EVO Manufacturing EVO-1121B 2007+ Jeep JK Evap Skid, EVO-12057B, EVO-12058B, EVO-770048 Installation Instructions Manual

EVO-1121B 2007+ Jeep JK Evap Skid
Part# Description Qty EVO-12057B Evap Main Skid 1 EVO-12058B Evap Skid Rear Mount 1 EVO-770048 EVO Evap Hardware Pack 1
Installation photos shown are on a 2012 + Jeep Wrangler JK, for those installing
the EVO Evap Skid on a 07-11 Jeep JK follow the same install procedures.
Throughout the install there is no need to remove any of the factory hoses or factory evap
mounting bracket. You will only be required to remove the factory bracket from the
NOTES PLEASE READ BEFORE INSTALL
crossmembers.
1. Loosen the two factory front evap skid bolts so that about ¼” thread are showing.
2. Loosen and remove the rear factory evap skid bolt completely.
3. Loosely install the EVO-12058B Evap Skid Rear Mount Plate using the rear factory evap skid bolt , the rear mount plate should be installed so that the plate is sandwiched between the crossmember and factory evap bracket, leaving yourself a few threads still showing.
4. Remove the two factory front evap skid bolts you previously loosened in step #1. Note the factory evap skid bracket will now be supported by the rear bolt only. You are now ready to install EVO-12057B Evap Main Skid Plate. Start by placing the front lip of the factory evap skid under the front edge of the EVO Evap Main Skid. Once you have done this the rear of the factory evap skid can be nestled into the rear of the EVO Evap Main skid.
Loading...
+ 1 hidden pages