Eumitcom WA3001A User Manual

Eumitcom

Eumticom Technlolgy Inc.

Quick Installation Guide

of

WLAN 11Mbps Access P oint

WA3001A

Federal Communications Commission Statement

This device complies with FCC Rules Part 15. Operation is subject to the following
two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may
cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy. If this equipment is not installed and used in accordance with the
manufacturer's instructions, it may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by during
the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:

! Reorient or relocate the receiving antenna.
! Increase the separation between the equipment and receiver.
! Connect the equipment to an outlet on a circuit different from that

to which the receiver is connected.

! Consult the dealer or an experienced radio/TV technician for help.

The use of shielded cables for connection of the monitor to the graphics card is
required to assure compliance with FCC regulations. Changes or modifications to
this unit not expressly approved by the party responsible for compliance could void
the user's authority to operate this equipment.

FCC Radiation Exposure Statement
This equipment compli es with FCC radiatio n ex pos ure li mi ts set fo rt h for an uncontrolled environment.
This equipment should be inst alled and operated with minimum distance 20cm between the radiator and
your body.

Manufacturer's Disclaimer Statement

The information in this document is subject to change without notice and does not
represent a commitment on the part of the vendor. No warranty or representation, either
expressed or implied, is made with respect to the quality, accuracy or fitness for any
particular purpose of this document. The manufacturer reserves the right to make
changes to the content of this document and/or the products associated with it at any time
without obligation to notify any person or organization of such changes. In no event will

2

the manufacturer be liable for direct, indirect, special, incidental or consequential damages
arising out of the use or inability to use this product or documentation, even if advised of
the possibility of such damages. This document contains materials protected by copyright.
All rights are reserved. No part of this manual may be reproduced or transmitted in any
form, by any means or for any purpose without expressed written consent of its authors.
Product names appearing in this document are mentioned for identification purchases only.
All trademarks, product names or brand names appearing in this document are registered
property of their respective owners.

This device requires a radio license, unless it (including antenna ) is installed totally
inside a building. (User must obtain this license from Industry Canada ).
“To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (EIRP) is not
more than that required for successful communication.”

Printed in Taiwan

3