Euromaid MF90 Installation And Operation Manual

MODEL

MF90

900mm
Built-In Oven
Manual

Installation and Operation

MF90 Installation and Instructions for Use

Using This Manual

This Owner’s Manual contains important information on safety and instructions intended to assist you
in the operation and maintenance of your appliance.
Please take the time to read this Owner’s Manual before using your oven and keep this book for
future reference.

Safety Instructions

Installation of this oven must be performed only by a licensed electrician. The installer is responsible for
connecting the appliance to the mains power supply in observance of the relevant safety recommendations
and local Australian codes.

Electrical safety

If the oven has been damaged in transport, DO NOT connect it.

 This appliance must be connected to the mains power supply only by an approved licensed electrician.
 In the event of a fault or damage to the appliance, do not attempt to operate it.
 Repairs should be performed by a licensed technician only. Improper repair may result in considerable

danger to you and others. If your oven needs repair, contact a Service Centre or your dealer.

 If the supply cord is defective, it must be replaced by a special cord or assembly available

from the manufacturer or an authorised service agent.

 Electrical leads and cables should not be allowed to touch the oven.
 The oven should be connected to the mains power supply by means of an approved circuit breaker or fuse.

Never use multiple plug adapters or extension leads.

 The rating label is located either on the right side of the door or affixed to the bottom of side of the cavity

front frame.

 The power supply of the appliance should be turned off when it is being repaired or cleaned.
 Take care when connecting electrical appliances to sockets near the oven.

WARNINGS

 The appliance should be turned off at the circuit breaker or board before replacing lamps to avoid the

possibility of electric shock.

 During oven operation, the interior surfaces become very hot.

Safety during operation

Caution ,hot surface

 This oven has been designed only for the cooking of household foods.
 During use, the oven interior surfaces become hot enough to cause burns. Do not touch heating elements

or interior surfaces of the oven until they have had time to cool.

 Never store flammable materials in or near the oven.
 The oven surfaces become hot when the appliance is operated at a high temperature for an extended

period of time.

 When cooking, take care when opening the oven door as hot air and steam can escape rapidly.

MF90 Installation and Instructions for Use

Safety during operation (Continued)

 When cooking dishes that contain alcohol, the alcohol may evaporate due to the high temperatures and

the vapour can catch fire if it comes into contact with a hot part of the oven.

 Use of high-pressure water cleaners or steam jet cleaners is not permitted for cleaning.
 Frozen foods such as pizzas should be cooked on the wire grill. If the baking tray is used, it may become

deformed due to the great variation in temperatures.

 DO NOT pour water into the oven bottom when it is hot. This could cause damage to the enamel surface.
 The oven door must be closed during cooking.
 DO NOT line the oven bottom with aluminium foil and do not place any baking trays or tins on it. The

aluminium foil blocks the heat, which may result in damage to the enamel surfaces and cause poor
cooking results.

 Fruit juices will leave stains, which can become indelible on the enamel surfaces of the oven. When cooking

very moist cakes, use the deep pan.

 Does not rest bake ware on the open oven door.
 This appliance is not intended for use by young children or infirm persons without the adequate supervision

of a responsible person ensuring that they are using the appliance safely.

 Only use the temperature probe recommended for this oven.
 If a cooking time is not entered, the oven will shut itself off after the lengths of time indicated below.
 Always place oven racks in desired location while oven is cool. If a rack must be moved while oven is hot,

do not let potholder contact the heating elements. Always use dry potholders. Moist or damp potholders on
hot surfaces may result in burns from steam. Do not let potholder touch hot heating elements. Do not use a
towel or other bulky cloth.

Child safety

 WARNING: Accessible parts may become hot during use. Children should be kept away. Children and pets

should not be left alone or unattended in the area where the appliance is in use. They should never be
allowed to play in its vicinity, whether or not the appliance is in use.

 Secure all loose garments, etc. before beginning. Tie long hair so that it does not hang loose, and do not

wear loose fitting clothing or hanging garments, such as ties, scarves, jewelry, or dangling sleeves.

 When children become old enough to use the appliance, it is the legal responsibility of the parents or legal

guardians to ensure that they are instructed in safe operation of the appliance by qualified persons.

 Do not allow anyone to climb, stand, lean, sit, or hang on any part of an appliance, especially on the door,

warming drawer or storage drawer. This can damage the appliance, and the unit may tip over, potentially
causing severe injury.

 This appliance can be used by children age from 8 years and above and persons with reduced physical,

sensory or mental capabilities or lack of experience and knowledge if they have proper supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.

CAUTION:

Items of interest to children should not be stored in an appliance, in cabinets above an appliance or on the
backsplash. Children climbing on an appliance to reach items could be seriously injured.

MF90 Installation and Instructions for Use

Cleaning Safety
WARNING

Make sure the oven is cool before cleaning. We recommend turning the oven off prior to cleaning
Clean and user maintenance shall not be made by children without supervision Do not clean the appliance
while it is still hot. Some cleaners produce noxious fumes when applied to a hot surface. Wet cloths or sponges
can cause burns from steam.

Oven exterior

 For cleaning both the interior and exterior of the oven, use a cloth and a mild cleaning agent or warm

soapy water.

 Dry with kitchen paper or a dry towel.
 Do not use scourers, caustic cleaners or abrasive products.

Stainless steel oven fronts

 Do not use steel wool, scouring pads or abrasives. They may damage the finish.

 For substain stains we recommend using Steel Power cream cleanser, apply cleanser, leave on for a period

of time even overnight and polish off

 To remove fingerprints and water stain we recommend using Steel Kleen.

Aluminium oven fronts

● Wipe the plate gently with a soft cloth or microfiber cloth and a mild window cleaning detegent.

Oven interior

● Do not use coarse scouring pads or cleaning sponges.

● To avoid damaging the enameled oven surfaces, use commercially available oven cleaners.

● To remove stubborn soil, use a special oven cleaner.

Oven door glass

The oven door is equipped with three sheets of glass placed against each other. The inner & middle sheets can
be removed for cleaning. If removed they need to be placed back in the correct order as they use a reflective
coating has to face inward towards the oven cavity.

WARNING

● Whenever the door is separated from the oven, the clips should be flipped open.

● Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can

scratch the surface, which may resulting in shattering of the glass.

● When the door is mounted, removing some of the parts (the door glass or some other part) from the door
may result in injury.

Attention

The glass may break if you use excessive force especially at the edges of the front sheet.

Accessories

Wash all bakeware and accessories after each use and dry with a kitchen towel.To clean easily, soak in warm
soapy water for about 30 minutes.

MF90 Installation and Instructions for Use

Cleaning Safety (Continued)
Catalytic Liners (removable) - enamel surface

The removable cover casing is coated with a dark gray catalytic enamel that can become coated with oil
and fat distributed by circulating air during convection heating. These deposits will burn off at oven
temperatures of 200 °C and higher, for example, when baking or roasting.
Higher temperatures will result in faster burning.The oven and accessories should be cleaned after each use.
Otherwise further baking and roasting will cause the deposits to bake on even harder and cleaning may
become difficult and in extreme cases impossible.
Remove all accessories from the oven.

● Set the oven to conventional function.

● Set the heat to 250 °C.

● Run the oven for approximately 1 hour. The length of time will depend on the degree of soiling.

It is a good idea to set the finish time for the process using the end time setting, in case you forget to switch the
oven off at the end.

Cleaning Catalytic Liners by hand

Make sure the oven is cool before cleaning.
The catalytic liners can be cleaned using a solution of hot water and washing-up liquid applied with a soft
nylon brush. Allow to dry in drainer or out in the sun. Due to the surface not being smooth do not attempt to dry
liners with a cloth as material fibres may remain on the surface of the liner.
Do not use abrasive cleaning agents, hard brushes, scouring pads or cloths, steel wool, knives or other abrasive
materials. DO NOT use oven sprays on catalytic enamel as the chemicals used in oven sprays will damage
catalytic enamel and render it ineffective.
If using oven sprays on the interior oven surfaces, the catalytic cover casing must first be removed from the
oven.

Disposal Instructions

Disposing of the packaging material

 The material used to package this appliance is recyclable.
 Dispose of the packaging materials in the appropriate container at your local waste disposal facility

Disposing of old appliances

WARNING: Before disposing of old appliances, make them inoperable so that they cannot be a source of

danger. Removal of doors is also advised.

To do this, disconnect the appliance from the mains supply and remove the mains lead.

To protect the environment, it is important that old appliances are disposed of in the correct manner.

 The appliance must not be disposed of with household rubbish.
 You can obtain information about collection dates and public refuse disposal sites from your local refuse

department or council.

MF90 Installation and Instructions for Use

Close-up view

A. Control Panel
G. Oven Rack
H. Guides for sliding the racks or dripping in and out
F. Dripping Pan or Baking Sheet

How to use your oven

This multi-function oven combines the advantages of traditional convection ovens with those of the more
modern fan assisted models in a single appliance.
It is an extremely versatile appliance that allows you to choose easily and safely between different
cooking modes.

Notice: The first time you use your appliance, we recommend that set the thermostat to the highest setting

and leave the oven on for about half an hour with nothing in it, with the oven door shut. Then open the
oven door and let the room air in. The odor that is often detected during this initial use is due to the
evaporation of substances used to protect the oven during storage and until it is installed.

Notice: DO NOT place the dripping pan provided on the bottom part of the oven cavity for catching

grease or spills whilst using the oven. Bottom rack position should be utilized for this when grilling food or
when using the rotisserie (only available on certain models). Also do not place aluminium foil to catch any
spills either. If either are placed on the enamel base of the oven, damage can occur due to the intense
heat created from the bottom heating element. Always place your cookware (dishes, aluminum foil, etc.
etc.) on the grid provided with the appliance inserted especially along the oven guides.