the remote control by turning the ON/OFF button
located in the center of the remote to the ON position. If done correctly, the
red Indicator Light on the remote will turn on.
• FORWARD - Move both joysticks on the remote up at the same time to
move the vehicle forward.
• BACKWARD - Move both joysticks on the remote down at the same time
to move the vehicle backward.
Pushing one joystick forward while pushing the other joystick backwards will
make the vehicle execute 360 degree spins. The left and right joysticks on the
remote control the left and right wheels of the vehicle.
4
TURN LEFT TURN RIGHT
DRAWKCABDRAWROF
5
CRAZY SPINS
Quickly push the two joysticks forward or backward, then push them in the
opposite direction. At certain speeds, you can make the vehicle stand up
on its rear wheels. Push one joystick forward and the other backward at the
same time will make your vehicle go into a fast 360 degree stunt spin!
6
OPERATING ON WATER
Activate the vehicle by turning the ON/OFF button located in the rear of the
vehicle to the ON position. If done correctly, the LED lights on the vehicle will
ash. Make sure the battery compartment on the vehicle is covered
and in the correct position. Activate the remote control by turning the ON/
OFF button located in the center of the remote to the ON position. If done
correctly, the red Indicator Light on the remote will turn on.
move the vehicle forward.
to move the vehicle backward.
The left and right joysticks control the left and right wheels of the vehicle.
TURN LEFT
TURN RIGHT
7
IMPORTANT NOTES
to ensure that the
allow product to cool
for 5-10 minutes and then resume play. Do not modify this product. If
product still does not turn on, replace the batteries.
2. Your vehicle may lose performance or functionality when the battery
power is low. If you experience a loss of performance, it is time for new
batteries. Your vehicle’s running time may change depending on your
driving style.
ect your vehicle’s performance. Interference can
be caused by other R/C vehicles running on the same frequency,
electrical wires, large buildings, or CB radios. Try to stay away from
potential sources of interference.
4. Point your transmitter antenna up - not down toward the vehicle. If your
vehicle gets too far away it will not work properly. If your transmitter has
an antenna loop feature, make sure the antenna is removed from the
holder and straightened before operating.
CARE & HANDLING
• Do not submerge in water for long periods of time.
• Do not submerge in other liquids.
• Do not disassemble the product for any reason.
• Do not expose to extreme temperatures.
• Do not drop, throw, smash or otherwise cause physical shock.
• Clean using only a slightly damp cloth.
• Do not use cleaners with chemical agents.
• Do not short-circuit the battery terminals.
• Do not use rechargeable batteries.
• Make sure the battery door screw is tightened before use or water will
penetrate the battery compartment.
CAUTION – Battery Safety Information
• Non-rechargeable batteries are not to be recharged
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries
• Exhausted batteries are to be removed
• Do not mix old and new batteries
re; batteries may explode or leak
• If this product will not be used for an extended period of time, remove the batteries from the product
• The supply terminals are not to be short-circuited
• Batteries are to be inserted with correct polarity
• Clean the battery contacts and also those of the product prior to battery installation
• As always, dispose of batteries in an eco-friendly manner
FCC PART 15 COMPLIANCE
The device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
cations not expressly approved by the party responsible for compliance could
void the user’s authority to operate the product.
2. NOTE: This product has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This product generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If the product does cause harmful interference to radio or television reception, which can be determined by
and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the product and receiver.
erent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
cial license of the U. S. Army.
cial Licensed Product of the U.S. Army
By federal law, licensing fees paid to the U.S. Army for use of its trademarks provide support to the
Army Trademark Licensing Program, and net licensing revenue is devoted to U.S. Army Morale,
Welfare, and Recreation programs.
EB Excalibur, Inc.
Miami, Florida
www.EBExcalibur.com
service@ebexcalibur.com
Distributed in the United Kingdom by:
EB Brands UK, Worcester WR4 9FA
er slightly from photography.
US1239IS01EXC
WARNING
Aquatic Toy
Use only under
supervision
Ages 8+
Loading...