Exald ZYZM002 User Manual

Energy Saving Lamp

Introduction

· Conserves natural resources by at least saving 80% electricity than
incandescent bulbs.

· About 6 times lamp life than a standard incandescent bulb.

Notice For Use

·Never use with the following fixtures:

dimming circuit
emergency lighting fixtures
electronic timer fixtures
direct current fixtures

·Use only at the rated voltage and frequency circuit. The power voltage must

be in the range of 120V±10%.

·Use indoor only. Never use it where water may drop on the lamp or where

the atmosphere is humid.

·Do not use in enclosed fixture,Or the lamp’s life would be shorten.

·Always turn off the switch when replacing or cleaning the lamp. Remove and

install it by grasping only the plastic portion of the lamp.

·Added weight may cause instability of free-standing portable lamps in which

the distancefrom the bottom of the base to top of the lamp hold dose not exceed
3 times minimum vase width. Use only with portable lamps which are provided
with lamp shade. The lamps are designed to start at very low supply voltages
down to about 108VAC and even lower if required, they are also designed to
tolerate short term very high supply voltage surges up to 132VAC.
These features are most important for developing area where the supply
voltage can fluctuate widely. They have short circuit protection ,all plastic
materials used are certified Fire Retardant, they can be safely operated in
the temperature range of -20℃ to +65℃

·This product complies with Part 18 of the FCC Rules but may

cause interference to radios, television , wireless telephones, and remote
controls. If interference occurs, move product away from the device or plug
either into a different outlet.

This product may cause unterference to radio equipment and should not be installed near maritime safety

communications equipment or other critical navigation or communication equipment operating between 0.45-30 MHz.