Everspring Industry Co AC123 Users Manual

AC123 REMOTE CONTROLLER

Symbol on LCD Screen

Symbol

~

Name of Symbol Significance
Antenna The remote controller is being communicated with other device.
Not Applicable The setting made by the remote controller generates conflict.
Battery Indicator
Day of Week Sunday, Monday, Tuesday, Wednesday, Thursday, Friday, Saturday

Real Time Time indication, AM means morning, PM means afternoon
Preferred Mode When the preferred mode is set or the preset preferred mode is chosen, an indication

Program Mode

Auto Mode In auto mode, time-to-operate can be
Learning Mode In learning mode.
Open/close status
Curtain status An indication of curtain device is applied.
Incandescent dimmer status
Arm status
Group code Devices to be controlled (If used for BH product, it refers to unit code)
Channel Used for house code of BH series product

full half to full Low

of
executed.

When the program mode is being set, an indication of
16

will be shown. means the preferred mode is being set or 16th is being

th

is being set.

open, close

Full brightness, Half brightness, Darkness

fully arm, part-arm 1, part-arm 2, disarm

will be shown. means

CH

Keypad Button

Symbol

OK

~

Delete Upon deletion is taken

Name of Symbol Significance
Preferred button Used for setting or executing preferred mode
Auto button Used for entering or leaving the auto mode
Program button Used for programming mode
Learning button Used for entering learning mode
On button

Off button

Leftward Towards the left
Rightward Towards the right
OK button Used for confirmation while setting or saving
Single Digit button
Tens Digit button
＊button
Present time button Keep pressing 3 seconds will enter present time setting
Setting BH button Keep pressing 3 seconds will enter the setting for house code of BH series

To operate together with
all devices to be activated; for time setting, it is regarded as UP.

To operate together with
Individual or all devices to be off; for time setting, it is regarded as DOWN.

All

~ 、 or ＊(all) button, let the memorized individual or

~ 、 or ＊(all) button, let the memorized

1

SPECIFICATIONS:

Frequency range 315 MHz or 433 MHz
Battery 1.5V A AA type x 4
Communication Range 70 meters min. (in an open space)

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with th e limits for a Class B digital device, pu rsuant to Part 1 5 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment
and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this equipment.

IMPORT AN T NOTE:
FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must
follow the specific operating instructions for satisfying RF exposure compliance.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

2