ETEKCITY CD-2800 User Manual
Name
Ultrasonic Cleaner
Power Supply
AC 110-120V
60HZ
Item No.
CD-2800
Input Power
35W
DIM.
20x12.5x14cm
Timer Setting
3 minutes
Tank Size
600ml
WT
780 g
CD-2800 Ultrasonic Cleaner
User’s Manual
1.0 Introduction
Don't have time to take your jewelry to be serviced every time you want
to restore its original luster? Look no further! The Sonic Wave CD-2800
Ultrasonic Cleaner is a powerful cleaning machine that will gently clean
your valuables in minutes. All you need to achieve professional
cleaning results is 1 pint (16oz) of ordinary tap water. Simply fill the
stainless steel cleaning chamber with water and the 42,000 cycle
ultrasonic energy wave feature will sweep away dirt, dust, and grime,
leaving your precious items looking like new. The CD-2800 is a trusted
cleaning method for professional jewelers, opticians, collectors, dental
labs, dentists, and artists.
Please read all instructions and warnings before operating this
machine.
1.1 Package Contents
1 ultrasonic cleaner machine
1 plastic arc for cleaning watch bands
1.2 Features
Tank size: 1 pint capacity (16 fluid oz, 600 ml)
42,000 cycle energy wave
3 minute auto shut off
Power Supply: 100-120 V, 60 Hz, 35 W
1.3 Safety Information
1. Only use machine for its intended uses as described by this
manual.
2. Never leave the machine unattended while it is plugged in.
3. Always unplug machine immediately after using.
4. Close supervision required when used in close vicinity to children.
5. Do not use the product in or near water.
6. Do not place or store the machine in or near a sink or tub where it
might be in danger of falling into the water.
7. Do not fully submerge the machine in water while trying to clean it.
Clean with damp, not dripping wet cloth, and dry with a soft towel.
8. Do not use attachments not recommended by the manufacturer.
9. Do not operate this machine if its cord or plug are damaged, if it is
not working properly, if it has been dropped or damaged, or if it has
fallen into water. Return the product to a service center for
examination and repair if any of the previous situations occurred.
10. Do not let the machine run while sleeping or operate it while
drowsy.
11. Do not drop or insert any object into any opening or hose.
12. Keep the cord away from heated surfaces.
13. This appliance has a polarized plug (one blade is wider than the
other). For your safety the plug will only fit into the outlet one way.
If the plug does not fit in the outlet reverse the plug. If it still does
not fit contact a qualified electrician. Do not attempt to alter this
plug or outlet to get it to fit.
14. When the product is subjected to electromagnetic interference like
fast transients or surge voltage you may not be able to turn the
product on or off. To fix this problem unplug the machine and plug
it in again. After doing this follow the instructions in this manual to
set the machine’s functions.
1.4 Applications
The CD-2800 Ultrasonic Cleaner can be used to clean the following:
jewelry, eyeglasses, sunglasses, keys, gold, diamonds, silverware,
precious coins, metal badges, metal watchbands, waterproof watches,
shaver heads, razor blades, dentures, combs, toothbrushes, valves,
nozzles, machine parts, printer heads, and other valuables! Do not fully
submerge non-waterproof items such as watches. Studs and jewels or
any parts that are not firmly set in the item may fall off during cleaning.
1.5 Operating Instructions
1. If you are cleaning a watch band please see the instructions
under section 1.5 #4 for special instructions before proceeding
with the steps listed below.
2. Make sure the unit is unplugged. Open the cover and put the
article into the tank then fill it with water. There should be
enough water to completely submerge the article, but the water
should be no higher than the fill line on the inside of the
machine. Do not run the unit without water as it may cause the
unit to become damaged. Do not add to much water or let the
water overflow.
3. Close the cover and plug the unit in. The blue power indication
light on the inner cover will turn on.
4. Turn the unit on to start the cleaning process. When the
cleaning is in progress the red working indication light will turn
on. The tank will make a slight buzzing noise when it is
running; do not be alarmed, this is normal.
5. After 3 minutes the cleaning will stop automatically and the red
working indication light will turn off. The interval will be more
effective if longer than 5 minutes. You may also press the off
button to stop the cleaning at any point during the process. If
you wish to run the cycle again simply repeat the above steps
as many times as desired. Repeating the working cycle will
enhance the cleaning effect.
6. When the cleaning is over, unplug the machine, open the
cover, take the cleaned article out, and drain the water.
1.6 Cleaning Methods
1. General Cleaning: All you need is tap water to clean most
items. There should be enough water to completely submerge
the article but the water should be no higher than the fill line on
the inside of the machine.
2. Enhanced Cleaning: Ideal for professional use by professional
jewelers, opticians, collectors, dental labs, dentists, and artists.
Add the Blitz Gem & Jewelry Cleaner Concentrate (not
included in all packages) for a brighter shine. To clean items
that are smudged or smeared add a few drops of detergent to
the water to enhance the cleaning effect.
3. Partial Cleaning: When cleaning large items that do not fit in
the tank you will only be able to partially submerge them/ clean
them.
4. Cleaning Watch Bands: To clean a watchband on a nonwaterproof watch please use the included plastic arc so the
watch head does not get damaged in the process. Slide the
watch band around the plastic arc. Fill the tank with water no
higher than the fill line so that the watch head remains above
the water. Slowly submerge the watch band into the tank
making sure the face remains above water. Add cleaner and
run the cycle following the instructions in section 1.4 above.
1.7 Maintenance
1. Do not leave the item you are cleaning in the tank when
pouring in cleaning solution.
2. Before draining the water unplug the unit.
3. Empty the water from the tank immediately after each use.
4. Wipe the tank with a soft towel to dry. Do not fully submerge
the machine in water to clean it. Wash with a slightly damp
cloth when necessary.
5. Do not clean the unit with organic solvents, diluents, or
abrasives.
6. Store in a cool and dry place.
7. All repairs should be performed by an authorized service
center. Never try to fix the unit yourself.
1.8 Specifications
Loading...