Eurosun 5B532BT User Manual

Bluetooth SPEAKER MANUAL
MODEL NO.: 5B532BT
*Speacification:
1.Speaker Unit:5.25’’*1
2.Output power :10W*1
3.Speaker impedance: 4Ω*1
4.Frequency Response :100Hz-20KHz
5.FM channel range: 87.5-108.0Mhz
7.SNR.:>=85dB
8.Bluetooth version:2.1
9.Battery capacity:1500mAh
10.charging time:3.5 hours
*Main Feature.
1.Trolley function
2.DC 5V USB charge cable and DC5V port connect speaker with charge
3.Support playback of MP3 (U disk and SD card).
4.FM radio.
5.AUX functions.
6.Karaoke function
7.Bluetooth function
Accessory
USB charging cable & 3.5MM audio cable : 1 pcs User manual: 1 pcs
Connect to Bluetooth device
Turn on the speaker unit and the Bluetooth switch on your mobile or other device and search for the speaker model name "KTS-895 ” Pair the device. Once device is paired Bluetooth will automatically connect wen unit is turned on subsequently.
MODE
Press the MODE button to switch to bluetooth /USB PLAYING /SD CARD PLAYING/FM radio/Aux in
AUX-IN
AUX-IN, Using the audio cable into AUX slot, and press the MODE button to switch to Aux in Model. Long time press the" and turn up the Volume.Or use the knob to adjust the volume.
" and " " buttons to turn down
USB/TF Card
Insert the U flash memory or Micro-TF card into the USB/TF slot. Speaker will read the MP3 format music automatically. Press the ll to Play/Pause, short time press the" "
"button to turn down and turn up the Volume.Or use the knob to adjust the
volume.
" and the " " to Prev. and Next, Long time press the" "and
FM RADIO
Press MODE button to search FM channel automatically. This operation will scan all FM stations and Pre-record them to memory. The scan procedure will take several minutes to complete and should not be interrupted. Once complete , you can short press " or volume.
" button to turn down or turn up Volume.Or use the knob to adjust the
" or " to move forward or backward. Long press " "
Karaoke
Insert the wired microphone into the MIC jack
Light:
Press MODE button 2 seconds to turn on or turn off the light .
Charging
Plug the USB cable into DC5V port and connect to power source. Red LED on panel when charging.
Loading...
+ 1 hidden pages