Assembly Instructions
Caution : You must read this before you proceed
SOFA
Parts List
Label Picture Description QTY
A Seat Base 1
B Backrest 1
C Right Armrest 1
1 of 7
D Left Armrest 1
E Leg 5
Hardware List
Label Picture Description QTY
①
②
③
Assembly Preparation
Before Beginning Assembly:
x1
x1
Plastic Washer 8
Double Head Insert 4
Bolt 2
x1
x1
x5
x4
x2
x8
2 of 7
Assembly Steps
Overview
Backrest(B)
Left Armrest(D)
Leg(E)
FRONT FACING
Right Armrest(C)
Seat Base(A)
This Sofa has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Sofa parts, the above
picture is to help you put the various parts into perspective. Please
read through the instructions below to familiarise yourself with the
parts and steps before assembly.
Step 1
x5
x2
x8
x4
Seat Base(A)
x1
Backrest(B)
Position the Seat Base(A) on a clean, non-marring surface.
Unzipper non-woven Fabric and Remove the Backrest(B), Leg(E)
and Hardware package as shown above.
3 of 7
Step 2
Left Armrest(D)
Position Left Armrest(D) on its back,put Double Head Insert(②) into
Left Armrest(D) as shown above.
Repeat the same step to put Double Head Insert(②) into the Right
Armrest(C).
Step 3
Seat Base(A)
Left Armrest(D)
Slide the Double Head Insert(②) on the Left Armrest(D) into the
Double Head Insert(②) on the Seat Base(A) as shown in the
picture.
Note: Make sure the Double Head Insert(②) on Left Armrest(D) lock
into the Double Head Insert(②) on the Seat Base(A).
Assistance from an adult partner is necessary for this assembly
process.
Repeat the same step to install Right Armrest(C).
During this assembly process - do exercise caution. You may need
to use your hand to press down and or pave away the padded
surface to facilitate the 'slip and slide' assembly.
Caution: Ensure that your fingers do not get caught or pinched in
the assembly process.
4 of 7
Step 4
Backrest(B)
Seat Base(A)
Attach the Backrest(B) to the Seat Base(A) by pushing the Backrest
(A) downwards until the Backrest(A) is fully slotted and locked into
position with Seat Base(A) as shown above.
Assistance from an adult partner is necessary for this assembly
process.
Step 5
Seat Base(A)
5 of 7
Put the Seat Base(A) on its back as shown.
Attach the Backrest(B) to the Seat Base(A) Using Bolt(③) by turning
clockwise until tight as shown above.
Then close the non-woven Fabric zipper.
Step 6
Leg(E)
Seat Base(A)
Install the Leg(E) onto the bottom of the Seat Base(A) by putting a
Plastic Washer(①)(optional but improves security and tightness),
onto the threaded stem. Insert the threaded stem into the threaded
hole at each corner of the bottom of the Seat Base(A). Tighten the
leg by turning clockwise.
Repeat the same steps to install the remaining 3 legs.and position
the Seat Base(A) right side up.
Step 7
Your Sofa is ready for use.
Your Sofa can only be used on a flat, level surface.
6 of 7
7 of 7
Loading...