EverFocus 1/3"" B/W CCD Camera None, 1/3 Instruction Manual

V. Specifications

INSTRUCTION
MANUAL

X The following diagram shows the location for the other cameras.

Y Fix the camera by the screw. Tear off the black paper of the

corresponding view window where the lens faces to.

Z Repeat steps 3 to 6 in the Installation Instructions.

For B/W CCD
Camera

For B/W CCD
Camera

For B/W CCD Camera

For B/W CCD
Camera

For B/W CCD
Camera

1/3” B/W CCD Camera

FCC/CE Certifications

0°C to + 50°C ; 32°F~122°F(20%~80% Humidity)Operating Temperature

0.283kg ; 0.62lbsWeight

150 mm (O.D.) x 50 mm (H) ; 5.9" (O.D.) x 2" (H)Dimensions

3W max. Power Consumption

12VDCPower Source

M12 x P0.5Lens Mount

Internal Sync.Sync. Mode

BNC 1.0Vp-p,75 ohmVideo Output

0.45Gamma Correction

YesBack Light Comp.

1/50(1/60)~1/100,000Electronic Shutter

Over 48 dB (AGC off)S/N Ratio

0.04 Lux/F=1.2Sensitivity

420 TV linesHorizontal Resolution

510 x 492 (EIA)
500 x 582 (CCIR)

Picture Elements

1/3" SONY B/W CCDPickup Device

III. Installation Instructions

1. The horizontal view angle of the Smoke Detector Camera is

78-degree. Decide the location to install the camera.

II. Precautions

• Do not expose the camera to humidity and dust. Outdoor

application without shielding is not recommended.

• Handle with care. This camera consists of sensitive high

precision parts. Do not disassemble or install it on an
unstable base.

• Operate on +12VDC. Use a regulated power source only.

• Never face the camera toward the sun directly.

P/N: MSM1G0030A VerB

4. Connect the video output of the camera to a monochrome monitor
or other video device through a 75 ohm type coaxial cable with
BNC female connector at cable extension.

5. Connect the +12VDC regulated power source of the camera to

the DC 12V Power-in jack with 2mm, center+, outer-plug.

6. Adjust the direction of the lens as per needed.

I. General

This camera is smoke detectors built with B/W CCD cameras
for discreet surveillance. It comes with B/W CCD camera that
delivers clear and sharp picture for side viewing; and it is easy
to change different lenses to adopt the best view angles for
security need. This camera can simultaneously install up to 4
cameras, which is most economic and effective for video
surveillance.

IV. Installing More Cameras

This camera can accommodate up to 4 B/W CCD cameras. Please

refer to the following steps to install the other cameras.

2. Visually inspect the contents to ascertain that no damage
occurred during shipping.

3.Plug in the attached video and power cable to the camera
connector.

Full-Screen Width of View

= 1.6 X Distance between

Camera and Target

78°