EverFocus EPTZ3000I, Eptz3000 User Manual

Speed Dome

EPTZ3000/EPTZ3000I

USER MANUAL

Date: Nov 2008

Table of Contents

1. EPTZ3000/EPTZ3000I OVERVIEW.................................................... 1-3

1.1. Introduction .............................................................................................1-3

1.2. Specifications..........................................................................................1-5

1.3. Feature .....................................................................................................1-7

1.3.1. Profile of EPTZ3000/EPTZ3000I........................................................1-7

1.3.2. EPTZ3000/EPTZ3000I Base Board ...................................................1-8

1.3.3. EPTZ3000/EPTZ3000I Control Board................................................1-9

1.4. EPTZ3000/EPTZ3000I Connection .......................................................1-10

1.5. EPTZ3000/EPTZ3000I Quick Operation Guide (Work with EKB500) .1-11

2. EPTZ3000/EPTZ3000I INSTALLATION........................................... 2-12

2.1. Packing List...........................................................................................2-12

2.2. Cable Needed.........................................................................................2-12

2.3. Initial Setup............................................................................................2-13

2.3.1. Address Setting................................................................................2-14

2.3.2. Communication Protocol Setting......................................................2-17

2.3.3. Transmission Speed Setting (Baud Rate Setting) ............................2-17

2.4. Rack and Speed Dome Installation......................................................2-19

2.4.1. Installation Requirements.................................................................2-19

2.4.2. EPTZ3000 Dome Camera Wall Mount Installation...........................2-19

2.4.3. EPTZ3000I Dome Camera Installation.............................................2-22

2.5. Accessories...........................................................................................2-25

2.5.1. EPTZ-CPMA: Ceiling Pendant Mount Adapter.................................2-25

2.5.2. EPTZ-PMA: Pole Mount Adapter......................................................2-25

2.5.3. EPTZ- CMA: Corner Mount Adapter.................................................2-25

1-1

3. EPTZ3000/EPTZ3000I CAMERA SETUP MENU............................. 3-27

3.1. Structure of the Setup Menu ................................................................3-27

3.1.1. Camera Setup Menu........................................................................3-28

4. EPTZ3000/3000I FUNCTION SETUP AND OPERATION ................ 4-36

4.1. Manual Control Mode............................................................................4-36

4.2. Auto Pan Mode ......................................................................................4-36

4.3. Position Setting.....................................................................................4-37

4.4. Tour Mode ..............................................................................................4-38

4.5. Alarm Link to a Position/Tour...............................................................4-39

4.6. Other operations ...................................................................................4-40

APPENDIX : The Alarm I/O Connection............................................... 4-41

1-2

1. EPTZ3000/EPTZ3000I OVERVIEW

1.1. Introduction

EPTZ3000/EPTZ3000I, an intelligent high-speed dome camera is ready to secure
your property with its omni-directional and exact monitoring. A 30X optical and 8X
digital zoom combining with a high-performance chip makes captured images clear
and vivid. The other powerful camera functions EPTZ3000/EPTZ3000I equips with:

 Wide Dynamic makes objects clear in a high illumination background.
 Vertical double density interline CCD with a slower shutter and true

Day/Night function.

 Electronics flip, no mechanical flip is necessary.
 520 color/570 B&W TVL; PAL/NTSC image formats support.
 Auto and fast focus increases the searching speed and precision.
 Auto Iris adjusts the monitoring image to the best brightness.
 White Balance function makes the shades of color more natural in different

light conditions.

 Color / B&W images auto switching to enhance the sensitivity in a low light

condition or at night.

 Private zone protects your privacy.

1-3

Furthermore, the micro control unit enables camera a nimble and exact movement
from minimal 0.01°/sec to maximal 360°/sec. It can go to every preset position in 1

second. It also has other advantages such as:

 192 preset positions are available.
 16 cruise tours can be set, and each tour contains up to 16 positions.
 Up to 256 speed domes can be supported on a RS-485 bus when all speed

domes are controlled by keyboard EKB500.

 Auto heater and fan to fit all kinds of temperature (outdoor models).
 Built-in 4 alarm inputs and 1 alarm output.

All of the features make the intelligent high-speed dome camera works for a wide
range and demanding application such as banks, airports, stations, casinos, streets
of cities, intelligent buildings, and etc.

1-4

1.2. Specifications

Model EPTZ3000 (outdoor) EPTZ3000I (indoor)
Pickup Device 1/4'' Vertical double density interline CCD
Video Format NTSC or PAL
Scanning System NTSC: 525 TV lines, 60 fields/sec

PAL: 625 TV lines, 50 fields/sec
Picture Elements 768 x 494 ( NTSC ) , 752 x 582 ( PAL )
Horizontal Resolution 520 TVL:Color ; 570TVL:B/W
Sensitivity 0.3 Lux/F=1.6 Color ; 0.05 Lux/F=1.6 B/W
S/N Ratio Over 52dB
Electronic Shutter 128x (Slow Shutter ON)~1/60~1/120,000 sec (NTSC)

128x (Slow Shutter ON)~1/50~1/120,000 sec (PAL)
Digital Slow Shutter OFF/4x/8x/12x/16x/32x/64x/128x selectable
Shutter Selection AUTO/A.FLK/Manual (x8~1/120000) selectable
Lens Type 30x optical zoom , f=3.3 mm (wide) to 99mm (tele) , F1.6 to F3.2
Zoom Ratio 240x max ( 30x Optical and 8x Digital Zoom )
True Day/Night Auto/Manual ICR
Black Light Comp. No
Auto Gain Control Auto/Manual
White Balance Auto Indoor/Auto Outdoor/One push/Man 2000K,3200K,5100K

selectable
Video Output BNC 1.0Vp-p , 75ohm
Sync. Mode Line Lock/Internal Sync
Power Source 24VAC
Power Consumption 24VAC 18W Max. ( without

24VAC 18W Max.

heater ) 18W

24VAC 66W Max. ( with heater )

70W
Operating Temperature -40°C~50°C ; -40°F~122°F 0°C~ 50°C ; 32°F~122°F
Focus Control One push/Auto/Manual
Horizontal Rotation Speed
Horizontal Rotation Range

0.1°/s~360°/s (1-239 grade shift gears)
360° unlimited rotation

Tilt Rotation Range 180° pendulum motion
Auto Zoom Speed Control Control speed auto-adjusted according to zoom length changing
Auto Pan, 2 Points

Can set freely
Scanning
Auto Pan Speed 1~239 grades available

1-5

Dwell Time (2 points) 1~127 seconds available
Preset Positions 128 positions
Running to Position Speed
Dwell Time at Preset

1~239 grades available

1~239 seconds available
Position
Tour 16 groups
Tour Point per Group 16 preset positions
Fan & Heater Fan & Heater auto starts No
Position Accuracy

±0.1°
Alarm 4 in 1 out with tour/position auto triggering
Built-in Menu for

Yes
Functions
Communication RS-485
Communication Speed 1200/2400/4800/9600 bps
Built-in Protocols EVF-1 ; Pelco-P ; Pelco-D ; A –type ; Plus-D
Address Editable Yes (through DIP switch)
Speed Dome Address 0-255
Manual Pan/Tilt Speed Pan: 0.01º ~ 360º/s ; Tilt: 0.01º ~ 360º/s
Weatherproof Ratings IP66 Indoor
Safety CE ; FCC
Dimensions 330mm(W) x 365mm(H) x

220mm(O.D) /

13"(W) x 14.4" (H) x 8.7"(O.D)

208mm(W) x 215mm(H) x

208mm(O.D) /

8.7"(W) x 12.2" (H) x 8.7"(O.D)

Weight 4.2kg/9.25lbs 2.15kg/4.8lbs

1-6

1.3. Feature

EPTZ3000I

EPTZ3000

1.3.1. Profile of EPTZ3000/EPTZ3000I

M5 Bolt (Hex) x3

Base PCB board

Control board

Wall Mount Bracket

Housing

Inner Housing

M3 Bolt x3

Bulb

Base PCB board

Control board

Connection Bus

Power Cable
BNC Cable
RS485 Cable

Mechanical Part

Camera Module

Power Cable
BNC Cable
RS485 Cable

Housing

Clip

Ceiling

Button

Bulb

Connection Bus

Mechanical Part

Camera Module

1-7

1.3.2. EPTZ3000/EPTZ3000I Base Board

The base board that is on the bottom of the housing connects to power cable, video cable,
control cable, alarm cable, fan and heater. In order to connect to cables, the board needs
to be taken off, and put back after finishing connecting to all cables. The connectors of
cable names are marked on the board in white text. The details of the alarm connector
(JP5) are shown on the APPENDIX A.
For EPTZ3000 outdoor model, JP1, JP3 and JP6 that are two-pin connectors need to be
taken off during installing. JP1 and JP3 are connectors for heater, and they can be
switched. JP6 is a fan controller connector that turns on/off of the fan. The 3 cables are too
short to be connected to a wrong connector when putting them back.

RELAY

JP5

Video +
Video ­RS485 +
RS485 -

AC24
AC24

JP3 JP1

EPTZ3000 Baseboard

RELAY

Video +

JP5

JP4

JP6

Video -

RS485 +

RS485 -

AC24

AC24

EPTZ3000I Baseboard

1-8

1.3.3. EPTZ3000/EPTZ3000I Control Board

The PCB board with two dipswitches is the control board of EPTZ3000/EPTZ3000I. The
two switches are used to set address, protocol, Baud Rate, video format and terminal
resistance.

CPU

ON

1 2 3 4 5 6 7 8

SW1

ID1
ID2
ID3
ID4
ID5
ID6
ID7
ID8

SW2

1 2 3 4 5 6 7 8

ON

Protocol

BAUD

1-9

1.4. EPTZ3000/EPTZ3000I Connection

Ω

Video Out

RS485 Tx(+)

RS485 Tx(-)

Adapter

Alarm 1

Alarm 2

Alarm 3

Alarm 4

24V AC110V AC

POWER
24V AC / 3.5 A

BNC

1.0Vpp ± 0.2V, 75

RS485 Control Line

EPTZ3000/
EPTZ3000I

4 ALARM INPUTS

GROUND

ALARM OUTPUTS

N.C.

N.O.

COM

1-10

1.5. EPTZ3000/EPTZ3000I Quick Operation Guide (Work with EKB500)

EPTZ3000/EPTZ3000I and EKB500 (Keyboard) can work together by using factory
default setting. You just need to connect cables by the following steps:

1. Connect the RS-485 cable to EPTZ3000/EPTZ3000I and a keyboard (EKB500).

2. Connect a video cable from EPTZ3000/EPTZ3000I to a monitor.

3. Connect the power to the EPTZ3000/EPTZ3000I and a keyboard (EKB500).
After the EPTZ3000/EPTZ3000I finishes the self-test mode, you can start to operate
the EPTZ3000/EPTZ3000I via the keyboard.

To operate the EPTZ3000/EPTZ3000I:

UP

IRIS+FocusF.Zoom

In

- N. Out

1. Shift the Joystick up/down or right/left to view from camera.

2. Turn the top of the Joystick to zoom in/out.

3. Press Zoom In/Out, Focus F. /N. and IRIS +/- function keys to operate the
EPTZ3000/EPTZ3000I.

Zoom INZoom OUT

LEFT RIGHT

DOWN

1-11

2. EPTZ3000/EPTZ3000I INSTALLATION

2.1. Packing List

There are 3 boxes that are housing, bulb and mechanical part with a camera module, one
wall mount bracket, one power adapter and one tool packet in the package. The detail
accessories list below:

 Housing x1
 Bulb x1
 Mechanical part with a camera module x1
 Wall mount bracket x1
 Adapter x1
 Tool packet

 Glove x2
 M5 Hex Allen wrench x1
 Pin connector x1
 M5 screw (Hex) x3 for wall mount bracket fixing
 M3 screw x3 for bulb fixing

2.2. Cable Needed

Power Cable

An adapter with 24V AC/3.5A output provides the power to the EPTZ3000/EPTZ3000I. An
extension power line may be needed.

Note: The input AC voltage range of an adapter depends on different area.
Please make sure the voltage range before installing.

2-12