Everdure 32B001H Instruction Manual

Safety and Operating Instructions
For Ceramic Tower Heater

Model No. 32B001H

HEAT LIVE RELAX

www.everdure.com

HEAT LIVE RELAX

www.everdure.com

6

Safety and Operating Instructions

For Everdure Heater Model No. 32B001H

READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT
DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO
COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!

IMPORTANT SAFETY INFORMATION

1. Read all instructions carefully before using the Heater.

2. Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electrical shock, or injury to persons.

3. Remove the package and ensure that the Heater is undamaged. In case of doubt do not use the
Heater and contact Everdure Service.

4. Do not let children play with any parts of the package.

5. Before you use the Heater, check if the voltage marked on the rating label corresponds to the

mains in your home.

6. Extreme caution is necessary when the Heater is used by or near children or Invalids and whenever

the Heater is left operating unattended.

7. Avoid using extension cords as the extension cord may overheat and cause a risk of fire.

8. Do not pull the power cord to disconnect with the power source. Always grasp the plug to pull it

out.

9. Do not insert any objects into the Heater as it may cause an electric shock or fire or damage to the

Heater. Do not block or tamper with the Heater in any manner while it is in operation. To prevent
a possible fire, do not block the air inlet or outlet in any manner. Do not place on soft surfaces,
like a bed, where openings may become blocked.

10. Do not leave the Heater unattended. Always unplug the Heater when not in use.

WARNING: The Main Power Switch and the On/Off switch should not be used as the sole

means of disconnecting power. Always unplug the power cord before servicing or
moving the unit. The Main Power Switch may be located in the back of some units.

11. This Heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Always

use the handle when moving this Heater. Keep combustible materials such as furniture, pillows,
bedding, papers, clothes and curtains at least 3 feet (0.9m) from the front of the Heater and
keep them at least 1 foot (0.3m) from the sides and rear.

12. The Heater has hot and arcing or sparking parts inside. It must NOT be used in potentially

dangerous locations such as flammable, explosive, chemical-laden or wet atmospheres. This
Heater is intended for general domestic use ONLY.

13. This Heater is not intended for use in wet or damp locations. Never locate a Heater where it may

fall into a bathtub or other water container.

14. Do not use Heater outdoors.

15. This Heater includes an audible alarm to warn that parts of the Heater are getting excessively hot.

If the alarm sounds, immediately turn the Heater off and inspect for any objects on or adjacent to
the Heater that may cause high temperatures.

DO NOT OPERATE THE HEATER WITH THE ALARM SOUNDING

WARNING: To avoid danger of electric shock, unplug from outlet when not in use and before

cleaning. If the supply cord is damaged, it must be replaced by a special cord or
assembly available from Everdure Service. In order to avoid overheating, do not
cover the heater. The heater must NOT be located immediately below a socket
outlet. Do not use the heater in the immediate surrounding of a bath, shower or
swimming pool.

HEAT LIVE RELAX

www.everdure.com

1

HEATER PARTS & FUNCTIONS

FRONT REAR

FUNCTION SETTING

The Heater may be operated by the manual controls located on the Heater (as shown in FIGURE 2) or
by your remote control (shown in FIGURE 8).

1. Carefully remove the Heater from the plastic bag and the carton.

2. Assemble the two detached half pans, fasten the screws on the bottom of the pan (as Shown in

Figure 1). Place the heater on a stable flat surface.

3. Plug the cord set into a 240V~A.C. electrical outlet. Turn the main POWER switch to ’ON’ position

(this is located in the back of the unit). A ’beep’ sound and the red light will come on indicating
that there is power to the unit. The Heater is ready to use. The red light will remain lit until the
main POWER switch is turned OFF and the Heater is unplugged from the electrical outlet.

Note: Main Power
Switch is located in

(FIGURE 1) (FIGURE 2)

the back of the unit.

HEAT LIVE RELAX

www.everdure.com

2