EURO E150WSCS, E360WSCS, E430WSCS User Manual
Wine Cooler
E150WSCS
E360WSCS
E430WSCS
EURO APPLIANCES BY EUROSTYLE GROUP
Warning
The information in this document is subject to modification without any prior notice.
Euro Appliances offers no guarantee for our wine cooler if it is being used for
any purpose other than that for which it was specially designed. Euro
Appliances cannot be held responsible for any error in this manual. Euro
Appliances is not responsible or liable for any spoilage or damage to wines or
any other contents incidental or consequential to possible defects of the wine
cooler. Warranty applies to the wine cooler only and not to the contents of the
wine cooler.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure they do not play with the appliance.
Allow 24 hours before switching on the wine cooler. During this time we
recommend that you leave the door open to clear any residual odours.
Before loading & plugging in the wine cooler, we recommend the location you
should have selected for your wine cooler should:
- Be unencumbered and well ventilated;
- Be well away from any heat source and direct sunlight;
- Not be too damp (laundry, pantry, bathroom, garage and basement etc.);
- Have a flat floor and place on a dry level surface;
- Have a standard and reliable electricity supply(standard socket to country
standards, linked to the ground),it is not recommended to use a multi-socket or
extension lead;
- Have a surge protector fitted to the electrical outlet
- Away from microwave. Certain microwave ovens do not have wave interference
shield. When place within 1 meter vicinity of the wine cooler, they may affect the
operation of the wine cooler.
The wine cooler should be placed where the ambient temperature is between 5
ºC to 43 ºC. If the ambient temperature is above or below this range, the
performance of the unit may be affected. Placing your unit in extreme cold or
hot conditions may cause interior temperatures to fluctuate; the idea range of
temperature may not be reached. (See Climate Class at the end of this manual).
*Grounding Instructions
The wine cooler must be grounded in case of an electrical short circuit.
Grounding reduces the risk of electrical shock. The wine cooler is equipped with
a power cord having a grounding wire and plug. The wine cooler plug must be
plugged into properly installed and grounded electrical outlet. In locations where
there is frequent lightening, it is advisable to use surge protectors.
Improper use of the grounding plug can result in the risk of electric shock.
Consult a qualified electrician or service person if the grounding instructions are
not completely understood. If the supplied power cord is damaged, it must be
replaced by a qualified person in order to avoid electrical hazard.
*Installing your wine cooler
Unpack and remove all of the protection and adhesive strips from the packaging
around and inside the wine cooler.
Important: Before connecting the unit to a
power source, please let it stand upright for approximately 24 hours. This will
reduce the possibility of a malfunction in the cooling system from handling
during transportation.
The wine cooler must be positioned that the plug is accessible. Release the
power cord and move your wine cooler to its finally location. The wine cooler
should be installed in a suitable place where the compressor will not be subject
to physical contact.
Note: For freestanding installation, it requires 30mm gap between both sides
for the wine cooler as well as the rear, which allows the proper air circulation to
cool the compressor and condenser. Even for built-in installation, it requires
10mm space on each side and at the top. The air vent at the front must never
to covered or blocked in any way.
*Levelling your wine cooler
Wine cooler must be levelled before loading your wines. Your wine cooler is
equipped with 4 adjustable feet to facilitate easy levelling. Euro Appliances
recommends that you tighten the back feet to the maximum and adjust the
front feet to create a level.
*Products & Specifications
1) E150WSCS
2) E360WSCS
Type
Dual Temperature Zone
Item Number
E150WSCS
Bottle Capacity
48 Bottles
Dimension (W*D*H)
595*595*798mm
Weight
48KG
Refrigerant
R600a/45g
Cooling System
Compressor Cooling
Ambient Temp
60-90 ºC
Temperature Range
Upper: 5-10 ºC/ Lower: 10-18 ºC
Rated Voltage
220 - 240V
Rated Frequency
50HZ
Input Power
160W
Type
Dual Temperature Zone
Item Number
E360WSCS
Bottle Capacity
110 Bottles
Dimension (W*D*H)
595*680*1408mm
Weight
90KG
Refrigerant
R600a/60g
Cooling System
Compressor Cooling
Ambient Temp
60-90 ºC
Temperature Range
Upper: 5-10 ºC/ Lower: 10-18 ºC
Rated Voltage
220-240V
Rated Frequency
50HZ
Input Power
220W
3) E430WSCS
*Operating your wine cooler
1) Turning on your wine cooler. Plug in and switch on the wine cooler by
pressing on the power button for a few seconds. When you use the wine
cooler for the first time (or restart the wine cooler after having it power off for
a long time), there will be a few degrees variance between the temperature
you have selected and the one indicated on the LED readout. This is normal
and it is due to the length of the activation time. Once the wine cooler is
running for a few hours everything will stabilize.
Important: If the unit is unplugged, power is lost or turned off, wait 3 or 5
minutes before restarting the unit. The wine cooler might not start if you
attempt to restart before this time delay.
Type
Dual Temperature Zone
Item Number
E430WSCS
Bottle Capacity
168 Bottles
Dimension (W*D*H)
595*680*1871mm
Weight
113KG
Refrigerant
R600a/65g
Cooling System
Compressor Cooling
Ambient Temp
60-90 ºC
Temperature Range
Upper: 5-10 ºC/ Lower: 10-18 ºC
Rated Voltage
220-240V
Rated Frequency
50HZ
Input Power
220W
Loading...