Euromaid R60FW User Manual

User Manual

Fixed Rangehood

R60FS, R60FW, R90FS & R90FW

Operation Instructions

CONTENT

Safety Information and Warnings

Installation Instructions

Safety Information and Warnings

● Please ensure this manual is read carefully before installation and use. Keep this
manual in a safe and accessible location should future reference be required.

● The installation work must be undertaken by a qualified and competent fitter.

● The manufacturer disclaims all liability for any damage or injury caused as a

result of not following instructions for installation contained in the following text.

● Young children should be supervised to ensure that they do not play with the
appliance.

● The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervised or instruction concerning
use of the appliance by a responsible person for their safely.

● Your cooker hood is for domestic use only, not suitable for barbecue, fast - food
shops, and other commercial use.

● Any installation work must be carried out by a qualified electrician or competent
person.

● The cooker hood and its filter mesh should be cleaned regularly in order to keep
in good working order.

● Before cleaning, always ensure that you have switched your cooker hood off.

● Do not flambé under the range hood.

● Clean the cooker hood according to the instruction manual, and keep the

cooker hood away from the danger of flames.

● If there is any fault with your cooker hood, please call the customer service
number in the Warranty Card.

● Please keep the room adequately ventilated when your cooker hood and gas
hob are working.

● Do not exhaust the gas from cooker hood through the same heated flue which is
for the gas from gas hob and other kitchen appliances.

● The cooker hood is used on 220/240v, 50Hz. Before installation and usage, read
all the instructions and make sure that the voltage (V) and the frequency (Hz)
indicated on your cooker hood are exactly the same as the voltage (V) and the
frequency (Hz) in your home.

● To ensure that you get the best Warranty experience for your cooker hood,
please provide copies of the Warranty Card and purchase receipt, when
booking warranty work with the Customer Service department.

● The air must not be discharged into a flue that is used for exhausting fumes from
appliances burning gas or other fuels (not applicable to appliances that only
discharge the air back into the room.

● Warning: Failure to install the screws or fixing device in accordance with these
instructions may result in electrical hazards. Accessible parts/ light bulbs may
become hot when used with cooking appliances.

R60FS, R60FW, R90FS & R90FW Fixed Rangehood User Manual Page 1

Installation Instructions

Method one:

1. The cooker hood should be placed at a distance of 65-75cm from the cooking

surface for best effect. The Australian authority requirement is the distance from
the highest part of a gas cooktop is 600mm and electric cooktop is 650mm to the
bottom of the range hood

2. To install onto the wall, drill 4 holes of Ø 8mm at a suitable place according with

the centre distance of hole in the back of the cooker hood.

3. Insert the nut into the holes.

4. Insert the screws (ST4*30) into the nuts and tighten.

5. Put up the cooker hood onto the fixed screws.

6. Then use the attached accessories enclosed to turn the screws into the two holes

of inside the hood, and then fix the screws to tighten the hood onto the wall.

7. Put the one way valve onto the cooker hood.

60cm 90cm

Method two:

1. Drill 4 holes of Ø 6mm at the bottom of the hanging cupboard.

2. Put the one way valve on the cooker hood, then install the cooker hood on the

bottom of the cupboard, tighten the hood with enclosed 4 screws (M4*35).

3. Install the adjusted board on the bottom of the hood in order to keep out the

gap between hood back and cupboard.

Page 2 R60FS, R60FW, R90FS & R90FW Fixed Rangehood User Manual

60cm 90cm

Notice:
There are 2 methods for ventilation, including ' horizontal ventilation' and ' vertical
ventilation'. Please pay attention to the ventilation method when installation.

1. Horizontal ventilation: As pic. A shown, please use the cover to seal the outlet on
the top, then the air can be vented from back.

2. Vertical ventilation: As pic B shown, please use the cover to seal the outlet on the
back, then the air can be vented from top.

R60FS, R60FW, R90FS & R90FW Fixed Rangehood User Manual Page 3

Operation Instructions

1. Outdoor air ventilation: Turn the adjuster to outdoor position (pic A), install the
outlet, turn on the cooker hood, then the air will be vented from the outside
outlet.

2. Indoor air ventilation: Turn the adjuster to indoor position (pic B), install the outlet
cover, turn on the cooker hood, then the air can be vented from the inside
outlet.

When you choose “front re-circulation mode”, the charcoal filter must be installed.

1. Push stop button, and the motor will stop.

2. Push the Low button, the motor runs at low speed.

3. Push the Mid button, the motor runs at mid speed.

4. Push the High button, the motor runs at high speed.

5. Push the light button and the two lights will come on. Push it again and the lights
will turn off.

Page 4 R60FS, R60FW, R90FS & R90FW Fixed Rangehood User Manual

6

Care and Maintenance

1. The rangehood and its filter mesh should be cleaned regularly in order to keep in

good working order. Because the grease filters are made of metal, do not clean
the filters with detergents that will corrode metal products.

2. Clean the filters as below:

Method one:
Put the filter in water (40
for about 2-3 minutes and then clean it with a soft brush. Do not brush too hard,
as it may damage the filter.
Method two:
You can also put the filter into the dishwasher with detergent for cleaning. Set
the temperature at around 60

3. To protect the main body from corrosion over a long period of time, the

rangehood should be cleaned with hot water plus soap or non corrosive
detergent once a week. Do not use abrasive detergent, or it will damage the
body.

4. Keep the motor and other spare parts free from water, as this will cause damage

o

-50o), pour in some grease-loosening detergent, soak it

o

.

to the appliance.

5. To disassemble and assemble the filter, please refer to the below picture.

6. To change the light, press the lamp cup, take out the bulb counter-clockwise.

R60FS, R60FW, R90FS & R90FW Fixed Rangehood User Manual Page 5

Trouble Shooting

Fault Cause Solution

The leaf blocked

Get rid of the
blocking

The capacitor damaged Replace capacitor

Light on, but motor does
not work

The motor jammed bearing
damaged

The internal with of motor off or a
bad smell from the motor

Replace motor

Replace motor

Beside the above mentioned, check the following:

Light does not work, motor
does not work

Light damaged Replace lights

Connect the wires as

Power cord looses

per the electric

diagram
One way valve and the air
ventilation entrance are not

Oil leakage

tightly sealed

Leakage from the connection
of U-shaped section and cover

The leaf damaged and causes
shaking

Shake of the body

The motor is not tightly hanged Lock the motor tightly

Take down the one

way valve and seal

with glue

Take U-shaped

section down and

seal with soap or paint

Replace the leaf

Insufficient suction

The machine inclines

Tel: [phone] Fax: [phone] Customer Care: 1800 444 357

The body is not tightly hanged Fixed the body tightly

The distance between the
body and the gas top too long

Too much ventilation from
open doors or windows

The fixing screw not tight
enough

The hanging screw not tight
enough

Distributed by:

Home Appliances Pty. Ltd.

20 Carlotta Street, Artarmon NSW 2064

Email: [e-mail] Website: www.hapl.com.au

Readjust the distance

Choose a new place

and resemble the

machine

Tighten the hanging

screw and make it

horizontal

Tighten the hanging

screw and make it
horizontal