EXCALIBUR 182 User Manual

WARNING:

To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.

CAUTION:

Use of any controls, adjustments or procedures other than those specified within this
manual, may result in hazardous radiation exposure.

Caution and rating label is located on the product.

CAUTION - TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL.

CAUTION - DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED.
REPLACE ONLY WITH THE SAME OR EQUIVALENT T YPE.

CAUTION - TO REDUCE THE RISK OF FIRE, DO NOT PLACE ANY HEATING OR
COOKING APPARATUS BENEATH THIS UNIT.

The lightning flash with arrowhead symbol, within an equilateral
triangle, is intended to alert the user to the presence of
uninsulated “dangerous voltage” within the product’s enclosure
that may be of sufficient magnitude to constitute a risk of electric
shock to persons.

The exclamation point within an equilateral triangle is intended
to alert the user to the presence of important operating and
maintenance (sevicing) instructions in the literature
accompanying the appliance.

The house with an arrowhead symbol is intended to alert the user
to use the transformer in normal indoor temperatures, not
extreme temperatures.

Battery Information

• The SOUNDMASTER Cube uses four (4) AAA batteries (not included).

• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.

• Do not mix old and new batteries.

• Do not use rechargeable batteries.

• Remove exhausted batteries from the unit to avoid battery leakage.

• Do not short-circuit battery terminals.

• Remove batteries and store them in a cool, dry place when not in use.

• To avoid explosion or leakage, do not dispose of batteries in a fire or attempt to recharge
alkaline or other non-rechargeable batteries.

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable l interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Limited 90-Day Warranty

EXCALIBUR ELECTRONICS, INC., warrants to the original consumer that its products are free
from any electrical or mechanical defects for a period of 90 DAYS from the date of purchase. If
any such defect is discovered within the warranty period, EXCALIBUR ELECTRONICS, INC., will
repair or replace the unit free of charge upon receipt of the unit, shipped postage prepaid and
insured to the factory address below. The warranty covers normal consumer use and does not
cover damage that occurs in shipment or failure that results from alterations, accident, misuse,
abuse, neglect, wear and tear, inadequate maintenance, commercial use, or unreasonable use
of the unit. Removal of the top panel voids all warranties. This warranty does not cover cost of
repairs made or attempted outside of the factory. Any applicable implied warranties, including
warranties of merchantability and fitness, are hereby limited to 90 DAYS from the date of
purchase. Consequential or incidental damages resulting from a breach of any applicable
express or implied warranties are hereby excluded. Some states do not allow limitations on the
duration of implied warranties and do not allow exclusion of incidental or consequential
damages, so the above limitations and exclusions in these instances may not apply. The only
authorized service center in the United States is:

Excalibur Electronics, Inc.

13755 SW 119th Ave.

Miami, FL 33186 U.S.A.

Ship the unit carefully packed, preferably in the original carton, and send it prepaid, and
adequately insured. Include a letter detailing the complaint, along with your daytime
telephone number, inside the shipping car ton. If your warranty has expired and you want an
estimated fee for service, write to the above address, specifying the model and the problem.

PLEASE DO NOT SEND YOUR UNIT WITHOUT RECEIVING AN ESTIMATE FOR SERVICING.
WE CANNOT STORE YOUR UNIT!

Excalibur Electronics, Inc.
13755 SW 119th Avenue • Miami, FL 33186
Tel: [phone] • Fax: [phone] • www.ExcaliburElectronics.com

SOUNDMASTER is a trademark of Excalibur Electronics, Inc.
iPod is a trademark of Apple, Inc., registered in the U.S. and other countries.
Actual product may differ slightly from photograph.

Model 182

CUBE

PORTABLE SPEAKERS FOR iPod

®

SOUNDMASTER™ CUBE

OPERATION MANUAL

Introduction

Congratulations on your purchase of the SOUNDMASTER™ Cube from
Excalibur Electronics, Inc. You and your friends will enjoy hours of great
music with this innovative speaker set. It produces hi-fi quality sound and is
compatible with iPod, MiniDISC players, MP3 players and portable media
players. This package includes one SOUNDMASTER Cube, an *AC adapter, a

3.5mm stereo cable and user’s manual.

*AC adapter included with 182AC models only

iPod not included.

Specifications

• Power Supply: DC 6 volt (Four AAA batteries or AC adapter)

• Output Power: 2+2W/channel @ 8 ohms @ 10%THD

• Speaker Drive: 34 mm speaker 4 ohms

• Frequency Response: 150HZ-18KHZ

• Signal to Noise Ratio: @1kHZ input > 60dB

Modifications not approved by Excalibur Electronics voids warranty.

For Your Safety: When disconnecting the AC power cord, pull the power plug. Do
not pull the cord by itself. Never handle the AC power plug with wet hands, as this
could cause fire or electric shock.

Warning

• To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture.

• Dangerous, high voltages are present inside the product housing.
Do not open the housing.

• To prevent electric shock, make sure to fully insert the plug into the wall socket.

• Refer all servicing to qualified personnel.

Damage Requiring Service: Do not attempt to repair the unit by yourself.
Service should be done by a qualified service technician.

Installing Batteries

You r SOUNDMASTER Cube requires four (4) AAA batteries (not included). To
install the batteries, carefully turn it over and place it upside down on a soft
surface. The battery compartment is located on the base. Press the side tabs and
lift to release the lid of the battery compartment. Install four AAA batteries,
making sure to match the polarity (+ and -) with the diagram inside the battery
compartment. Replace the lid by pressing on the side tabs and returning it to its
original position. Release the side tabs once the lid is secure. You can also power
your SOUNDMASTER Cube by using an AC adapter*. To use the AC adapter,
connect it to the AC adapter input jack located on the back of the unit. Plug the
AC adapter into an electrical outlet.

NOTE: DO NOT EXPOSE YOUR SOUNDMASTER CUBE
TO RAIN OR MOISTURE.

Using Your SOUNDMASTER Cube

Carefully remove your SOUNDMASTER Cube from the packaging. Open the unit
by gently pulling apart the speaker body and extending the unit. Power your
SOUNDMASTER Cube by either installing four AAA batteries or using the AC
adapter*. Please read the Installing Batteries section. Plug your device into the
SOUNDMASTER CUBE using the attached 3.5mm speaker cable. Once your
device is plugged in and the unit is powered, turn the switch to the ON position.
When the unit is on, the light will turn on. If your headphones are plugged into
the jack, your speakers will not play.

Troubleshooting

If there is no sound from your speakers, please check the following:

• The batteries may be incorrectly installed in the battery compartment. If this is
the case, reinstall the batteries, making sure to match the polarity. If this doesn’t
work, try using new batteries.

• Check the AC adapter* to ensure it is securely plugged into the SOUNDMASTER
Cube and the electrical outlet.

• The audio device may not be fully plugged into the speaker or may be plugged
into the wrong jack. If this is the case, carefully inspect your audio device and
plug the cable into the correct jack, making sure the connection is secure.

• The audio input cable to the unit may not be plugged in correctly. Securely
connect the audio input cable.

• The volume setting of your device may be turned off or too low. If this is the
case, increase the volume.

IMPORTANT SAFETY INSTRUCTIONS

Read and keep these instructions for reference.

1.
Heed all warnings and follow all instructions.

2.
Do not use this product near water.

3.
Clean using only a slightly damp cloth. Do not use cleaners with harsh chemical

4.
agents or detergents.

Do not block any of the ventilation openings.

5.
Install and use in accordance with the manufacturers instructions.

6.
Do not place product near any heat sources such as radiators, heat registers, stoves or

7.
other apparatus (including amplifiers) that produce heat.

This product may be equipped with a polarized alternating-current line plug (a plug

8.
having one blade wider than the other). This plug will fit into the power outlet only
one way. This is a safety feature; if you are unable to insert the plug fully into the outlet,
try reversing the plug. If the plug should still fail to fit, contact your electrician to
replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.

Protect the power cord from being damaged or pinched.

9.
Only use attachments/accessories specified by the manufacturer.

10.
Unplug product during lighting storms or when you are not going to use it for a long

11.
period of time.

Refer all servicing to qualified service personnel. Service is required when the product

12.
has been damaged in any way. This includes, but isn't limited to, a damaged power
supply cord or plug, liquid spilt or an object dropped onto the product, exposure to
rain or moisture, dropping the product or the product not operating normally.