EVIVA Address: 30 WOOD ST PATTERSON NJ 07524
Length: 67-10/11”(measured from left most to right most point on outer rim)
Width: 29-1/8”(measured from back most to front most point on outer rim)
Height: 31-1/2”(exterior height from base structural support to top of tub lip)
Basin Dimension at Tub Base Length: 40-1/2”
Basin Dimension at Tub Base Width: 20-1/2”
Height from tub base to top of tub lip:17-1/3”
Water Depth: 14-1/2”(height from tub floor drain to overflow outlet)
Maximum Water Capacity: 64 gallons
Installation Type: Free standing
Bath Type: Soaking
Drain Location: Center
Material: Acrylic
EVVN6210-67WH Bathtub Specifications
：
EVIVA Address: 30 WOOD ST PATTERSON NJ 07524
EVIVA Address: 30 WOOD ST PATTERSON NJ 07524
1. Clean,level,and prepare the floor
for installation.
2. Place the unit in the exact
installed position on the floor and
trace the outline of the bath with
a pencil or any erasable marking
(figure 7).
3. Determine the location of the
drain pipe ,on the floor by taking
measurements of the drain and
waste location underneath the unit
FREESTANDING INSTALLATION
Note: If you purchased a brushed nickel trim kit, it must be installed before
installing the bathtub (brushed nickel trim not available on all models),
Warning: Due to the rough handing during shipping or on the job site, do not
install this product until a thorough inspection and water test has been completed.
Check bathtub for correct model and size. Carefully inspect the tub for any
damage (i.e., chips, scratches, cracks).If at any point during the pre-installation
inspection and water test, you discover a problem with the bathtub or piping
system, DO NOT INSTALL the unit and contact us immediately.
All pre installed parts must be checked and retightened before installation.
--------------------------------------------------------------------------
EVIVA Address: 30 WOOD ST PATTERSON NJ 07524
4. Using a blanket , cardboard ,or
other clean protective surface , turn
the unit on its side so that the unit
is properly supported during drain
installation.
5. Clean the drain hole area in
preparation of setting the drain.
INSTALL DRAIN HARDWARE
6. Apply a bead of clear silicone
or plumbers putty around the
Drain body and pass it through
the drain hole (figure 9).
7. Apply plumbers putty to the
the area should be dry and free of
any debris.
Washer and slide it over the bottom of the Drain Body (figure 9).
8. Slide the paper washer over the drain body.
9. Attach the Drain Body Nut on the Drain Body and tighten until the Nut and
Washer have created a seal with the bottom of the bathtub .DO NOT
OVERTIGHTEN (figure 10).
EVIVA Address: 30 WOOD ST PATTERSON NJ 07524
PREPARE TAIL PIECE
All parts involved in tail piece
installation are provided by the
installer
10. Drain waste vent must always
be installed according to local
standard. Verify the placement of
the bathtub before drilling the
hole for the drain waste vent.
11. Install 1 1/2”rubber slip
gasket over the drain waste vent.
12. Cut tail piece to desired
length(will vary for each
installation)
13. Slide tail piece nut over tail
piece towards flanged end.
14. Connect tail piece assembly
to waste vent.
15. Place flange washer on top of
tail piece.
EVIVA Address: 30 WOOD ST PATTERSON NJ 07524
INSTALL BATHTUB
16. Apply a generous bead of adhesive
or silicone to the bottom of the tub
supports(figure 12).
17. Then apply a bead of tub and tile
18. Carefully set tub into position(figure
13) and connect the drain
hardware(previously installed).Finish
the installation of the tail-piece
installation.
caulk around the edge of the
base(figure 12).
COMPLETE BATHTUB INSTALLATION
19. Fill the tub with waster to the overflow and then drain the tub while inspecting
the waste connections below the floor for leaks. Access from below will be
necessary for this step (figure 14).
21. With the bathtub now in place, wipe off any excess tub and tile caulk and
adhesive where the tub meets the floor.
22. Run a bead of tub and tile caulk around the bottom edge of the bathtub where
it meets the floor. Wipe off any excess caulk with a wet cloth (figure 15).
Loading...