Eurekazone Ripsizer25 Assembly Instructions And User's Manual
EZ RipSizer 25”
SKU: ripsizer25
Assembly Instructions
User's Manual
Copyright © 2011 Eurekazone Inc.
1
Introduction
The EZ RipSizer is the perfect tool for the job site and the workshop. It allows for
ripping material of unlimited length to a width up to 25”. In keeping with the
“Deadwood Concept,” that is the basis for the EZ Smart System, the material is placed
on a sturdy support structure (ex: the EZ Smart Table Kit or sawhorses) and the cut is
made using any saw along with the RipSizer. The flexibility of the RipSizer eliminates
the need for long track saw rails and a table saw, whether in the shop or on the job site,
for the sizing of cumbersome sheet goods.
When not in use the EZ RipSizer is stored easily, either left assembled or disassembled
and placed in a case or box, and is easily transported.
Note: The EZ RipSizer requires the use of a portable circular saw and is compatible
with any style of saw. Be sure to follow all safety precautions and to not perform any
modifications that disrupt any safety mechanisms on the saw. It is advised to wear
hearing and eye protection during all cutting procedures.
For updates to the EZ RipSizer and all other Eurekazone products be sure to visit the
Eurekazone website (www.eurekazone.com) or the Track Saw Forum
(www.tracksawforum.com).
2
Parts and Inventory
PART # PART NAME QTY
1 28” Support Arms 2
2 42” Fence 1
3 36” Smart Rail w/ Edge Anti-Chip (EAC) Inserts 1
4 Rail Support Brackets 2
5 Fence Support Brackets 2
6 Stabilizers (one disassembled to show components) 2
7 48” L-R Self-Adhesive Measuring Tape 1
8 48” R-L Self-Adhesive Measuring Tape 1
- Allen Wrench (Not Pictured) 1
- Assembly Manual (Not Pictured) 1
- Smart Base (Not Pictured) 1
- Anti-Chip (AC-1 and AC-2) Inserts (Not Pictured) 2 each
3
Assembly
Note: Trim EAC (Edge Ant-Chip insert) prior to assembly to ensure proper zeroclearance functioning and to avoid causing damage to the EAC. Instructions for
trimming the EAC can be found in the back of this manual under Appendix 2.
STEP 1: Attaching Rail Support Bracket to the Smart Rail
Turn Smart Rail upside down. Slide Rail Support Bracket into end of rail until it
stops. Tighten screws with Allen wrench. NOTE: Over-tightening of the screws may
cause dimpling of the top surface of the guide rail. However, dimpling of the surface
of the Smart Rail will not affect the function of the Rip Sizer as the saw does not
require the full length of the Smart Rail. Repeat for second Rail Support Bracket.
STEP 2: Installing Fence Support Brackets on Support Arms
Place Fence Support Bracket in outer track of Support Arm. Align edge of block on
the Fence Support Bracket with the end of the Support Arm. Tighten screw on the
side of the Fence Support Bracket. Repeat for second Support Arm assembly.
4
Loading...