Everdure CH20S Instruction Manual

OPERATION, MAINTENANCE

AND SAFETY INSTRUCTIONS

FOR EVERDURE CH20S & CH20R CERAMIC TOWER HEATERS

HEAT LIVE RELAX

HEAT LIVE RELAX

www.everdure.com

IMPORTANT SAFETY INSTRUCTIONS

2

IMPORTANT: Read the safety precautions of this booklet carefully before attempting to

assemble, install, operate or maintain the product described. Protect yourself and
others by observing all safety information. Failure to comply with instructions
could result in personal injury and/or property damage. If you are unsure about
anything regarding your heater or these instructions, please contact Everdure on
1300 766 066 before operating your appliance.

1. Read all instructions carefully before using the heater.

2. Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electrical shock, or injury to persons.

3. Remove the package and ensure that the heater is undamaged. In case of doubt do not use the heater
and contact Everdure Service. Do not let children play with any parts of the package.

4. This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience or knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible for their safety. Children should
be supervised to ensure that they do not play with the appliance.

5. Before you use the heater, check if the voltage marked on the rating label corresponds to the mains in
your home.

6. Extreme caution is necessary when the heater is used by or near children or individuals with decreased
mental and physical capacity and whenever the heater is left operating unattended.

7. Avoid using extension cords as the extension cord may overheat and cause a risk of fire.

8. Do not pull the power cord to disconnect with the power source. Always grasp the plug to pull it out.

9. Do not insert any objects into the heater as it may cause an electric shock or fire or damage to the
heater. Do not block or tamper with the heater in any manner while it is in operation. To prevent a
possible fire, do not block the air inlet or outlet in any manner. Do not place on soft surfaces, like a bed,
where openings may become blocked.

10. Do not leave the heater unattended. Always unplug the heater when not in use.

WARNING: The Main Power Switch and the On/Off switch should not be used as the sole means of

disconnecting power. Always unplug the power cord before servicing or moving the unit.

11. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use the
handle when moving the heater (where available) or hold on the sides if not available (make sure the
unit s turned off). Keep combustible materials such as furniture, pillows, bedding, papers, clothes and
curtains at least 3 feet (0.9m) from the front of the heater and keep them at least 1 foot (0.3m) from the
sides and rear.

12. The heater has hot and arcing or sparking parts inside. It must NOT be used in potentially dangerous
locations such as flammable, explosive, chemical-laden or wet atmospheres. This heater is intended
for general indoor domestic use ONLY.

13. This heater is not intended for use in wet or damp locations. Never locate a heater where it may fall into
a bathtub or other water container.

14. Do not use the heater outdoors.

WARNING:

To avoid danger of electric shock, unplug from outlet when not in use and before cleaning. If the
supply cord is damaged, it must be replaced by a special cord or assembly available from
Everdure Service. In order to avoid overheating, do not cover the heater. The heater must NOT
be located immediately below a socket outlet. Do not use the heater in the immediate
surrounding of a bath, shower or swimming pool.

HEAT LIVE RELAX

Butto

y

HEATER PARTS & FUNCTIONS

FRONT REAR

Note: This model does not
have an ionizer

FUNCTION SETTING

The Heater may be operated by the manual controls located on the Heater (as shown in FIGURE 1) or by your
remote control (shown in FIGURE 5 – CH20R only).

1. Carefully remove the Heater from the plastic bag and the carton.

2. Place the heater on a stable flat surface.

3. Set the main power foot switch to ’OFF’. Plug the cord set into a 240V~A.C. electrical outlet. Turn the main
POWER foot switch to ’ON’ position. A ’beep’ sound and the red light will come on indicating that there is
power to the unit. The Heater is ready to use. The red light will remain lit until the main POWER foot Switch is
turned OFF and the Heater is unplugged from the electrical outlet.

Heat Mode

Timer Setting

n

Note: These buttons are triangular in
shape on your heater but have the
same s

mbols.

Oscillate Button

Power Button

(FIGURE 1)

3

HEAT LIVE RELAX

4. POWER: Turn the Heater ON by pressing the ‘POWER’ button. Upon turning the Heater on, the unit will be in

the default COOL FAN MODE.

5. MODE: Pressing the ’MODE’ button will set the Heater into different MODES: COOL FAN, LOW HEAT,
HIGH HEAT. (As shown in FIGURE 2)

FAN ONLY mode LOW HEAT mode HIGH HEAT mode

(FIGURE 2)

6. OSCILLATION: Pressing the ‘OSC’ button will allow the Heater to oscillate. To stop the oscillation, press the
‘OSC’ button once more. (As shown in FIGURE 3)

(FIGURE 3)

7. TIMER: The timer function allows you to set the length of operation from 0.5 hour to 7.5 hours. Pressing the
‘Timer’ button will increase the length of operation by 0.5 hour each time. (As shown in FIGURE 4)

(FIGURE 4)

8. To turn the Heater OFF, press the ‘POWER’ button. And the unit will work in the COOL FAN MODE for 30sec,
and then turn itself off.

HEAT LIVE RELAX

REMOTE CONTROL OPERATION

NOTE: The remote control is only available on model CH20R

1. lnstall two “AAA” (not included) batteries as shown in the diagram below.

2. The Remote Control Power buttons are labeled in a similar design to those on the heater (shown below) and
work identically to those on the heater.

(FIGURE 5)

SAFETY FEATURES

1. A thermal overload protector is built in to prevent overheating.

2. When an overheat temperature is reached, the heater will automatically shut off. It can only resume operation
when the user resets the unit (see reset instructions below).

3. If the unit is tilted, a safety system automatically will cut off the power, put the unit in a vertical position and it
will go on stand-by mode. Turn the unit on by pressing the POWER button and the unit will start operating
again as per normal.

To reset your heater:

1. Unplug the heater and wait between 5-10 minutes for the unit to cool down.

2. Then, turn on the unit again and operate normally.

HEAT LIVE RELAX

CLEANING & MAINTENANCE

WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING, DO NOT

IMMERSE HEATER IN WATER!

Clean the Air Inlet with the vacuum brush attachment on your Vacuum cleaner.

Clean the body of the heater with a soft damp cloth. Always make sure that the heater is completely

dry before connecting back to the mains supply.

CAUTION: Do not use gasoline, benzene, thinner, harsh cleaners, etc. as they will damage the

heater. NEVER use ALCOHOL OR SOLVENTS.

STORAGE: Store the heater with these instructions in the original packaging, in a cool, dry place.

WEEE WARNING

This product should not be disposed of with household waste. Please recycle where facilities exist and
check with your local authority for recycling advice.

HINTS & TIPS

Where possible your electric heater should be connected to a power outlet that uses a separate 10 amp power
circuit. This will avoid overloading your household fuse.
In the event that your household fuse is overloaded and trips, please note this is normally caused by the use of
excessive power outlets at the same time your heater is operating (for example, a steam iron, kettle, toaster etc.).
Please ensure to check the use of the power circuit and adjust when heater is in use (i.e. turn off the heater when
boiling a kettle). Should you still experience difficulty contact Everdure Service for assistance.

WARRANTY

Please refer to the separate warranty documents accompanying this product. This product has a 2 year
replacement warranty.
To make a claim on the warranty, the heater must be returned to the point of purchase together with the original
receipt. Warranty does not apply to any defect, deterioration, loss, injury or damage caused by, or as a result of
the misuse or abuse of this heater. You may have rights implied by State or Federal law. Nothing in terms of this
warranty is to be taken to exclude any conditions or warranties implied by state or Federal law, which cannot be
excluded or modified.

We highly recommend that you register your Everdure products on www.everdure.com

.

Everdure National Sales & Service Line

1300 766 066

HEAT LIVE RELAX

OTHER PRODUCTS AVAILABLE FROM EVERDURE

Barbecues

Gas Heaters

Cooking Products

HEAT LIVE RELAX

HEAT LIVE RELAX

A division of Shriro Australia Pty Ltd

23-27 Chaplin Drive Lane Cove NSW 2066

1300 766 066

www.everdure.com

IM Ref: CH20SR 10/2010/01

HEAT LIVE RELAX