Everdure HCC183SA Instruction Manual

OPERATION, MAINTENANCE

AND SAFETY INSTRUCTIONS

FOR EVERDURE HEATER HCC183SA

HEAT LIVE RELAX

IMPORTANT SAFETY INSTRUCTIONS

IMPORTANT: Read the safety precautions of this booklet carefully before attempting to assemble,

install, operate or maintain the product described. Protect yourself and others by
observing all safety information. Failure to comply with instructions could result in
personal injury and/or property damage. If you are unsure about anything regarding
your heater or these instructions, please contact Everdure on 1300 766 066 in Australia
or [phone] in New Zealand before operating your appliance

1. Read all instructions carefully before using the heater.

2. Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electrical shock, or injury to persons.

3. Remove the package and ensure that the heater is undamaged. In case of doubt do not use the heater
and contact Everdure Service. Do not let children play with any parts of the package.

4. This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience or knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible for their safety. Children should
be supervised to ensure that they do not play with the appliance.

5. Before you use the heater, check if the voltage marked on the rating label corresponds to the mains in
your home.

.

6. Extreme caution is necessary when the heater is used by or near children or individuals with decreased
mental and physical capacity and whenever the heater is left operating unattended.

7. Avoid using extension cords as the extension cord may overheat and cause a risk of fire.

8. Do not pull the power cord to disconnect with the power source. Always grasp the plug to pull it out.

9. Do not insert any objects into the heater as it may cause an electric shock or fire or damage to the
heater. Do not block or tamper with the heater in any manner while it is in operation. To prevent a
possible fire, do not block the air inlet or outlet in any manner. Do not place on soft surfaces, like a bed,
where openings may become blocked.

10. Do not leave the heater unattended. Always unplug the heater when not in use.

WARNING: The Main Power Switch and the On/Off switch should not be used as the sole means of

disconnecting power. Always unplug the power cord before servicing or moving the unit.

11. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use the
handle when moving the heater (where available) or hold on the sides if not available (make sure the
unit is turned off). Keep combustible materials such as furniture, pillows, bedding, papers, clothes and
curtains at least 3 feet (0.9m) from the front of the heater and keep them at least 1 foot (0.3m) from the
sides and rear.

12. The heater has hot and arcing or sparking parts inside. It must NOT be used in potentially dangerous
locations such as flammable, explosive, chemical-laden or wet atmospheres. This heater is intended
for general indoor domestic use ONLY.

13. This heater is not intended for use in wet or damp locations. Never locate a heater where it may fall into
a bathtub or other water container.

14. Do not use the heater outdoors.

15. This heater includes a tilt switch that turns the heater off if it falls over. Once righted, the heater can be
used as normal.

WARNING:

To avoid danger of electric shock, unplug from outlet when not in use and before cleaning. If the
supply cord is damaged, it must be replaced by a special cord or assembly available from an
authorised person. In order to avoid overheating, do not cover the heater. The heater must NOT
be located immediately below a socket outlet. Do not use the heater in the immediate
surrounding of a bath, shower or swimming pool.

HEAT LIVE RELAX

GENERAL HEATER PARTS

3

Handle

Thermostat
control
knob

Power
knob

Power
Indicator

Front
housing

GETTING STARTED

1. Carefully remove the heater from the plastic bag and the carton, and unwind the cord to its full length.

2. Place the heater onto a stable, flat and dry surface.

3. Set the power knob to the ’O’ (off) position. Plug the cord set into a 230-240V~A.C. 50Hz electrical outlet. Turn
the power on at the electrical outlet.

PLEASE NOTE: The power indicator will light up ONLY when the heater is running.

The heater will only operate if the thermostat control knob is set to a higher temperature than the
temperature of the room it is in.

Front side

Air outlet

Oscillation
Switch

HEAT LIVE RELAX