Everspring Industry Co SR804 User Manual

SR804 Wireless Keyfob

A

y

Installation Instructions

General Introduction

The SR804 Wireless Keyfob is used to Arm, Partial Arm and Disarm the system.
The Keyfob also incorporates a Panic switch that will immediately initiate a Full
Alarm condition when the system is Armed or Disarmed. Its great compatibility with
our U-Net family security products makes it suitable for smart home cloud based
platforms such as Homesys

Product Overview

LED indicator B Arm C Partial Arm
D Disarm E Panic Switch F Key Chain Ring
G Negative Polarit

Binding with Homesys

1. Remove the battery cover behind the keyfob.

2. Prepare the CR2032 coin cell battery by removing any plastic wrapping on the
battery. Do not insert the batteries yet into the unit.

3. Log into the Homesys account from a web browser.

H Positive Polarity

4. Select “System”, then “Add a New Device”.

5. Select “Keyfob”.

6. The following screen will appear. This means the gateway is entering binding
mode.

1

7. Insert the battery ensuring that the +v terminal faces upwards away from the
PCB and replace the battery cover.

8. The screen below will appear in 10 seconds if the process is successful.

9. Time-out will occur if the binding process was unsuccessful. Please refer to the
“Manual binding” section.

Manual Binding

1. With the battery inserted, repeat steps 3 to 6 of the Binding with Homesys

section.

2. Press and hold the Disarm button for more than 3 seconds until the LED flashes

moderately (on for 2 second; off for 2 second). This implies keyfob has now
entered the binding mode and is waiting to receive binding signals from the
gateway.

3. Within 5 secs, the LED indicator then stop flashing and turn off, indicating the
learning procedure is completed. The screen below will appear indicating the
process is successful.

4. If after 30 seconds LED flashes rapidly for 3 times, it means the keyfob fails the
binding process

Operation & Testing

Operating the Keyfob

There are 5 operating modes provided by the keyfob.

1. ARM : Press and release the ARM button.

2. DISARM : Press and release

3. PARTIAL ARM 1: Press and release the Partial Arm button once

4. PANIC: Slide the Panic Switch and hold for at least 3 secs before releasing.

Note: The LED on the keyfob will turn green after button press is released. This
implies the keyfob receives a confirmation signal from the Gateway. Instead if the
LED turns red, this means the keyfob did not receive the reply from gateway

Testing the Keyfob

1. Press the Arm button to see if there is an entry in the LOGS page of your
Homesys account.

2. Press the Partial Arm button to see if there is an entry in the LOGS page of your
Homesys account.

3. Press the Disarm button to see if there is an entry in the LOGS page of your
Homesys account.

4. Slide the Panic Switch and hold for at least 3 secs before releasing. See if there
is an entry in the LOGS page of your Homesys account.

Note: Press the Disarm button to deactivate a triggered alarm and siren sound.

2