ETA Systems PD11SS User Manual

CONDITIONED POWER DISTRIBUTION
SEQUENTIAL POWER UP/POWER DOWN
15 AMP SERIES

PD11SS

BACK
PANEL

Why You Need Conditioned Power:

With present demands on power
utilities, voltage spikes, power
surges, electrical noise, and power
failures are commonplace. This
“garbage” in the power delivered
can reduce the fidelity of audio
systems, cause premature failure,
or result in extensive damage or
destruction of electronic equipment.

PROTECT YOUR INVESTMENT
with ETA Systems Conditioned
Power units featuring EMI/RFI
filtration, spike/surge/sag/ protection,
voltage regulation, and sequential,
timed power turn-on.

ETA QUALITY
STANDARD FEATURES:

• Incoming power spike and surge
protection and noise filtration on
all 3 legs of incoming power

• One rack space high

• Three year limited warranty

• ETL listed

PD11SS SPECIFICATIONS:

Dimensions 19" L x 10" D x 1 3/4" H
Weight 10 lbs.
Housing Quality

Electrical 120V, 50/60 Hz, single phase
Max. amps 15/unit
Max. watts 1800/unit
Max. front outlet 15 amps
Spike/surge protection Line to neutral, neutral to ground, line to ground
Clamping level 200V peak
Response time 1 nanosecond
Max. surge voltage 6000V
Max. surge current 12,000 amps
Max. spike energy 450 joules total
Noise attenuation Transverse > 35 dB, 1.5 kHz to 200 mHz
Certification ETL listed

Black powder coat chassis,
anodized black aluminum front panel

PD11SS
SPECIAL FEATURES:

• Microprocessor monitored sequential
power distribution system

• Four power up/down steps or stages
of distributed and conditioned power

• Four pre-set power up/down intervals
of 1, 5, 10 or 30 seconds

• Optional manual setting for up to
240 seconds between intervals

• One dual 15 amp U-grounded outlet
per stage

• Full 120 volt, 15 amp, 1800 watt
capacity per unit

• Protected "always on" 15 amp
AC power outlet on the front panel

• Protected "always on" 15 amp
AC power outlets (2) on the rear panel

• 12-gauge, 3-prong, 6-foot power cord,
15-amp capacity

• Total unit circuit breaker located on
the front panel

• Spike and surge protection

• EMI/RFI filtration

• Watchdog circuitry with “Go/ No Go”
L.E.D. display

PD11SS REMOTE OPERATION:

• External three pin screw terminal
block for simple three-wire hook-up
is located on rear panel. Connection
requires user provided ON/OFF switch
and L.E.D. indicator.

™

®

All designs and specificatons are subject to change without notice. 5FP-072-LIT 5/01

SYSTEMS

The Power Just Keeps On Coming

1532 Enterprise Pkwy, Twinsburg, Ohio 44087 USA • 800-321-6699 • Fax: [phone] • www.etasys.com