Joist
Designer Surround
Installation Guide
Exclusively designed to fit these
Element 4 Modore Fireplaces:
Element4 Modore Fireplaces EuropeanHome.com
140
1
18595
August 2018
TABLE OF CONTENTS
Important Information 3
Specications and Dimensions 5
Pre-Installation Planning 6
Installation 7
Maintenance 12
Warranty 13
Element4 Modore Fireplaces EuropeanHome.com
2
IMPORTANT INFORMATION
PRODUCT INSTALLATION RECORD
Installer: Please complete this form. Customer: Please retain this information.
Purchased From
Date of Purchase
Installed By
Date of Installation
Surround Serial Number
Thank you for your purchase of a Designer Surround for Element4!
Since your Designer Surround for Element4 is designed to install, and perform, like ceramic tile, it should be
installed by a professional.
Please refer to your dealer for additional information for professional installers .
Element4 Modore Fireplaces EuropeanHome.com
3
JOIST SURROUND PANELS
Joist Tile Panels
12”
16 13/16”
24” 12”
Joist Metal Panels
52”
63”
84”
16 3/4”
6”
6”
17 1/8”
6”
6”
52” Metal 63” Metal 84” Metal 96” Metal 16 13/16” Tile 16 3/4” Tile 17 1/8” Tile
95 Joist 1 2 - - 1 - 140 Joist - - 1 2 - 1 185 Joist 4 - - 1 - - 1
Each surround contains Metal and Tile Panels according to the chart, above.
Element4 Modore Fireplaces EuropeanHome.com
96”
All surround panels are 7/16” thick
4
SPECIFICATIONS and DIMENSIONS
SPECIFICATIONS and DIMENSIONS
72”
52”
Tile Tile
95 Fireplace
63”
63”
105”
84”
34 13/16”
140 Fireplace
52”
185 Fireplace
52”
96”
118”
96”
96”
52”
Tile
34 3/4”
Tile
35 1/8”
52”
Element4 Modore Fireplaces EuropeanHome.com
5
5
PRE-INSTALLATION PLANNING
BEFORE YOU BEGIN
These surrounds are intended to be installed in the same manner as a french cleat system. (See image below)
Please read these instructions thoroughly before proceeding. There is information which is important for safe
and eective installation.
Please inspect the shipment for completeness and any damage. Contact your retailer if any damage is found.
Do not install the surround with any damaged or substituted parts.
For the best nished results, please consider hiring a professional Carpenter or Contractor to install these
surround panels. Dealer can also be referred.
Before you begin your installation you should have the following tools and supplies:
• Gloves
• Pencil
• Impact Gun
• Drill
• Level
• Tape Measure and Framing Square
Wall
• Lint-free Cloth
• Stud-nder
• #8 Screws (Bugle Head)
Included with the Surround Panels:
• Various sized Z-Clips
Surround
Element4 Modore Fireplaces EuropeanHome.com
6
INSTALLATION
LAYING OUT THE PANELS
The panels of the Designer Surround for Element4 are made to t against the replace opening and each other.
First, hold a metal panel up to the lower edge of the replace and mark the wall with a light pencil line along
the lower edge of the metal panel(s). Then draw a straight line parallel to the right edge of the replace opening at the distance shown below as appropriate for your surround model. The intersection of these two lines
is the starting point for the installation.
25” right of
replace opening
12” down from replace
Starting
Point
12” down from replace
Layout Lines for the Joist 95
(not to scale)
40” right of
replace opening
Starting
Point
Layout Lines for the Joist 140
(not to scale)
27” right of
replace opening
12” down from replace
Element4 Modore Fireplaces EuropeanHome.com
Starting
Point
Layout Lines for the Joist 185
(not to scale)
7
INSTALLATION: WALL LAYOUT
The metal panels and tile panels should be applied to the wall in the order shown below. They will be hung on
the wall using z-clips by the system described on page 6,9,10 and 11.
INSTALLATION
4 (Metal)
10”
8 1/4”
Tile
95 Fireplace
140 Fireplace
3 (Tile)
1 (Metal)
2 (Metal)
Joist 95
4 (Metal)
3 (Tile)
1 (Metal)
2 (Metal)
Joist 140
Tile
7 1/2”
2 (Metal)
Element4 Modore Fireplaces EuropeanHome.com
185 Fireplace
1 (Metal)
6 (Metal)
5 (Tile)
4 (Metal)
3 (Metal)
Joist 185
8
INSTALLATION: WALL LAYOUT + Z-CLIPS
NOTE ABOUT ZCLIPS
Z-clips installed on the wall should have the interlocking side facing up. The slotted side of the clips face
the wall. The length of the clips is to account for contact with the existing wall stud behind the wall sheeting. Mount the Z-clips to studs only.
ZCLIP INSTALLATION PREP REFER TO GRAPHICS ON PAGES 1011
• Use a stud-nder to mark the stud locations above, below, and anking the replace within the relevant
area you will be installing the surround. Screw into these locations for structural integrity. Note, you can
drill into the replace cabinet using 3/4” self tapping screws.
• The included z-clips should exceed 16” slightly. Holes are predrilled to 16” to line up with the rule of 16”
on center. There should be center drilled holes as well.
• Before sinking the second screw, make sure you level the clip o along the guideline.
Ideal Stud Framing Example
Element4 Modore Fireplaces EuropeanHome.com
9
INSTALLATION: WALL LAYOUT
INSTALLATION
Using the starting point and the edges of the replace, mark lines on the wall using the measurements
appropriate to your model, below.
Red lines Represent guidelines for Z-clip; draw these in as guides for mounting.
2 5/16”
2 5/16”
2 3/16”
2 3/16”
2 3/16”
2 3/16”
24”
Layout Lines for the Joist 95
(not to scale)
24”
6”
2 5/16”
12”
6”
6”
6”
2 5/16”
24”
6”
6”
Layout Lines for the Joist 140
(not to scale)
2 5/16”
24”
2 3/16”
2 3/16”
Layout Lines for the joist 185
(not to scale)
Element4 Modore Fireplaces EuropeanHome.com
10
12”
6”
2 5/16”
6”
6”
INSTALLATION
The areas in gray, below, show where the Z-clips is to be applied to the wall.
2 5/16”
2 5/16”
2 3/16”
2 3/16”
24”
24”
Align Z-Clips to the Red Lines
Layout Lines for the Joist 95
(not to scale)
6”
2 5/16”
12”
6”
6”
6”
2 5/16”
24”
2 3/16”
2 3/16”
2 5/16”
2 3/16”
2 3/16”
6”
6”
Align Z-Clips to the Red Lines
Layout Lines for the Joist 140
(not to scale)
6”
2 5/16”
24”
12”
6”
6”
Align Z-Clips to the Red Lines
Element4 Modore Fireplaces EuropeanHome.com
Layout Lines for the joist 185
(not to scale)
11
MAINTENANCE
SURROUND MAINTENANCE
Weekly Cleaning
Both the metal and tile panels should be wiped with a lint free cloth to remove any dust then wiped with a
damp cloth.
Yearly Cleaning
Both the metal and tile panels should be wiped with a lint free cloth to remove any dust then wiped with a
damp cloth.
Element4 Modore Fireplaces EuropeanHome.com
12
WARRANTY
WARRANTY
European Home Warranty
Designer Surround for Element4 Modore Fireplaces
European Home warrants this product against defects in materials and workmanship for a period of TWO (2)
YEARS from the date of original retail purchase.
If a defect exists, European Home will, at its option, either (1) provide needed components using new or
refurbished replacement parts or (2) exchange the product with one which is new or which has been manufactured from new or serviceable used parts and is at least functionally equivalent to the original product. A
replacement product/part assumes the remaining warranty of the original product or ninety (90) days from
the date of replacement or repair, whichever provides longer coverage for you. When a product or part is
exchanged, any replacement item becomes your property and the replaced item becomes the property of
European Home. All warranty claims must be submitted through the dealer from which you purchased the
product. Check with your dealer in advance for any costs to you when arranging a warranty call. Shipping
and/or delivery charges for parts are not covered by this warranty.
Nothing in the above shall be deemed to imply that this warranty shall apply to work which has been
abused or neglected or shows evidence of changes or modications by others with or without permit, damages caused by the acts of God, building settlement or moving, re or vandalism. In addition, installation of
this product that varies from the requirements stated in the instruction manual will void the warranty.
Element4 Modore Fireplaces EuropeanHome.com
13
13
Element4 Modore Fireplaces EuropeanHome.com
EUROPEAN HOME
a division of Europa Ja, Inc.
30 Log Bridge Road
Building 300 - Suite 303
Middleton, MA 01949
www.europeanhome.com
IGHVFJS 1.0
14
Loading...