Everdure CBES61 Installation Manual

INSTALLATION

The adjacent furniture must be able to withstand a minimum temperature rise of 50°C above the ambient temperature of the room it is located in, during periods of use – please check your furniture is acceptable for use with a cooktop.

Please see the above drawing for minimum clearances. Also see the following minimum distances stated below:

600 mm between the hob surface and the underside of any horizontal surface above it.

50 mm clearance around the appliance and between the hob surface and any combustible materials.

UNPACKING THE APPLIANCE

When unpacking the appliance please check that the following items are contained within the packaging:

1 Ceramic cooktop

1 Installation and instruction manual

4 Fixing screws

4 Clamps

1 Sealing strip

DESIGNED TO PERFECTION

INSTALLING THE APPLIANCE CBES61

Cut a hole in the worktop that corresponds with the drawings shown above.

IMPORTANT: You must have a gap of at least 25 mm between the underneath of the appliance and any surface that is below it.

Carefully turn the cooktop upside down and place it on a cushioned mat. Apply the sealing strip provided around the edge of the appliance. The protective covering must be removed from both sides. Do not leave a gap in the sealing agent or overlap the thickness.

IMPORTANT: Do not use a silicon sealant to seal the appliance against the bench top. This will make it difficult to remove the cooktop from the bench top in future, particularly if it needs to be serviced.

(A) Sealing strip

(B) Clamp

Place the clamp (B) over the holes that match the size of the screws. There are one set of screw holes in each corner of the hob. Slightly tighten a screw (C) through the clamp (B) so that the clamp is attached to the hob, but so that you can still adjust the position of it.

Carefully turn the hob back over and then gently lower it into the aperture hole that you have cut out.

On the underneath of the hob, adjust the clamps into a position that is suitable for your worktop. Then fully tighten the screws (C) to secure the hob into position.

DESIGNED TO PERFECTION