Page 1
Everbright Lighting Ltd. Energy Saving Lamp FCC ID: QJKEBETUS0207
Page 1
EXHIBIT 5
User’s Manual
Page 2
Everbright Lighting Ltd. Energy Saving Lamp FCC ID: QJKEBETUS0207
USER MANUAL OF ENERGY SAVING LAMP
Self-ballasted fluorescent (electronic energy saving lamp) is a new kind of lighting style
that uses trip-phospher tube with electronic ballast. It is characterized of energy saving,
long life and flicker-free, and is widely used for restaurants, hotels, shops, homes lighting.
1. Specifications:
ETU-11W, 15W, 20W, 24W AC 120V 60Hz
ETUS-11W, 15W, 20W, 24W AC 120V 60Hz
2. Working environment temperature: -18~ 40.
3. Precautions:
z Use only on 120 volt, 60 hertz;
Page 2
z Never disassemble of modify the lamp---any changes could void the user’s authority
to operate this device;
z Not for use in totally enclosed fixture;
z Risk of electric shock---do not use where directly exposed to water;
z This device is not intended for use with emergency exit fixtures or emergency
exit lights;
z To prevent burns, do not touch the bulb or cap during operation or immediately after
switching off;
z Handle the plastic enclosure when replacement;
z Not for use with dimmers, electronic timer or photocell devices or occupancy sensor.
z This product could produce interference when used near a TV, radio, wireless
remote control or maritime safety communications equipment or other critical
navigation or communication equipment operating between 0.45-30MHz.
If
interference should occur, move the lamp away from the appliance a distance of three
feet or more. Or plug the lamp or the compliance into a different outlet.
Page 3
Everbright Lighting Ltd. Energy Saving Lamp FCC ID: QJKEBETUS0207
z To prevent risk of fire, never install this device in the following fixtures:
a. Fixture on dimming circuits.
b. Emergency exit lights powered by direct current (DC).
4. COMPLIANCE INFORMATION STATEMENT
Product Name: Energy Saving Lamp
Page 3
Model No.:
ETU-11W, 15W, 20W, 24W; ETUS-11W, 15W, 20W, 24W
This device complies with part 18 of FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that
may cause undesired operation.
******
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
Loading...