Etomer ET-AC40E Instruction Manual

1/3
REFRIGERATOR-FREEZER
UK
MODEL: ET-AC40E
INSTRUCTION MANUAL
² The appliance must be earthed and connected to a suitable 230 volt AC socket. The manufacturer and the seller do
not accept responsibility for any damage due to incorrect electrical installation.
TEST-RUN
² At AC input condition, the voltage range required is 190~240V. ² Do not pull the appliance by the power cord. ² Connect power, set the digital thermostat to -18° and check the indicators. After 30 minutes, open the door and check the
inside surface. If the inside surface is cold, your appliance is working.
LED CONTROL AND OPERATIONS
Operation with AC230V/50Hz
² Connect the “AC230V” socket of the appliance with an AC230V power source by the removable AC plug and cord
packed with the appliance.
² The LED light “230V” will illuminate to indicate the appliance is working. ² In the temperature window the digital temperature set last time will flash for 5 seconds and then automatically change to
the actual temperature inside the cabinet.
² Press the “Up” or “Down” keystrokes/arrows to set the temperature you require. It can be adjusted from -20~10°. ² The set temperature will flash for 5 seconds and then automatically change to show the actual temperature inside the
cabinet.
² To turn off the appliance, remove the plug from socket.
FOODS STORING
² Fresh food should not be stored together with frozen food. ² When the temperature is set below 0°, do not keep glass-bottled drinks such as beer and lemonade as the bottles might
crack
DEFROSTING AND DE-ODORIZING
² When the layer of ice on the inner cabinet sides is over 5mm, defrosting operation should be performed to improve the
refrigerating efficiency.
² Switch off the power, remove all items. After defrosting and removing all water, clean the cabinet with a soft cloth and
switch on the appliance.
² Note: never remove ice with sharp objects. ² Place a piece of charcoal in the appliance to remove any bad odors.
MAINTENANCE AND REGULAR CLEANING
² Always disconnect the power supply before cleaning. Clean the inside of the cabinet whenever necessary using a warm
solution of water and bicarbonate of soda (1 tablespoon to every 2 liters of water) and dry with a soft cloth
² Dirt from the condenser should be cleaned by a qualified technician when necessary.
2/3
NOT A MALFUNCTION
² It is normal to hear gurgling sounds caused by the flow of refrigerant when each cooling cycle ends. ² The surface temperature of the compressor can reach 70-90ºC when running. ² The noise emitted by the cooling fan on the condenser is a normal condition.
MAIN TECHNICAL PARAMETER
Model: ET-AC40E Efficient volume: 38L Max. Input power (Max.): 140W Temperature of freezing: -12°C Temperature of refrigerating: 0~10°C Dimensions (L x D x H): 355 x 595 x 430mm
SAFETY:
A separate earthed 15A socket outlet should be used on 230VAC. In the event of any malfunction of your freezer, please contact the nearest service agent.
CIRCUIT DIAGRAM
IDENTIFICATION
1. LED control panel
2. Carrier handle
3. AC socket
5. Ventilation grill
6. Detachable lid
7. Case
8. Back cover
Loading...
+ 1 hidden pages