ETC SmartPack CE Terminal Output Panel User Manual

ETC® Setup Guide

SmartPack® with Terminal Output Panel

This Setup Guide contains installation instructions for the SmartPack® with Terminal Output Panel. If you
have any questions, please contact the supplier of your ETC equipment or ETC Technical Services.

ETC Americas: Tel: [phone] (toll-free within USA)

Tel: [phone] (from outside USA)
Email: [e-mail]

ETC Asia: Tel: [phone]

Email: [e-mail]

ETC Europe: Tel: [phone]

Email: [e-mail]

Model Number Voltage Model Number Voltage

SH615TM 230V SN615TM 230V ND

SH1210TM 230V SN1210TM 230V ND

Installation Instructions

Step 1: Terminate conductors.

a: To prepare the load conductors, strip 12-13mm (.49”) of insulation from the end of each wire.

To prepare the input conductors, strip 16-17mm (.65”) of insulation from the end of each wire.

b: Insert the Wago terminal tool (Wago #210-141) into the terminal (input terminal shown), or

you can use a screwdriver if the Wago tool is unavailable.

- OR -

Americas

 3030 Laura Lane, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel: [phone]  [phone]  Fax: [phone]  [phone]

Europe

 Unit 5, Victoria Industrial Estate, Victoria Road, London W3 6UU, UK  Tel: [phone]  Fax: [phone]

Asia

 Room 605-606, Tower III Enterprise Square, 9 Sheung Yuet Road, Kowloon Bay, Kowloon, Hong Kong  Tel: [phone]  Fax: [phone]

Web

: www.etcconnect.com 

Service

: (US) [e-mail]  (UK) [e-mail]  (Asia) [e-mail]
Comments about this document:
Copyright © 2003 Electronic Theatre Controls, Inc.
All Rights Reserved. Product information and specifications subject to change.
Tous droits réservés. Toutes informations et spécifications techniques susceptibles d'être modifiées.
Alle Rechte vorbehalten. Bei Produkt Informationen und Eigenschaften sind Änderungen vorbehalten.
Todos derechos reservados. Información y especificaciones del producto sujetos a cambio.

7020M2210

 Rev A  9/2003

Email

: (US) [e-mail]  (UK) [e-mail]  (Asia) [e-mail]



Commentaires:  Anmerkungen:  Comentarios sobre este documento: [e-mail]

c: To open the terminal, squeeze the handles of the Wago terminal tool until it clicks. If you are

using a screwdriver, align the head with the slot in the top of the terminal and press down
firmly until the terminal opens.

d: Insert the prepared wire into the terminal (input terminal shown):

e: Squeeze and release the handles of the Wago terminal tool, or remove the screwdriver. The

wire should be held securely in the terminal.

f: Repeat for all earth/ground, neutral and hot wires for each load circuit, and for all input

wiring.

Wiring Diagrams

Keep area free of obstructions.

12 Channel Models

6 Channel Models

Neutral

Keep area free of obstructions.

Live

Neutral

Live

40A MAX PER CONNECTION

40A MAX PER CONNECTION