E-TOP BR330g User Manual

Router R330g

Quick Setup Guide V1.0

1

Quick Setup Guide V1.0

Part 15.19
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation

Part 15.21
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment. In cases where the manual is provided only in a
form other than paper, such as on a computer disk or over the Internet, the information required by
this section may be included in the manual in that alternative form, provided the user can
reasonably be expected to have the capability to access information in that form.

This equipment complies with FCC radiation exposure limits set forth for this an
uncontrolled environment. The antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons and
must not be co-located or operating in conjunction with any other antenna or
transmitter. End users must follow the specific operating instructions for satisfying
RF exposure compliance.

Table of Contents

TABLE OF CONTENTS ............................................................ 錯誤! 尚未定義書籤。

CHAPTER 1 NAVI R330G’S QUICK SETUP ....................................................... 3

1.1 R

1.2

1.2.1 Time Zone Setting...................................................................... 7

1.2.2 LAN Interface Setup .................................................................. 8

1.2.3 WAN Interface Setup ................................................................. 9

OUTER MODE’S QUICK SETUP INSTRUCTION

THE INTRODUCTION OF ROUTER MODE’S QUICK SETUP

1.2.3.1 WAN Interface Setup–Static IP ..................... 錯誤! 尚未定義書籤。

............................................. 3

................................. 6

1.2.3.2 WAN Interface Setup– DHCP Client ............... 錯誤! 尚未定義書籤。

1.2.3.3 WAN Interface Setup– PPPoE ........................ 錯誤! 尚未定義書籤。

1.2.3.4 WAN Interface Setup– PPTP .......................... 錯誤! 尚未定義書籤。

1.2.4 Wireless Basic Settings..................................... 錯誤! 尚未定義書籤。

1.2.5 Wireless Security Setup .................................... 錯誤! 尚未定義書籤。

1.2.6 Quick Setup Finish ................................................................... 18

2

Quick Setup Guide V1.0

Chapter 1 Navi R330g’s Quick Setup

1.1 Router Mode’s Quick Setup Instruction

Please open a Microsoft Internet Explorer, and enter http://192.168.100.1
(Default Gateway) into browser’s blank, then you will see the configuration page
below:

Please input in the blanks, the factory default values for User Name and Password

are “admin” and “admin” (all in lowercase letters); after inputting, please click on

“OK” to enter the homepage as below:

3

Quick Setup Guide V1.0

Please select the “Router”, and then click on “Apply Change”, so you will go to the

page of “System Rebooting”.

4

Quick Setup Guide V1.0

After 60 seconds, you will go back to the main page of “Operation Mode”, and see

the “Router Home” appearing on the left sub-menu, then please click on

“Quick Setup”, and you will see the main page of “Router Quick Setup” shown

below, which means you have already enabled the operation mode of “Router

Quick Setup”.

5

Quick Setup Guide V1.0

1.2 The Introduction of Router mode’s Quick Setup

After you go to the main page of “Router Quick Setup”, please click on “Next”

right side below, and go to the next page to do each setting step by step:

6

Quick Setup Guide V1.0