Euromaid MCG30, MCK30 Installation Instructions
Suits 20 Litre or 23 Litre or 25 Litre or 30 Litre ovens
1
MICROWAVE INSTALLATION KIT
1. Frame IPCS 2. Fixing Bolt 4 PCS 3. Bolts 3 mmX12 mm 8 PCS
4. Metal Piece IPCS 5. Base setting paper I PCS 6. feetmat 2 PCS
7. Bolts 4 mmX10 mm 4PCS
Technical Specifications of the Installation Kit
Cavity dimensions Overall Kit Dimensions
Internal Width 568 mm Width 592 mm
External FRONT HEIGHT 365 mm Height 376 mm
Depth 550 mm Depth 20 mm
Microwave Oven Cabinet
550
100
vent
568
MICROWAVE CAVITY
365
vent
100
Cabinet Measurement Requirements (illustrated above):
1. Cabinet's inner dimension in transverse direction is 568 mm. This is the minimum distance from the left batten to right batten.
Do not alter.
2. Cabinet's inner dimension in lengthways direction is 365 mm. This is the minimum distance from the left batten to right batten.
Do not alter.
3. Cabinet' s depth should be no less than 550 mm.
4. Outside dimension of cabinet should be no less than 596 mm as the frame length is 592mm.
5. Cabinet's board less than 15 mm or 20 mm thick.
550
100
450
2
INSTALLATION STEPS
Metal Sheet
1. Fix the cabinet as per diagram above. Put the base
setting paper (Component 5) on the bottom board of the
cabinet cavity. Keep the paper's front edge and cabinet
outside edge in one line. Then put the base (Component 6)
on the paper and adjust their holes as per the hole position
in the drawing. Then, fix the required bolts.
3. Put the Microwave Oven carefully into
the cabinet, placing the underside of the
Microwave Oven into the base plate now
created.
2. Fix Metal sheet end on the left and right of
Cabnit, another end on the upper and lower of
cabinet. After fixing the metal sheet, then fix
the buckle and let it touch another end of
metal sheet tighly. Please pay attantion that
buckle's bent side shall be installed as to the
drawing while fixing the bunkle. Then press
the buckle and take away metal sheet, tigten
screws.
N.B. Indentation is on
left-hand side
4. Keep the Microwave Oven in a horizontal direction.
Push the metal piece of the frame into the metal
buckle. The frame should now be installed.
Loading...