EVA KOOL TRAVELMATE Instruction Manual

TRAVELMATE
Instruction Manual
1 |
P a g e
Nexberg Pty Ltd T/a Evakool 16 Enterprise St CALOUNDRA QLD 4551 Tel : 07 5492 7777 Fax : 07 5492 7733
Please read these instructions and the Safety Instructions carefully before
using your refrigerator.
1Safety Instructions Page 2 2Notes on using the product Page 2 3Operation Page 2-3 4Cleaning and Maintenance Page 5 5Troubleshooting Page 5 6Error Codes Page 6 7Warranty Statement Page 7
TRAVELMATE
Instruction Manual
2 |
P a g e
Features:
Reliable cooling system with Danfoss designed compressor manufactured by SECOP
Efficient electronic technology, low energy consumption
Multi-voltage system (DC 12-24 Volt) and (AC 100-120/220-240 Volt)
Digital Battery Protection - protects your vehicle battery effectively
1. Safety Instructions
Warning: Do not touch exposed cables.
Warning: Do not use fridge if you suspect any connections could be wet.
When using the fridge please ensure the circuit being used is fused.
Any installation of DC power sources should be handled by a qualified professional.
Make sure the source voltage is correct. The technical data label shows the voltage data.
Do not place any electrical devices inside the refrigerator as moisture could harm these
devices.
2. Notes on using the product
Your refrigerator requires good ventilation, especially around the vents of the refrigerator;
allow a gap of at least 200mm around the vents and 100mm around the rest of the unit.
Avoid humidity: humidity inside the appliance can form frost and impair cooling. Do not
allow frost to build up.
Never wash the appliance using a hose or running water and never submerge the unit, as
water will damage the electronics.
Avoid placing your refrigerator near a heat source. A cooler environment helps the refrigerator
to work more efficiently and keep the contents cool.
Place the refrigerator on a flat surface and away from any edges. When using the fridge in a
vehicle, please use a fastening device to secure it.
3. Operation
Power
The refrigerator can be powered by a multi-voltage system utilizing either 12/24 Volts or 240 Volts. The electronic module controls the compressor motor and has the added function of a three stage battery protection. When the input voltage drops below the minimum, the compressor will cut out; when the voltage comes back up to the cut-in value, the compressor will restart automatically.
Battery Protection: The Danfoss compressor requires over 10.4 Volts (12 Volt System) or
23.0 Volts (24V System) to operate. If the voltage drops below this the fridge will stop operating.
TRAVELMATE
Instruction Manual
3 |
P a g e
Cable Specification
The DC cables must have a suitable cross-section for their length, according to this table:
*Note: The length is from the battery to the refrigerator.
Display Panel
Using the Fridge
TO TURN ON:
Plug in the DC or AC power cable. The LED display on the control panel
will light up and the interior temperature will be displayed.
NOTE:
IF THE UNIT IS OFF, ONLY AN ORANGE LED WILL BE ILLUMINATED. TO TURN ON YOUR UNIT PLEASE HOLD THE ON/OFF SWITCH DOWN UNTIL THE POWER LED CHANGES TO GREEN AND THE LED DISPLAY IS ILLUMINATED.
Cable Area 12V Max Cable
Length*
24V Max Cable
Length*
[mm2] AWG [m] [ft.] [m] [ft.]
2.5 12 2.5 8 5 16 4 12 4 13 8 26 6 10 6 20 12 39
10 8 10 33 20 66
Loading...
+ 5 hidden pages