ETS-Lindgren 7604 User Manual

Model 7604
Magnetic Field Pickup Coil
User Manual
ETS-Lindgren L.P. reserves the right to make changes to any product described herein in order to improve function, design, or for any other reason. Nothing contained herein shall constitute ETS-Lindgren L.P. assuming any liability whatsoever arising out of the application or use of any product or circuit described herein. ETS-Lindgren L.P. does not convey any license under its patent rights or the rights of others.
© Copyright 1991–2010 by ETS-Lindgren L.P. All Rights Reserved. No part of this document may be copied by any means without written permission from ETS-Lindgren L.P.
Trademarks used in this document: The ETS-Lindgren logo is a trademark of ETS-Lindgren L.P.
Revision Record | MANUAL 7604 | Part #399063, Rev. E
Revision Description Date
A Initial Release February, 1991
B C D
E Rebrand July, 2010
ii |
Edits/updates Edits/updates Edits/updates
April, 1999
Table of Contents
Notes, Cautions, and Warnings ................................................ v
1.0 Introduction .......................................................................... 7
References .................................................................................................... 7
ETS-Lindgren Product Information Bulletin ................................................... 8
2.0 Maintenance ......................................................................... 9
Annual Calibration ......................................................................................... 9
Service Procedures ....................................................................................... 9
3.0 Specifications ..................................................................... 11
Electrical Specifications ............................................................................... 11
Physical Specifications ................................................................................ 11
4.0 Operation ............................................................................ 13
Graph of Conversion Factors ....................................................................... 14
Table of Conversion Factors ........................................................................ 16
Example ............................................................................................... 16
5.0 Theory of Operation ........................................................... 17
Equation (1) ......................................................................................... 17
Equation (2) ......................................................................................... 17
Equation (3) ......................................................................................... 18
Equation (4) ......................................................................................... 18
Equation (5) ......................................................................................... 18
Appendix A: Warranty ............................................................. 19
Appendix B: Derivation of General Equation ........................ 21
Equation (A1) ....................................................................................... 21
Equation (A2) ....................................................................................... 21
Equation (A3) ....................................................................................... 21
Equation (A4) ....................................................................................... 22
Equation (A5) ....................................................................................... 22
Equation (A6) ....................................................................................... 22
Appendix C: Abbreviations, Symbols, Units ......................... 23
U.S. National Standard and SI Abbreviations and Symbols ................ 23
List of Equivalent SI Magnetic Units and Obsolete Units .................... 24
| iii
Appendix D: Performance, Theory, Measurement ............... 25
iv |
Notes, Cautions, and Warnings
Note: Denotes helpful information intended to
See the ETS-Lindgren Product Information Bulletin for safety, regulatory, and other product marking information.
provide tips for better use of the product.
Caution: Denotes a hazard. Failure to follow instructions could result in minor personal injury and/or property damage. Included text gives proper procedures.
Warning: Denotes a hazard. Failure to follow instructions could result in SEVERE personal injury and/or property damage. Included text gives proper procedures.
| v
This page intentionally left blank.
vi |

1.0 Introduction

A number enclosed in a square bracket corresponds to the numbered item in References.
The ETS-Lindgren Model 7604 Magnetic Field Pickup Coil is designed to measure magnetic emissions to the specification limits in MIL-STD-461 [1] in accordance with MIL-STD-462 [2], Method RE01. The design was originally specified in MIL-STD-461A [3] and is also used in tests for compliance to other specifications [4] and standards. The Model 7604 is normally connected to an EMI meter for the range 20 Hz to over 500 kHz.
The international system of units (SI) is used throughout this manual. See Appendix C on page 23 for the standard abbreviations, symbols, units, and their equivalents.

References

[1] MlL-STD-461 (MIL-STD-461C), Military Standard Electromagnetic
Emission and Susceptibility Requirements for the Control of Electromagnetic Interference, Department of Defense, 4 Aug 1986.
[2] MlL-STD-462, Military Standard Electromagnetic Interference
Characteristics, Measurement of, Department of Defense, 31 Jul 1967.
(with change notices 1 through 6, dated from 1 Aug 68 to 15 Oct 87).
[3] MIL-STD-461A, Military Standard Electromagnetic Interference
Characteristics Requirements for Equipment, Department of Defense, 1 Aug 1968, pp 8 and 17.
[4] Draft Space Station Electromagnetic Emission and Susceptibility
Requirements for Electromagnetic Compatibility, January 8, 1990.
[5] Bronaugh, E.L., and W.S. Lambdin, Electromagnetic Interference Test
Methodology and Procedures, Vol 6 of A Handbook Series on
Electromagnetic Interference and Compatibility, Interference Control Technologies, Inc., Gainesville, VA 22065, 1988, pp 4.22 and 11.2.
Introduction | 7
[6] ANSI/IEEE Std 268-1982, American National Standard Metric Practice.
[7] ANSI/IEEE Std 260-1978, Standard Letter Symbols for Units of
Measurement, (reaffirmed 1985).
ETS-Lindgren Product Information Bulletin
See the ETS-Lindgren Product Information Bulletin included with your shipment for the following:
Warranty information
Safety, regulatory, and other product marking information
Steps to receive your shipment
Steps to return a component for service
ETS-Lindgren calibration service
ETS-Lindgren contact information
8 | Introduction
Loading...
+ 18 hidden pages