0
& MAINTENANCE INSTRUCTIONS
Models Included:
ASSEMBLY, OPERATION
FOR EVERDURE E2GO PORTABLE GAS BARBECUES
E2GLPC-09B
E2GLPC-09G
THE EVOLUTION OF PORTABLE OUTDOOR COOKING
2
OPERATION AND MAINTENANCE INSTRUCTIONS
FOR EVERDURE E2GO GAS BARBECUE RANGE
E2GLPC-09B & E2GLPC-09G OUTDOOR PORTABLE BARBECUES
CONTENTS
SECTION PAGE NO.
Important Safety Instructions Gas 3
Appliance Details 4
Gas Connections 4
Outdoor Installation Guide 5
Operating Instructions 6
Lighting Procedure 7
Cleaning & Storage 7
Troubleshooting 8
Barbecue Assembly 9
Maintenance 10
Barbecue Accessories 10
Warranty 10
Parts List: Barbecue Assembly 11
It is important that you retain these instructions, proof of purchase as well as
other important documents about this product for future reference.
E2GO
2
THE EVOLUTION OF PORTABLE OUTDOOR COOKING
3
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT: Read the safety precautions of this booklet carefully before removing the
barbecue from its carton or connecting the barbecue to its gas supply. If you
are unsure about anything regarding your barbecue, please contact Everdure on
1300 766 066 before operating your appliance.
1. This Portable barbecue is intended for OUTDOOR USE ONLY. This appliance must NOT be used indoors.
2. For your safety and enjoyment, read all operating instructions before lighting.
3. Ensure that all gas connections are tight before operating this appliance (refer to leak testing procedure in this manual).
Always check for leaks when a gas cylinder is replaced or reconnected.
4. Unsupervised children or pets should not be near a barbecue while cooking or during warm up or cool down. Ensure
children or pets are kept a distance well away from the barbecue whilst it is in use. Ensure that young children do not play
with the appliance. This appliance is not intended for use by young children or infirm persons.
5. Particular care must be taken when removing the fat tray and the disposable foil trays. Mishandling of hot oil and fats can
cause serious injury.
6. Turn gas valve/control knob and gas cylinder valve off after use. Do not allow build up of unburned gas.
7. Do not use this appliance for any purpose other than what it is intended for.
8. Do not move this barbecue while in use or directly after use, as accessible parts may be very hot. The barbecue should only
be lifted by the serverys at either side (the fold out servery bins should be either folded in or removed). Take care that undue
pressure will not be placed on the gas hose, or turn off the gas supply & remove the hose from the cylinder or gas source
(not at the barbecue). Take care that the fat tray & disposable foil tray are removed to minimise fat/oil spillage.
9. This barbecue has been designed to be used either on a raised bench or on the optional e2go Trolley Stand. When using a
raised surface (table etc.), ensure the surface is level, large enough and strong enough to support the barbecue and will
withstand temperatures of 60°C above ambient temperature. When using an E2go Trolley Stand, ensure that your barbecue
is in a level position and the barbecue is secured onto the trolley correctly.
10. People with flammable clothing such as nylon etc. should keep well away from the barbecue when it is operating.
11. Never leave the burner on high for more than 10 minutes unless actually cooking.
12. In case of fat fire turn cylinder off. Fat trays should be cleaned and checked before using the barbecue. Disposable foil
trays should be replaced before using the barbecue. Regular cleaning should reduce the build up of fat and food residues
which is combustible and can result in a fat fire. Fat fires can be prevented with diligence in cleaning your fat tray and
regular replacement of foil trays. Do not allow the foil tray to overflow. Damage as a result of fat fire is not covered by your
warranty and voids it. Do not use sand, fat absorbents or kitty litter in the fat tray or disposable foil tray.
13. Ensure that the product has adequate clearance from combustible materials. The appliance is designed so that heat will not
affect the trolley. All combustible materials must be kept more than 250mm from the sides and rear of the trolley and more
than 1500mm above the cooking surface of the barbecue.
14. If the burner makes a hissing sound when lit, it may be burning inside. Turn the burner off, allow to cool, and try ignition
again. Keep your barbecue protected against strong wind – if this cannot be avoided, always check that the burners remain
alight if operating the barbecue in windy conditions.
15. Do not carry out any servicing on the gas manifold of the barbecue yourself – this must only be done by authorised
technicians.
16. We recommend that you regularly maintain your barbecue and keep it in good condition. This can be achieved by following
the cleaning and maintenance suggestions in this booklet.
17. The barbecue (and portable trolley) is designed to be used with either 4kg or 9kg gas cylinders. When not using an optional
e2go Trolley Stand, the cylinder should be placed at a lower level to the barbecue, as far away as the hose will allow without
undue tension on the hose, in a protected spot (so it does not receive any fat splatter from cooking or can be accidently
knocked over). When using the e2go Trolley Stand, the gas cylinder should be placed in the dedicated cylinder mounting at
the bottom of the trolley, not beside the trolley.
18. This appliance is not suitable for mounting in a movable vehicle (boat, trailer etc).
19. Do not use or store this appliance in areas of high salt content (a marine environment) or an area with caustic fumes or
liquids (such as a domestic pool), as these chemicals can cause the appliance materials to deteriorate (and void the
warranty). Regular cleaning and covering with an Everdure barbecue cover can help can help to reduce this.
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE
DO NOT STORE CHEMICALS OR FLAMMABLE MATERIALS OR SPRAY AEROSOLS NEAR THIS APPLIANCE
DO NOT OPERATE THIS APPLIANCE INDOORS
DO NOT ENCLOSE THIS APPLIANCE. THE MINIMUM CLEARANCE FOR THIS UNIT IS 1500mm ABOVE THE
COOKING SURFACE AND 250mm FROM ANY SIDE
DO NOT LIGHT WITH HOOD DOWN
DO NOT OPERATE THIS APPLIANCE BEFORE READING THE INSTRUCTION BOOKLET
THE EVOLUTION OF PORTABLE OUTDOOR COOKING
3
4
APPLIANCE DETAILS
Gas Type: ULPG N.G
Burner Pressure: 2.75 kPa 1.0 kPa
Injector Diameter: Ø1.00 mm Ø1.60 mm
Heat Input: 12 MJ/ hr 12 MJ/ hr
Note: The size of the injector diameter is stamped on one of the hexagon faces (e.g. ‘165’ for Ø1.65mm injector).
*NOTE: the length increases by 147mm per servery when the serverys are folded out fully. **NOTE: the length increases by
138mm per servery when the serverys are folded out fully.
Air is admitted at the underside of the combustion chamber (a 200mm x 20mm gap between the fat tray and
the chamber through an oval hole 65mm x 45mm in size). Air is also admitted around the burner (3cm²) on
the right hand side & at the viewing/manual ignition hole (radius 8mm) on the left hand side. Exhaust gases are
emitted around the edge of the hot plate (5mm gap) and through a slot in the rear of the hood.
Barbecue only
Barbecue and Trolley
LENGTH (mm) WIDTH (mm) HEIGHT (mm)
502 388
870*
888**
502 983
3
GAS CONNECTIONS
LOCAL AUTHORITY REQUIREMENTS
Check Gas Type and specifications plate on the inside of the left-hand side trolley door. All gas fitting work,
service and repairs can only be performed by an authorized person in accordance with AS5601 / AG601 and
local gas regulations.
NATURAL GAS
E2go barbecues can be converted to use natural gas ONLY with an e2go NG conversion kit. Fit the NG
manifold (with valve), regulator and NG hose following the supplied instructions. Conversion of any barbecue
from ULPG to NG (or vice versa) must be done by a licensed gas fitter/technician. Please contact Everdure for
further information.
FOR ULPG CYLINDER CONNECTION
1. To achieve the optimum performance from your Everdure Barbecue, an approved gas cylinder (POL fitting) of
4kg or 9kg capacity must be used.
2. Do not connect gas to a barbecue that is not secured in an e2go trolley or on a stable raised surface. The
Cylinder must be placed in the centre of the trolley when a trolley is used. The cylinder should be lower than
the barbecue & in a protected place when not using a trolley.
3. Connect the cylinder to the barbecue, via the hose and regulator. Firmly tighten joints, but do not over-
tighten. Take care not to damage the regulator fitting. Check that the gas control knob/valve is in the Off
position before opening the gas cylinder.
NOTE: Only one gas cylinder should be stored in the trolley at any one time.
LEAK TESTING
1. Make sure the gas control knob is Off and turn the cylinder valve On.
2. Check for leaking joints by brushing with solution of half-liquid detergent and half water. If a leak is present,
bubbles will appear (or you may hear a hissing sound). Retightening connections can generally repair a
leaking joint. You must also check the gas hose and connection at the gas cylinder. If a leak cannot be
resolved, do not proceed.
DO NOT USE NAKED FLAME FOR LOCATING GAS LEAKS.
IF A LEAK PERSISTS CALL AN AUTHORISED GAS FITTER.
4
THE EVOLUTION OF PORTABLE OUTDOOR COOKING