ETI Snow Switch PD PRO, Snow Switch GF Pro Quick Reference Installation Manual

AUTOMATIC SNOW/ICE MELTING SYSTEM CONTROL PANEL

PACKING LIST

QTY. PART NO. DESCRIPTION

1 23736 PD Pro

1 23731 Accessory Kit

1 24455 PD Pro Installation Sheet (this document)

1 23735 PD Pro Instruction Manual

The Snow Switch Model PD Pro Automatic Snow and Ice Melting System is permanently connected equipment
and does not have an internal disconnect device. A readily accessible disconnect device, short circuit, and current

NOTE:

protection shall be provided and are not supplied by ETI When power is applied, the system will start.

MODEL PD PRO

To Heater Cable

Heater Load Line / Yellow
Heater Load Neutral / Yellow
Heater Ground (shield)/Green

Power Cable

(provided by customer)

Sensor Wiring #18 AWG jacketed,

Heater Cable

(provided by customer)

Remote Wiring #22 AWG jacketed,

Temperature Sensor

Assembly Wiring

Size for 30 Amp

maximum load

3-conductor

Size to system load

2-conductor

#22 AWG jacketed,

2-conductor

South Bend, Indiana USA | networketi.com

SNOW/ICE CONTROL INSTALLATION GUIDE | PART NO. 24455 REV D

Cable Function Wire Lead Connect To:

INPUT POWER (provided by customer) Line 1

OUTPUT TO HEATER

(provided by customer)

South Bend, Indiana USA | networketi.com

Line 2 / Neutral Ground

Heater Load Line

Heater Load Neutral

Heater ground (Shield)

2

SNOW/ICE CONTROL INSTALLATION GUIDE | PART NO. 24455 REV D

Black

White

Green

Yellow
Yellow
Green