Everspring Industry Co TSM04 User Manual
1
TSM04
Magnetic Contact Detector
General Introduction
The TSM04 Magnetic Detector is used in security or home automation applications
to detect opening or closing of doors/windows. It consists of two parts; a Detector
and a Magnet. Opening the protected doors/ windows will remove the magnetic field,
sending an alarm signal to the gateway. Its great compatibility with our U-Net family
security products makes it suitable for smart home cloud based platforms such as
Homesys.
Product Layout
A. Detector
G. Mylar hole
B. LED indicator
H. Screw mounting hole
C. Magnet
I Slot
D. Battery mylar
J Learning button
E. Screw mounting hole
K Mylar hole
F. Tamper
L Battery
Accessories :
Binding with Homesys
1. Device with battery included. The battery is isolated by a mylar. Don’t remove
the mylar yet.
2. Log into the Homesys account from a web browser.
3. Select “System”, then ”Add a Device”
4. Select “Magnetic Detector”
.
3M rubber
Screws
2
5. The following screen will appear. This means the gateway is entering binding
mode.
6. Devices with battery included : Pull out the mylar, and the LED should turn on.
Devices without battery included : Open the backplate and use a screwdriver to
open the battery cover as below to insert the battery
7. The screen below will appear in 10 seconds if the process is successful.
Note: Time-out will occur if the binding process was unsuccessful. Please refer
to the “Manual Binding”.
Manual Binding
1. Remove the backplate of the detector and leaving the battery inside the
detector
2. Repeat steps 4 to 5 of the Binding with Homesys section
3. Press the Learning button for about 3 seconds and release. The LED will flash
repeatedly. This implies detector has now entered the binding mode and is
waiting to receive binding signals from the gateway.
4. Within 5 seconds, the LED indicator will flash rapidly and turn off, indicating the
learning procedure is completed. The screen below will appear indicating the
process is successful..
Learning
button
Loading...