5 PIECE OUTDOOR PATIO ALUMINUM DINING SET
Before you start, here is
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
some helpful advice:
Hardware:
A
Bolt M6x20mm x4
Component:
2
B
C
D
E
F
Bolt M6x25mm x4
Bolt M6x20mm x8
Flat Washer x8
Allen Wrench M4 x1
Allen Wrench M5 x1
1
Table Top x1
1
2
Leg x2
2
Page 1 of 2
STEP 1:
Please put the Table Top (1) upside down on a carpeted or padded area.
Remove the plastic covers which pre-install in the end of the Table Top (2) by using Allen Wrench (E/F).
Insert 1 piece of Leg (2) into Table Top (1) as shown.
Insert 2 pieces of Bolt (A) from the pre-drilled holes on the bottom of the Table Top (1) into each side on the bottom of Leg (2).
Insert 2 pieces of Bolt (B) from the pre-drilled holes on the side rail of the Table Top (1) into each end of Leg (2) as shown.
Insert 4 pieces of Bolt (C) with 4 pieces of Flat Washer (D) from the pre-drilled holes on the side of the Table Top (1)
into each end of Leg (2) as shown.
Do not fully tighten Bolts (A&B&C) at this step.
Repeat the same steps for remaining 1 piece of Leg (2).
Use Allen Wrench (E) to tighten all Bolts (A&B) and Allen Wrench (F) to tighten all Bolts (C) clockwise until secure.
2
B
C
A
A
2
1
A
E
Ax4 Bx4 Fx1
STEP 2:
Carefully turn over the assembled table.
Cx8
Dx8
Ex1
1
2
D
D
C
E
B
C
1
F
2
Hardware & Tool required
Assembly is completed. The table is ready to enjoy now!
Page 2 of 2
Loading...