EverFocus B-W CCD Camera None User Manual

X The following diagram shows the location for the other cameras.

For B/W CCD Camera

For B/W CCD
Camera

For B/W CCD
Camera

For B/W CCD
Camera

For B/W CCD
Camera

Y Fix the camera by the screw. Tear off the black paper of the

corresponding view window where the lens faces to.

Z Repeat steps 3 to 6 in the Installation Instructions.

V. Specifications

Picture Elements

1/3" SONY B/W CCDPickup Device

510 x 492 (EIA)
500 x 582 (CCIR)

420 TV linesHorizontal Resolution

0.04 Lux/F=1.2Sensitivity

Over 48 dB (AGC off)S/N Ratio

1/50(1/60)~1/100,000Electronic Shutter

YesBack Light Comp.

0.45Gamma Correction

BNC 1.0Vp-p,75 ohmVideo Output

Internal Sync.Sync. Mode

M12 x P0.5Lens Mount

12VDCPower Source

3W max. Power Consumption

150 mm (O.D.) x 50 mm (H) ; 5.9" (O.D.) x 2" (H)Dimensions

0.283kg ; 0.62lbsWeight

0°C to + 50°C ; 32°F~122°F(20%~80% Humidity)Operating Temperature

FCC/CE Certifications

INSTRUCTION
MANUAL

1/3” B/W CCD Camera

I. General

This camera is smoke detectors built with B/W CCD cameras
for discreet surveillance. It comes with B/W CCD camera that
delivers clear and sharp picture for side viewing; and it is easy
to change different lenses to adopt the best view angles for
security need. This camera can simultaneously install up to 4
cameras, which is most economic and effective for video
surveillance.

III. Installation Instructions

1. The horizontal view angle of the Smoke Detector Camera is

78-degree. Decide the location to install the camera.

78°

4. Connect the video output of the camera to a monochrome monitor
or other video device through a 75 ohm type coaxial cable with
BNC female connector at cable extension.

5. Connect the +12VDC regulated power source of the camera to

the DC 12V Power-in jack with 2mm, center+, outer-plug.

6. Adjust the direction of the lens as per needed.

II. Precautions

• Do not expose the camera to humidity and dust. Outdoor

application without shielding is not recommended.

• Handle with care. This camera consists of sensitive high

precision parts. Do not disassemble or install it on an
unstable base.

• Operate on +12VDC. Use a regulated power source only.

• Never face the camera toward the sun directly.

Full-Screen Width of View

= 1.6 X Distance between

Camera and Target

2. Visually inspect the contents to ascertain that no damage
occurred during shipping.

3.Plug in the attached video and power cable to the camera
connector.

IV. Installing More Cameras

This camera can accommodate up to 4 B/W CCD cameras. Please

refer to the following steps to install the other cameras.

P/N: MSM1G0030A VerB