Everdure 32B007 Instruction Manual
Safety and Operating Instructions
For Ceramic Tower Heater
Model No. 32B007
HEAT LIVE RELAX
www.everdure.com
HEAT LIVE RELAX
www.everdure.com
6
Safety and Operating Instructions
For Everdure Heater Model No. 32B007
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT
DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO
COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
IMPORTANT SAFETY INFORMATION
1. Read all instructions carefully before using the Heater.
2. Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electrical shock, or injury to persons.
3. Remove the package and ensure that the Heater is undamaged. In case of doubt do not use the
Heater and contact Everdure Service.
4. Do not let children play with any parts of the package.
5. Before you use the Heater, check if the voltage marked on the rating label corresponds to the
mains in your home.
6. Extreme caution is necessary when the Heater is used by or near children or Invalids and whenever
the Heater is left operating unattended.
7. Avoid using extension cords as the extension cord may overheat and cause a risk of fire.
8. Do not pull the power cord to disconnect with the power source. Always grasp the plug to pull it
out.
9. Do not insert any objects into the Heater as it may cause an electric shock or fire or damage to the
Heater. Do not block or tamper with the Heater in any manner while it is in operation. To prevent
a possible fire, do not block the air inlet or outlet in any manner. Do not place on soft surfaces,
like a bed, where openings may become blocked.
10. Do not leave the Heater unattended. Always unplug the Heater when not in use.
WARNING: The Main Power Switch and the On/Off switch should not be used as the sole
means of disconnecting power. Always unplug the power cord before servicing or
moving the unit. The Main Power Switch may be located in the back of some units.
11. This Heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Always
use the handle when moving this Heater. Keep combustible materials such as furniture, pillows,
bedding, papers, clothes and curtains at least 3 feet (0.9m) from the front of the Heater and
keep them at least 1 foot (0.3m) from the sides and rear.
12. The Heater has hot and arcing or sparking parts inside. It must NOT be used in potentially
dangerous locations such as flammable, explosive, chemical-laden or wet atmospheres. This
Heater is intended for general domestic use ONLY.
13. This Heater is not intended for use in wet or damp locations. Never locate a Heater where it may
fall into a bathtub or other water container.
14. Do not use Heater outdoors.
15. This Heater includes an audible alarm to warn that parts of the Heater are getting excessively hot.
If the alarm sounds, immediately turn the Heater off and inspect for any objects on or adjacent to
the Heater that may cause high temperatures.
DO NOT OPERATE THE HEATER WITH THE ALARM SOUNDING
WARNING: To avoid danger of electric shock, unplug from outlet when not in use and before
cleaning. If the supply cord is damaged, it must be replaced by a special cord or
assembly available from Everdure Service. In order to avoid overheating, do not
cover the heater. The heater must NOT be located immediately below a socket
outlet. Do not use the heater in the immediate surrounding of a bath, shower or
swimming pool.
HEAT LIVE RELAX
www.everdure.com
1
A
A
HEATER PARTS & FUNCTIONS
LCD
Handle
Key Button
ir Outlet
ir Inlet
Air Filter
Rear Housing
Front Housing
Main power
Foot Switch
Plug
Base with TipOver Switch
FRONT REAR
FUNCTION SETTING
The Heater may be operated by the manual controls located on the Heater (as shown in FIGURE 1) or
by your remote control (shown in FIGURE 7).
1. Carefully remove the Heater from the plastic bag and the carton.
2. Place the heater on a stable flat surface.
3. Set the main power foot switch to ’OFF’. Plug the cord set into a 240V~A.C. electrical outlet. Turn
the main POWER foot switch to ’ON’ position. A ’beep’ sound and the red light will come on
indicating that there is power to the unit. The Heater is ready to use. The red light will remain lit
until the main POWER foot Switch is turned OFF and the Heater is unplugged from the electrical
outlet.
Timer Setting
Oscillate
Heat Mode
Button
(FIGURE 1)
Temp Increase
Button
Temp Decrease
Button
Power Button
HEAT LIVE RELAX
www.everdure.com
2
Loading...