Everpure E17-17, EV9797-92 User Manual

B E N E F I T S

A P P L I C A T I O N / S I Z I N G

I N S T A L L A T I O N T I P S

O P E R A T I O N T I P S

EV9797-91

MR S-20

Compl ete Mineral Reduction Water Proce ssin g Sy stem

Improves equipment life and performance by
removing at least 90%+ of all dissolved solids
that cause scale build-up

Protects against taste and odor causing
contaminants while removing dirt, particulates
and dissolved minerals

Less frequent deliming of equipment means
reduced maintenance and service costs

Sanitary cartridge replacement is simple, quick
and clean. Internal filter parts are never exposed
to handling or contamination

Choose a mounting location suitable to support
the full weight of the system when operating

Mount system convenient to the post water
softener supply line and for routing the outlet and
drain lines

The tank assemby may be mounted above, below
or alongside (preferred) of the water processor
assembly

Install vertically with cartridges hanging down.
Allow 2-1/2" clearance below the cartridge for
easy cartridge replacement

The water inlet must supply a minimum of 0.5
gpm at 50-85 psi on a consistent basis

Deliming of equipment prior to application is
recommended

MRS-20 System: EV9797-91

MRS-20T System: EV9797-92

4CB5 cartridge: EV9617-11

4CB5-MR cartridge: E17-17

MR-20 Cartridge: EV9273-69

4MR-1 Cartridge: EV9273-69

Replace the 4CB5-MR carbon filter every 12
months. Change the 4MR-1 mineral reduction
cartridge every two years, or as needed

Cartridge replacement schedules assume the
system is installed on softened water

Outlet Water Production: 25 gal. per day (54.5L)
@ 50 psig (340 kPa), 77°F (25°C) per NSF
Standard 58 testing. Water production depends
on supply water pressure and temperature

Wastewater Production: 74 gal. per day (289L)
@ 50 psig (340 kPa), 77°F (25°C). Wastewater
drain line capacity: 3 gpm (21 Lpm) to open
atmosphere

Storage Tank Capacity: 3 gallon tank; effective/
usable capacity: 2.5 gal. (9.5L)

Two-part design makes installation flexible, and
small footprint easily fits in any kitchen

Easy to operate system has no moving parts and
requires no electrical power

System includes mineral reduction processor,
carbon filter cartidge, reverse osmosis cartridge,
and storage tank

No monitoring of grains per gallons is necessary.
System removes scale reducing minerals regardless
of the GPG

Mineral Reduction System for foodservice
applications

Ideal for: Flash steamers, conventional steamers,
cheese melters, combi-ovens and coffee/espresso
machines

Uniquely designed for low volume applications
(approximately 25 gpd nominal consumption)

27"

22.5"

25"

22.5"

OUTLET

3/8" FNPT

INLET
3/8" FNPT

Overall Dimensions:
Processor - 25”H x 22.5"”W x 5”D
Tank - 27”H x 22.5"”W x 11.25”D

Inlet and Outlet connection:
3/8” OD John Guest tubing fitting (provided)
3/8" ID beverage hose

Wastewater line and Sample port connection:
1/4" OD John Guest tubing fitting (provided)

Steamer manifold connection:
1/4" quick connect on tubing coil (provided)

Steamer feed hose connection:
3/8" barb on tubing coil (provided)

MR S -20

MRS-20 T

Pressure Requirements:
10 psi -125 psi (0.7 – 8.6 bar), non-shock

Water Supply:

0.5 gpm (1.9L) @ 50-85 psi (280-595 Kpa)

Inlet Temperature:
40°F - 100°F (4-38°C)

Inlet TDS:
1,500 ppm max recommended

Operating Weight: 50 lbs.

The contaminants or other substances
removed or reduced by this drinking water
system are not necessarily in your water. Do
not use with water that is microbiologically
unsafe or of unknown quality without
adequate disinfection before or after the
system. Systems certified for cyst reduction
may be used with disinfected water that may
contain filterable cysts.

Everpure water treatment systems (excluding replaceable elements)
are covered by a limited warranty against defects in material and
workmanship for a period of five years after date of purchase.
Everpure replaceable elements (filter cartridges and water treatment
cartridges) are covered by a limited warranty against defects in
material and workmanship for a period of one year after date of
purchase. See printed warranty for details. Everpure will provide a
copy of the warranty upon request.

Everpure, LLC
1040 Muirfield Drive
Hanover Park, IL 60133
Ph: 630-307-3000 Fax: [phone]