Eurotronic Spirit Z-Wave Plus Service Manual

EN

Spirit Z-Wave Plus

Installation & Operation Guide

Made in Germany

www.eurotronic.org

Content

1 Included in delivery 3

2 Adapters 4

3 Product Description 4
Technical specications 4
Contact information 5
Warranty 5

4 Buttons and Displays 6

4.1 Buttons 6

4.2 Boost-Buttons LEDs 7

4.3 LCD 7
Network behavior 8

4.4 Inclusion 9

4.5 Mounting the Spirit Z-Wave Plus 10

4.6 Plus Mechanical Installation 11

4.7 Exclusion 12

4.8 Unmounting the Spirit Z-Wave 13

4.9 Plus Factory Rese 13

5.3 Altering the operating states 14

5.4 Window open detection 15

5.5 Display NodeID 15

6 Z-Wave 16

6.1 Assoziation 17

6.2 Basic 17

6.3 Conguration 18

6.4 Multilevel Sensor 18

6.5 Multilevel Switch 19

6.6 Notication 19

6.7 Protection 19

6.8 Thermostat Mode 19

6.9 Thermostat Setpoint 20

7 Troubleshooting 20

5 Operating the device 14

5.1 Setpoint adjustment 14

5.2 Child protection 14

1. Included in delivery

1. Spirit Z-Wave Plus energy-saving controller

2. Screw

3. Adapters for Danfoss valves

4. 2x AA batteries

* When using the RAV adapter, you need the RAV Pin

for the extension of the valve stem.

RAV Pin*

RAVL

Spirit Z-Wave Plus

energy-saving controller

RAV

RA

2x AA batteries Screw for adapter

– 3–

2. Adapters

WARNING - Remove the connecting pieces of the plastic adapter completely before you use one of the
supplied adapters!

Additional adapters are available for different valve manufacturers. Please consult the EUROtronic
Website for all information about the different adapters at: www.eurotronic.org/Service/FAQ

For the following valves no adapter is required:
Heimeier, Junkers Landy + Gyr, MNG, Honeywell, Braukmann, as these have a thread of M30 x 1.5mm.
The adapters for Danfoss RAV (pin must be plugged on the valve tappet) Danfoss RA and Danfoss RAVL
are included.

For the following valves an adapter is required:
Herz M28 x 1,5 mm, Comap M28 x 1,5 mm, Vaillant 30,5 mm, Oventrop M30 x 1,0 mm, Meges M38 x 1,5 mm,
Ondal M38 x 1,5 mm, Giacomini 22,6 mm, Rossweiner M33 x 2,0 mm, Markaryd M28 x 1,0 mm,, Ista M32 x
1,0 mm, Vama M28 x 1,0 mm, Pettinaroli M28 x 1,5 mm, T+A M28 x 1,5 mm, Gampper 1/2/6.

If you are not sure which valve you are using, please visit: www.eurotronic.org/Produkte/Adapter for fur­ther Information. Here you will find a list of various valves and adapters.

3. Product Description

Spirit Z-Wave Plus is a Z-Wave radio standard compatible energy-saving radiator thermostat.

FLiRS (Frequently Listening Receiver Slave):
Spirit Z-Wave uses FLiRS to provide short latency and short responding times.

Contact information

If you wish to receive further technical Support or information about other EUROtronic products, please
contact us via E-Mail or telephone.

Customer Service:
Eurotronic Technology GmbH
Südweg 1
36396 Steinau-Ulmbach
Germany

Telefon: 0 66 67 / 9 18 47-0
Servicehotline: 0 66 67 / 9 18 47-17
eMail: [e-mail]
Internet: www.eurotronic.org

– 4–

Warning

Do not use rechargeable batteries!
Never recharge batteries, do not short circuit them, do not take them apart - Risk of explosion! Remove dead
batteries from the device immediately. Do not use old and new batteries together. Clean battery and device
contacts before inserting if necessary.
Keep batteries away from children. Avoid contact with skin, eyes and mucous membranes. In case of
contact with battery acid, rinse the affected areas immediately with plenty of water, and seek medical atten­tion immediately. Do not expose batteries to direct sunlight.

Safety Instructions:
Spirit Z-Wave Plus is designed for use in buildings.
Operate Spirit Z-Wave Plus only as described in the user manual.
Spirit Z-Wave Plus should only be put to use in a dry and dust-free place, away from direct sunlight.
Do not keep using the device when there is obvious damage.
Spirit Z-Wave Plus may not be rebuilt, modified or opened.

Warranty

The 24-months warranty period begins at the day of purchase. Please keep the receipt as evidence of pur­chase. During the warranty period, defective radiator thermostats may be sent to your dealer or the address
below. Please ensure sufficient postage is paid. A new or repaired device will then be sent to you free of
charge.
Please note that EUROtronic only grants warranty on the function of the device. EUROtronic will not grant war­ranty for the interaction between the thermostat and the bottom part of the valve. The technical data is only
valid for the use of the following valves: Heimeier, Junkers Landys + Gyr, MNG, Honeywell, Braukmann (mea
sure of thread M30 x 1,5), Oventrop (M30 x 1,5) Danfoss RA, RAV and RAVL. Please refer to the combinations of
the devices on our website (https://www.eurotronic.org/produkte/adapter-information.html) EUROtronic does
not issue a guarantee when using the thermostat with valves which are not mentioned above.

Declaration of Conformity:

Advice on environmental protection:

lection points established for them or to the point of sale. The particulars of this are regulated by the applicable
state laws. The symbol on the product, operation instructions or packaging points to these provisions. You
make an important contribution to the protection of the environment by reusing or recycling old equipment/bat
teries or making use of them in other ways.

-

Eurotronic Technology GmbH hereby declares that this device is compliant with the essential require­ments and other relevant provisions. The declaration of conformity is provided at www.eurotronic.org.

From the date of implementation of European guidelines 2002/96/EC and 2006/66/EC, into national law,
the following applies: Electric and electronic devices and batteries may not be disposed of in household
waste. The consumer is obliged to return electric and electronic devices and batteries to the public col

-

-

– 5–

Technical specications

Device short description Spirit Z-Wave Plus

EAN 4260012711301

Article Number 701003

Supply Voltage 2 x 1,5V LR6/Mignon/AA

Radio Frequency 868,42 MHz

Connection M30 x 1,5mm

4. Buttons and Display

4.1 Buttons

Minus

Boost

Method of operation Type 1

Dimensions (W x H x D): 56 x 68 x 89 mm

Weight 176g (incl. batteries)

Degree of protection IP20

Degree of pollution 2

Plus

Button Interaction Result/Behavior

Press once Decrease room temperature by 0.5°C.

Press and hold Decrease Room temperature by 0.5°C and lower the Room temperature by 0.5°C

every 0.5 seconds or until the lowest temperature is set.

Press once Increase room temperature by 0.5°C.

Press and hold Increase Room temperature by 0.5°C and raise the Room temperature by 0.5°C

every 0.5 seconds or until the highest temperature is set.

Push once • Confirm action which is displayed in the LCD.

• Switch into Boost-Mode(Quick Heat).

• Quit Boost-mode(Quick Heat) if currently active.

Hold for 3 seconds The LCD shows the Z-Wave Node ID.

Hold for 5 seconds The Spirit Z-Wave Plus will react to Exclusion Commands.

Hold while unpowered and
insert batteries

Hold both simultaneously

&

for 3 seconds

Allows factory reset of the Spirit Z-Wave Plus.

Sets or clears the child protection.

– 6–