This document and all information contained herein is the sole property of ETERBRIGHT SOLAR CORPORATION and shall not be distributed, reproduced, or
disclosed in whole or in part without the prior written consent of ETERBRIGHT SOLAR CORPORATION.
A3-224
Installation and Safety Manual of CIGS-3000A1&E1 Solar Photovoltaic Module
Contents
1. Introduction
2. Disclaimer of Liability
3. General Information
4. Warnings and Cautions
5. Safety
6. Product Characteristics
7. General Installation
8. Mechanical Installation
9. Electrical Installation
10. Maintenance
11. Shut Down Generation System
12. Revision History
This document and all information contained herein is the sole property of ETERBRIGHT SOLAR CORPORATION and shall not be distributed, reproduced, or
disclosed in whole or in part without the prior written consent of ETERBRIGHT SOLAR CORPORATION.
A3-224
Installation and Safety Manual of CIGS-3000A1&E1 Solar Photovoltaic Module
1. Introduction
This manual provides information regarding the installation and safe handling of the
ETERBRIGHT SOLAR CORPORATION CIGS solar photovoltaic module. ALL of the instructions
in this manual should be read carefully before attempting installation. If there are any
questions, please contact ETERBRIGHT SOLAR CORPORATION Technical Service department
for further explanation.
Please retain this manual for your future reference.
2. Disclaimer of Liability
Because the use of this manual and the conditions or methods of installation, operation,
use and maintenance of photovoltaic product are beyond ETERBRIGHT SOLAR
CORPORATION’s control, ETERBRIGHT SOLAR CORPORATION does not accept responsibility,
and expressly disclaims liability for loss, damage, or expense arising out of, or in any way
connected with, such installation, operation, use or maintenance.
No responsibility is assumed by ETERBRIGHT SOLAR CORPORATION for any infringement of
patents or other rights of third parties, which may result from the use of the PV product.
No license is granted by implication or otherwise under any patent or patent rights.
If you do not adhere to the instructions given in this manual, your rights under the
ETERBRIGHT SOLAR CORPORATION warranty may be forfeited.
ETERBRIGHT SOLAR CORPORATION reserves the right to change the manual, the PV
product, the specifications, or product information sheets without prior notice.
3. General Information
Installation should be performed only by qualified persons. Before installation, installers
should assume the risk of all injuries that might occur during installation, including, but not
limited to, the risk of electric shock. Installers must conform to all safety precautions in the
manual when installing modules.
4. Warnings and Cautions
4.1 Warnings
One individual module may generate DC voltages greater than 30 volts when exposed
to direct sunlight. Contact with a DC voltage of 30V or more is potentially hazardous.
Installers should know in advance that the risk of injury may occur during the
installation, including electric shock.
All PV modules should be installed according to all local and national applicable
standards, codes and regulations.
Rooftop installations should be placed over fire resistant roofs ONLY.
This document and all information contained herein is the sole property of ETERBRIGHT SOLAR CORPORATION and shall not be distributed, reproduced, or
disclosed in whole or in part without the prior written consent of ETERBRIGHT SOLAR CORPORATION.
A3-224
Installation and Safety Manual of CIGS-3000A1&E1 Solar Photovoltaic Module
Artificially concentrated sunlight shall not be directed on the module or panel
4.2 Cautions
Do not attempt to disassemble the modules, and do not remove any attached
nameplates or components from the modules.
Do not apply paint or adhesive to module top surface.
Do not use mirrors or other magnifiers to artificially concentrate sunlight on the
modules.
5. Safety
5.1 Handling Safety
Wear non-slip gloves to prevent the modules from falling while handling the modules.
Keep children/pets away in the process of handling and installing the modules.
Do not stand or step on the module.
To avoid glass breakage, do not place any heavy objects on the module.
Do not drop the module heavily.
5.2 Installation Safety
DO NOT DISCONNECT UNDER LOAD.
COMPLETELY cover the module with an opaque material during installation to prevent
electricity from being generated.
Use ONLY insulated tools and insulated gloves that meet the electrical installation
standards.
Abide by the safety regulations for all other components used in the system, including
wiring and cables, connectors, charging regulators, inverters, storage batteries and
rechargeable batteries, etc.
Do not wear metallic rings, watchbands, ear, nose, lip rings or other metallic objects
while installing or maintaining photovoltaic systems.
The parts of installation CANNOT cover the drainage holes.
6. Product Characteristics
The power rating of ETERBRIGHT SOLAR CORPORATION CIGS solar photovoltaic module are
measured under standard test conditions (Irradiance 1000W/m2, module temperature of
25℃(77℉), AM 1.5G ), so that the power output of module will vary under actual
operating conditions.
The amount of DC power generated by the solar photovoltaic module is proportional to the
radiation intensity, but the voltage will vary depending on the temperature.
This document and all information contained herein is the sole property of ETERBRIGHT SOLAR CORPORATION and shall not be distributed, reproduced, or
disclosed in whole or in part without the prior written consent of ETERBRIGHT SOLAR CORPORATION.
A3-224
Installation and Safety Manual of CIGS-3000A1&E1 Solar Photovoltaic Module
This document and all information contained herein is the sole property of ETERBRIGHT SOLAR CORPORATION and shall not be distributed, reproduced, or
disclosed in whole or in part without the prior written consent of ETERBRIGHT SOLAR CORPORATION.
A3-224
Installation and Safety Manual of CIGS-3000A1&E1 Solar Photovoltaic Module
Remark*1 STC: Irradiance 1000W/m2, Module Temperature 25, Air Mass1.5
The electrical characteristics are within ±10% of the indicated values of Isc and Voc
under STC. Pmax Tolerance (UL) before UL 1703 Light Soaking Tolerance is +3/-3%; after
Light Soaking (UL 1703) Tolerance is +5/-3%.
Under normal conditions, the current and voltage generated by
This document and all information contained herein is the sole property of ETERBRIGHT SOLAR CORPORATION and shall not be distributed, reproduced, or
disclosed in whole or in part without the prior written consent of ETERBRIGHT SOLAR CORPORATION.
A3-224
the solar photovoltaic
Loading...
+ 13 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.