ETC Source Four HID Canopy Kit User Manual

•

™

Source Four HID

Approved
wire nuts

Black plastic
strain relief

J-Box
(Not included)

White wires

Green Ground
wires

Black wires

Ground
screw

Cross-bar-attachment
hardware (1/2”)

Canopy Kit Installation Instructions

Cross bar

Nipple

Jam nut1

Jam nut 2

Canopy

Yoke-stop
hardware (1-1/4”)

Fixture yoke
(Supplied with fixture)

Jam nut 3

Ballast power
cable

Wires from
fixture

Yoke-stop
bracket

Please note the following safety warnings before use:

Turn off power at main fuse or breaker box before installation

• Wiring must meet local and national code

• Use only the hardware supplied to mount the canopy kit and light fixture

Installing the HID Canopy Kit

1.

Attach the J-Box (not supplied with kit) to building ceiling structure.
Run ballast power cable through jam nut 3, yoke stop bracket, yoke, jam nut 2, canopy, jam nut 1, nipple and cross bar.

2.

3.

Run wiring from the Source Four HID fixture (not supplied) through the ballast power cable.

4.

Using the supplied cross-bar-attachment 1/2” screws (2) and washers (2), attach the cross bar to the J-Box.
Thread in nipple to desired length.

5.

6.

Thread jam nut 1 over the nipple and tighten with a wrench.
Insert the grounding screw into pre-drilled hole in the cross bar marked “GND”

7.

8.

Strip insulation from Green, Black and White wires coming from the branch circuit wiring and ballast power cable
Connect branch circuit Black and White wires to ballast Black and White wires, as indicated in the illustration, using

9.

approved wire nuts (not supplied with kit).
Wrap branch circuit Green wire and ballast Green wire around body of GND screw per illustration. Tighten GND screw

10.

with a screwdriver.

11.

Place the black strain relief over ballast power cable, between wire connections and end of nipple. Snap the two halves of
the strain relief together using pliers. Push all wiring and connections into the J-Box.

12.

Place canopy over the nipple, and loosely secure with jam nut 2.
Position the small hole in the canopy so that it aligns with the pre-drilled hole in the cross bar, and secure with 1-1/4” Yoke-

13.

stop hardware.

14.

Tighten canopy jam nut 2.

15.

Place the Source Four HID fixture yoke (not supplied with kit) over the nipple and secure using the yoke-stop bracket and
remaining jam nut 3.

Electronic Theatre Controls

North America 3030 Laura Lane • Middleton, Wisconsin 53562 • USA • Tel: [phone] • Fax: [phone]
Europe 5 Victoria Industrial Estate • Victoria Road • London W3 6UU • Tel: [phone] • Fax: [phone]
Asia Room 605-606 • Tower III • Enterprise Square • 9 Sheung Yuet Road • Kowloon Bay • Hong Kong • Tel: [phone] • Fax: [phone]
World Wide Web: http://www.etcconnect.com • Email: [e-mail]

Specifications subject to change. Source Four HID is protected by US patent numbers 5,446,637; 5,345,371 and 5,775,779. US and International Patents Pending.

Copyright 1999. Revised 11/99.. Part number: 7060M1017