Euromaid INLEM3, INLRCM3, INLCP92BG User Manual

User Manual

Off Board Flat Canopy

Rangehood

INLCP92BG - HOOD

INLEM3 / INLRCM3 - MOTOR

1…………………………………..………………………………Safety instructions

2…………………………………..………………………………Installation

3…………………………………..………………………………Start using your Rangehood
4…………………………………..………………………………Troubleshooting

5…………………………………..………………………………Maintenance and cleaning

6…………………………………..………………………………Environment protection

SAFETY INSTRUCTIONS

Content

This manual explains the proper installation and use of your Rangehood, please read
itcarefully before using even if you are familiar with the product. The manual should be
keptin a safe place for future reference.
These instructions shall also be available in an alternative format, e.g. on a website or
on request from the user in spec sheet format.

2

Things not to do:

● Do not try to use the Rangehood

without the grease filters or if the filters
are excessively greasy!

●Do not install above a cooker with a

high level grill.

●Do not leave frying pans unattended

during use because overheated fats or
oils might catch fire.

●Never leave naked flames under the

Rangehood.

●If the Rangehood is damaged, do not

attempt to use.

●Do not flambé under the Rangehood.

●CAUTION: Accessible parts may

become hot when used with cooking
appliances.

●The minimum distance between the

supporting surface for the cooking
vessels on the hob and the lowest part
of the Rangehood. (When the
Rangehood is located above a gas
appliance, this distance shall be at
least 75 cm)

●The air must not be discharged into a

flue that is used for exhausting fumes
from appliances burning gas or other
fuels.

Things to always do:

●Important! Always switch off the

electricity supply at the mains during
installation and maintenance such as
light bulb replacement.

●The Rangehood must be installed in

accordance with the installation

instructions and all measurements
followed.

●All installation work must be carried out

by a competent person or qualified
electrician.

●Please dispose of the packing material
carefully. Children are vulnerable to it.

● Pay attention to the sharp edges

inside the Rangehood especially
during installation and cleaning.

●When the Rangehood is located above
a gas appliance, the minimu m
distance between the supporting
surface for the cooking vessels on the
hob and the lowest part of the
Rangehood that distance must be:

Gas cookers: 75 cm
Electric cookers: 65 cm

Coal or oil cookers: 75 cm

●Make sure the ducting has no bends

sharper than 90 degrees as this will
reduce the efficiency of the
Rangehood.

●Warning: Failure to install the screws or

fixing device in accordance with these
instructions may result in electrical
hazards

●Warning: Before obtaining access to

terminals, all supply circuits must be
disconnected.

Things to always do:

●Always put lids on pots and pans when

cooking on a gas cooker.

●When in extraction mode, air in the
room is being removed by the
Rangehood. Please make sure that
proper ventilation measures are being
observed. The Rangehood removes
odours from room but not steam.

3

●Rangehood is for domestic use only.

●If the supply cord is damaged, it must

be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.

●This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible for
their safety.

●Warning: Before obtaining access to

terminals, all supply circuits must be
disconnected.

Things to always do:

●Caution: The appliance and its

accessible parts can become hot

during operation. Be careful to avoid

touching the heating elements.

Children younger than 8 years old

should stay away unless they are
under permanent supervision.

●There shall be adequate ventilation of
the room when the Rangehood is
used at the same time as appliances
burning gas or other fuels.

●There is a fire risk if cleaning is not

carried out in accordance with the
instructions

●Regulations concerning the discharge

of air have to be fulfilled.

●Clean your appliance periodically by

following the method given in the

chapter MAINTENANCE.

●For safety reason, please use only the

same size of fixing or mounting screw
which are recommended in this
instruction manual.

●Regarding the details about the method

and frequency of cleaning, please
refer to maintenance and cleaning
section in the instruction manual.

●Cleaning and user maintenance shall

not be made by children without
supervision.

●When the Rangehood and appliances
supplied with energy other than
electricity are simultaneously in
operation, the negative pressure in the
room must not exceed 4 Pa (4 x 10-5
bar).

●WARNING: Danger of fire: do not store

items on the cooking surfaces.

●A steam cleaner is not to be used.

●NEVER try to extinguish a fire with

water, but switch off the appliance and
then cover flame e.g. with a lid or a
fire blanket.

4

IMPORTANT INFORMATION

Points to consider for installation

1. Before installation, please ensure the area is clean to avoid suction of the

remaining bits of debris and dust.

2. Please ensure that the fan motor is firmly secured to either a flat surface such

as an MDF panel affixed across the ceiling rafters, or fixed to the ceiling rafters

themselves. Ensure the fan motor is level and there is no vibration when in use.

3. The location of the fan unit shall allow access for maintenance and repair.

Permanent fixed means of access is required where the fan unit location is

beyond the extent of normal steps or ladders.

4. After installation, make sure that the main body is level to avoid grease

collection at one end.

5. Please note the dimensions of the fan motor for installation purposes.

6. The fan motor should be secured using the supplied brackets and screws.

5

INSTALLAT ION - ROOF CAVITY MOTOR VERSION

Schematic diagram

1. Connect the Rangehood main body with the external cabinet by control wire, to

achieve power on and off, and also speed switching.

2. The control wire is separated into 3 parts, the first two parts are fixed onto the main
body and external cabinet, while the middle part is extension wire.

3. The Rangehood main body and the external cabinet will exhaust the smoke to
outdoor after installing the expansion pipe.

6

MOUNTING OF THE V-FLAP

If the Rangehood does not have an assembled V-flap 1, you should mount the half-
parts to its body. The images only show an example of how to mount the V-flap, the
outlet may be various according to different models and configuration.
To mount the V-flap 1 you should:

• Mount two half-parts 2 into the body 6

• a pin 3 should be top oriented;

• the axis 4 should be inserted in the holes 5 on body;

• repeat all the operations for the 2nd half-part

INSTALLAT ION

If you have an outlet to the outside, your Rangehood can be connected as below
picture by means of an extraction duct (enamel, aluminium, flexible pipe or non­flammable material with an interior diameter of 220mm)

1. Before installation, turn the unit off and unplug it from the outlet.

7

2. The Rangehood should be placed at a distance of 65~75cm above the cooking

surface for best effect.

3. Install the hook on a suitable place once the installation height is fixed, and keep it

in line. The fixed position of the inside chimney bracket is the place of chimney.
See pic 2.

4. 1) Equip the outlet connecting cover onto the cabinet top, and screw 6 pcs 4*8mm
screws to fix it.

2) Install the outlet seal ring and outlet, and fix them with 8 pcs 4*14mm screws,
see pic 3. Then hang the hood on the hook. See pic 4.

8